熱壞分析法 的英文怎麼說

中文拼音 [rèhuàifēnxīfǎ]
熱壞分析法 英文
determination of glass transition temperature of plastics-thermomechanical analysis
  • 壞 : Ⅰ形容詞1 （不好的; 惡劣的; 使人不滿意的） bad 2 （表示程度深 多用在表示心理狀態的動詞或形容詞後面...
  • 分 : 分Ⅰ名詞1. （成分） component 2. （職責和權利的限度） what is within one's duty or rights Ⅱ同 「份」Ⅲ動詞[書面語] （料想） judge
  • 析 : Ⅰ動詞1. （分開; 散開） divide; separate 2. （分析） analyse; dissect; resolve Ⅱ名詞（姓氏） a surname
  • 法 : Ⅰ名詞1 （由國家制定或認可的行為規則的總稱） law 2 （方法; 方式） way; method; mode; means 3 （標...
  1. This paper outlines operation, check and repair of the bucket stacker / reclaimer of a coal conveying system used at anqing petrochemical coal - fired power station, describes damage condition of the slewing ring, discusses the causes and details how to replace the damaged slewing ring by synchronously jacking

    摘要介紹了安慶石化熱電廠輸煤系統斗輪堆取料機的使用檢修和回轉大軸承的損壞，分析了損壞原因，重點介紹了「頂升法」更換回轉大軸承的技術。
  2. Presents the investigation of the heat conduction behavior, internal thermal stress field of specimen under thermal shock and microscopic damage and failure of the tungsten based composites by combination of macroscopic and microscopic analyses and integration of material science and mechanics ; describes a microscopic mechanical model based on the microstructure of components with macroscopic stress applied to the microscopic model as that of maximum principal stress at the center, and the fringe of the specimen, and the microscopic stress fields obtained through calculation by the finite element method, and concludes from test results that the maximum principal stress is first generated inside the test coupon, and a failure will be first initiated in the inclusion if the material fails at this time ; the maximum principal stress moves to the edge of the test coupon after the test coupon is heated for a period of time, and the failure will first be initiated in the base if the material fails at this time

    從材料設計的思想出發，採用宏觀與微觀、材料科學與力學相結合的方法，對鎢基復合材料的熱傳導行為、材料在熱沖擊載荷下的內部熱應力場及材料細觀結構的破壞行為進行了詳細的理論研究.根據鎢基復合材料的細觀組織結構建立了材料細觀模型.在宏觀分析的基礎上，分析了材料微結構內部的破壞行為.分別取試件心部與邊緣主應力值最大點的應力狀態，施加在所建立的模型上，用有限元方法計算了模型內部的彈性應力場.結果表明：試件主應力最大值首先產生在試件內部，此時，如果材料發生破壞將先從夾雜中開始；加熱一段時間后試件中的最大主應力值轉移到試件邊緣，此時材料發生破壞將先從基體中開始
  3. By adopting the method of coupling analysis, and a comprehensive consideration on composed pressure and affections of pre - tightened radial force and thermal stress, the internal stress field of anvil was obtained and the damage mechanism was expounded

    採用耦合分析方法，綜合考慮合成壓力、徑向預緊力和熱應力的作用，獲得了頂錘內部的應力場，闡述了破壞機理。
  4. Abstract : a previously proposed approximate quasi - static theoretical method is employed herein to examine the deformation and perforation of a simply - supported circular plate struck by a flat - faced projectile at normal incidence. based on the principle of virtual work, static load - displacement relationships are first obtained and then used to predict the energy - absorbing capacity of the plate subjected to relatively low speed impact. it is shown that good agreement is obtained between the theoretical predictions and the available experimental data, provided that adiabatic shear plugging failure does not occur, but the influence of strain rate sensitivity is taken into account

    文摘:採用準靜態近似理論方法分析簡支圓板在平頭彈丸正撞下的變形和穿透.首先基於虛功原理得到了靜態荷載位移關系，並將其用於預測低速沖擊下圓板的能量吸收能力.當考慮了材料的應變率敏感性，並且不發生絕熱剪切沖塞破壞的前提下，理論預測和實驗結果吻合良好
分享友人
分享到 Line

分享到臉書