熱壓氮化硅 的英文怎麼說
中文拼音 [rèyādànhuàguī]
熱壓氮化硅
英文
hot pressed silicon nitride-
Performance for a piezoresistive transducer pressure sensor to thermal and pressure environments can be predicted by finite element method. a simplified 1 / 8 model, considering silicon dioxide and nitride process as well as stack anodic bonding and adhesive bonding processes, was developed. the fem results were found to be comparable to experimental data. case studies suggested that pyrex stack induces certain amount of non - linearity, while it isolates hard epoxy nonlinear effect. flexible epoxy bonding or soft adhesive bonding is preferred to the packaging process. the viscoelasticity and viscoplasticity of bonding material will result in hysteresis and drift errors to sensor output. however, soft adhesive s influence on sensor can be ignored under relative stable environments. more over, detailed design and process information will help to improve modeling application
熱、壓環境下壓阻變換壓力傳感器的性能可以通過有限元方法預測.這里研究了簡化的1 / 8模型，模型考慮了二氧化硅和氮化硅生成過程及堆陽極鍵合和膠粘結合過程.結果發現有限元預測結果和實驗數據具有可比性.範例研究表明，硼硅堆導致產生一定的非線性，但它隔離了硬環氧樹脂的非線性.在包裝過程中最好使用柔性環氧黏合或軟黏膠性結合.黏合材料的黏彈性和黏塑性將會導致傳感器輸出的滯后和漂移誤差.然而，在相對穩定的環境下，軟黏合劑對傳感器的影響可以忽略.此外，詳細的設計和過程信息有助於提高模型的適用性Abstract : the principle of production of low - dew - point nitrogen by pressure swing adsorption ( psa ) was described, and the application in the manufacture of silicone rubber was introduced
文摘:介紹了變壓吸附法制低露點氮氣的基本原理及在熱硫化硅橡膠生膠生產中的應用。Using commercial fea software, computer simulation is carried on the characteristics of the resonator and the pressure sensitivity for several silicon / silicon nitride beam structures
應用有限元分析軟體，對硅梁及氮化硅梁的多種結構，進行了計算機模擬，分析了熱激勵諧振器的特性以及壓力敏感特性。In this thesis adding the pre - process carbon nanotubes into the powder of silicon nitride, with ball milling, drying and sieving, fabricate the silicon nitride ceramics applying the hp sintering method, which in order to improve the toughness of the silicon nitride
本文就是利用碳納米管優良的力學性能，在對其預處理后，將其添加到氮化硅陶瓷粉末中，經球磨、乾燥、過篩后，採用熱壓燒結工藝，制備氮化硅陶瓷，以期改善氮化硅陶瓷的韌性。分享友人