熱彈性材料 的英文怎麼說

中文拼音 [rèdànxìngcáiliào]
熱彈性材料 英文
thermoelastic material
  • 彈 : 彈名詞1. （彈子; 小球形的東西） ball; pellet 2. （內裝爆炸物, 具有破壞和殺傷能力的東西） bullet; bomb
  • 性 : Ⅰ名詞1 （性格） nature; character; disposition 2 （性能; 性質） property; quality 3 （性別） sex ...
  • 材 : 名詞1 （木料） timber 2 （泛指可以直接製成成品的東西; 材料） material 3 （供寫作或參考的資料） ma...
  • 料 : 名詞1 （材料; 原料） material; stuff 2 （喂牲口用的穀物） feed; fodder 3 （料器） glassware 4 （...
  • 材料 : 1. （原料） material 2. （資料） data; material 3. （適于做某種事的人才） makings; stuff
  1. Testing of elastomeres ; testing of heat generation and service life during the fatigue test flexometer test ; bases principles

    彈性材料試驗.通過疲勞試驗測試工作壽命和釋熱
  2. Testing of elastomers ; testing of heat generation and service life during the fatigue test flexometer test ; rotary flexometer

    彈性材料試驗.通過疲勞試驗測試工作壽命和釋熱
  3. Testing of elastomers ; testing of heat generation and service life during the fatigue test flexometer test ; compression - flexometer

    彈性材料試驗.通過疲勞試驗測試工作壽命和釋熱
  4. Because the propellant grain is viscoelastic material, the liner and adiabatic layer are also viscoelastic one, the interface debond problem is actually interface crack about elastic - viscoelastic or bi - viscoelastic materials. research about this problem relates to the knowledge of viscoelastic mechanics and interface fracture and combustion. numerical analysis method about interface debond on solid rocket motor is researched in this paper

    由於固體火箭發動機的推進劑藥柱是一種粘彈性材料，襯層和絕熱層也具有粘彈性性質，因此其界面脫粘問題實際上是彈性-粘彈性或雙粘彈性各向同性材料界面裂紋問題，對該問題的研究涉及到粘彈性力學、界面斷裂力學和燃燒學等相關學科。
  5. This paper also researches on thermal elastoplastic analysis model of multilayered graded coating structures on the basis of thermal elastoplastic analysis model of trilayered materials with the focus on the structural character of graded coating. it builds the thermal elastoplastic analysis theory for the graded coating structure that has a single plastic layer or two plastic layers. it gives the analytical formulas of thermal stresses and the thermal elastic - plastic transform temperatures of graded coating that has a single plastic layer or two layers under the thermal loading

    針對梯度塗層的結構特徵，在建立的三層疊層材料熱彈塑性分析模型的基礎上，對多層梯度塗層結構的熱彈塑性分析模型進行了研究，分別建立了含單個塑性層和兩個塑性層的梯度塗層結構的熱彈塑性分析理論，給出了在熱載荷作用下含單個塑性層和兩個塑性層的梯度塗層的熱彈性-塑性臨界溫度和熱應力分析公式，利用有限元分析對理論模型進行了驗證。
  6. Abstract : the rare earth - containing psbr sheet was prepared through vinyl pyridine - sbr ( psbr ) latex reacted with rare earth alkoxide, and the thermal oxidation resistance of rare earth - containing composite elastomer was studied

    文摘:利用稀土醇鹽與psbr橡膠乳液進行反應獲得含稀土復合彈性材料進行抗熱氧化研究。
  7. The result of thermogravimetric analysis ( tg ) shows that its thermo - decomposing temperature rises obviously

    熱重量試驗表明含稀土復合彈性材料的熱分解溫度大幅度上升。
  8. In the paper, active control to rotor vibration with sma is studied : 1 ) the material performance of sma, especially the coupled relation of strain, stress and temperature, is studied in nonlinear coupled thermoelasticity theory and the linear result is modified ; 2 ) the nonlinear dynamic behavior of rotor system with sma bearing is studied in the nonlinear theory and the dynamic stability theory and the deference of the soft / hard nonlinear system is pointed out

    1 ）運用非線性熱彈性耦合理論研究記憶合金材料的力學性能，特別是應力、應變和溫度三者之間的耦合關系，改進了原有的線性結果。 2 ）運用非線性理論和運動穩定性理論研究帶有記憶合金支承的轉子系統在非定常狀態的非線性動力學行為，指出了軟、硬非線性系統的區別。
  9. Large thermoelastic deformation analysis on shallow conical shell of functionally graded materials

    功能梯度材料扁錐殼的熱彈性大變形分析
  10. Experiment study of thermal strain field of functionally gradient material

    梯度功能材料熱彈性應變場分析
  11. With the stress ( strain ) and coupling coefficient being ignored, the coupling heat conduction equation and the coupling moisture diffusion equation would degenerate to fourier heat conduction model and pick diffusion model respectively

    並針對各向同性材料，導出含濕、熱的耦合線性粘彈性本構方程，以及相應的熱傳導方程和耦合濕分擴散方程。
  12. Though the strength of mc nylon gear is low than metal gear, for it has low abrasion and inertia as well as flexible, it may be directly taken the place of metal - especially non iron metal, cast iron and non quenching steel

    盡管mc尼輪的強度明顯比相應的金屬輪低，由於它的低摩擦性和低慣性，以及熱塑性塑料輪輪的彈性彎曲，在很多應用上可以直接替代金屬-尤其是非鐵金屬鑄鐵和未經淬硬處理的鋼材。
  13. For example, the furnaces can be used for quenching of high - speed steel, mould steel, alloy structure steel, bearing steel, elastic alloy etc, sintering and annealing of magnetic materials, and so on

    其它熱處理工藝根據用戶要求實例：高速鋼模具鋼合金結構鋼軸承鋼彈性合金等材料的淬火，以及磁性材料的燒結退火等。
  14. After aging test, its retention rate of mechanical properties is higher than that of the reference group

    發現這種復合彈性材料在熱氧化后力學性能的保持率比參照樣品有明顯的提高。
  15. In this paper, using the elasticity recovery correspondence principle and the nonlinear viscoelastic continuum thermodynamics, we utilize the irreversible thermodynamics to get the nonlinear viscoelastic relations with damage

    本文結合彈性回復對應原理，從非線性粘彈性材料的連續介質熱力學分析入手，通過不可逆熱力學定律來求出含損傷的非線性粘彈性本構關系。
  16. Specification for styrenic thermoplastic elastomer injection molding and extrusion materials

    苯乙烯熱塑性塑料彈性體注塑模塑和擠塑材料的規格
  17. Thermoplastic elastomer classification system

    熱塑性彈性材料的分類體系
  18. Method for assessing solar water heaters - elastomeric materials for absorbers, connecting pipes and fittings

    太陽能熱水器評估法.吸收器連接管和配件用彈性材料
  19. For the polymer showing time - dependent character in many situations, the viscoelasticity should necessarily be taken into account in the general model. further, as the conventional j integral is no longer valid for hydrothermal materials cases, investigations on new energy - type fracture criter ia are specifically needed

    此外，在含濕、熱效應的高聚物材料中，傳統的粘彈性或彈性材料的斷裂判據不再適用，所以，對該問題進行研究也是十分必要的。
  20. Transient thermal bending analysis of thin plates of functionally gradient material by finite element method

    梯度功能材料薄板瞬態熱彈性彎曲有限元分析
分享友人
分享到 Line

分享到臉書