熱應力裂縫 的英文怎麼說

中文拼音 [rèyīnglìlièféng]
熱應力裂縫 英文
thermal stress cracking
  • 應 : 應動詞1 （回答） answer; respond to; echo 2 （滿足要求） comply with; grant 3 （順應; 適應） suit...
  • 力 : Ⅰ名1 （力量; 能力） power; strength; ability; capacity 2 [物理學] （改變物體運動狀態的作用） forc...
  • 裂 : 裂動詞[方言] （東西的兩部分向兩旁分開） open
  • 縫 : 縫名詞1. （接合處） seam 2. （縫隙） crack; crevice; fissure; slit
  • 裂縫 : 1. （裂開的縫兒） rent; rip; hiatus; tear; rift; crevice; crack; fissure 2. [地質學] fracture; rupture
  1. Some other defects in castings are well - defined cracks and hot tears that develop during solidification, under combination of stress concentration from uneven contraction and the metal ' s low strength at near - melting temperatures

    鑄件內部的其它一些缺點是，凝固過程中，在不均勻收縮造成的應力集中和接近熔點溫度下金屬的低強度的綜合作用下，出現的清晰裂縫和熱撕裂。
  2. The failure analysis of the heating jacket indicates that the austenitic stainless steel 316l is susceptible to stress corrosion cracking under the combined action of chloride environment and residual stresses induced by welding

    結果表明：加熱夾套開裂的主要原因是316l奧氏體不銹鋼不耐氯化物腐性，焊縫有一定的缺陷和腐蝕介質存在，屬於一種典型的應力腐蝕失效形式。
  3. 7mpa / km in the center of the zone ( 6 ) in the hot dry rock geothermal energy extraction system, after the system start to operate, the normal stress of crack show the pronounced influence depending on the temperature ' s change in a month, there are a marked drop in temperature nearby the injection well, forming a lower stress area, with the heat extraction, the temperature ' s change even gradually, but the temperature descend quickly nearby the production well, forming a new lower stress area

    （ 6 ）高溫巖體地熱開發中，裂縫面法向應力受溫度變化的顯著影響，在系統開始運行的一個月內，注入井附近區域其溫度降低較快，形成低應力區;隨開采時間的延長，其溫度變化逐漸平緩，而生產井附近區域溫度降低加快，逐漸形成新的低應力區。
  4. The heat transfer and the restriction circumstance are simulated. the temper ature - time curve and the stress - time curve are obtained. because the later joint - filled slots are restrained strongly, in which the thermal stress is great, especially in the corner, in spite of a little temperature rise, some measures should be taken to prevent them from producing cracks

    利用有限元前處理軟體vizicad建立了「 t 」形后澆帶模型，模擬了后澆帶的「熱環境」和「約束環境」 ，計算得到了后澆帶的應力和溫度發展曲線，發現雖然後澆帶的溫升不大，但受到的約束較大，因此產生較大的溫度應力，特別是在其拐角處，應採取措施防止裂縫的出現。
  5. 3, carry out detailed numerical simulation and analysis for heat extraction of deep - seated hdr based on the tengcong prefecture, reach the major variety rule of rock mass stress, temperature, fracture width depending on the heat extraction. ( 1 ) in the hot dry rock geotherraal energy extraction system, transportation of energy and flow of water arise mainly through the fracture, the lower temperature water attain the high temperature from the injection well to production well through conduction convection and take away the thermal from wall rock

    3 、認真地對騰沖高溫巖體地熱開發進行了數值模擬計算和分析，得出了地熱開發過程中巖體應力、溫度以及裂縫寬度隨地熱提取的變化規律等重要結論： （ 1 ）在高溫巖體地熱開發系統中，能量的運移、輸送與水的流動主要通過裂縫面發生，注入的低溫水在流到生產井的過程中，發生傳導、對流、吸收圍巖熱量，達到升溫的目的。
  6. Concentrated on simulative analysis of 3 - d temperature and stress fields of concrete dams, determination of thermodynamic parameters, cracking mechanism, crack prevention, crack control and crack repairs, the mainly work in this dissertation are as follows : 1

    本文圍繞混凝土壩三維溫度場與應力場模擬分析、熱力學參數確定、裂縫成因機理、防裂限裂措施及裂縫補救方法等，作了如下的工作： 1
  7. ( 6 ) the validity of control methods of crack has been verified by using engineering instances. on the basis of the researches mentioned above, some crucial conclusions are acquired as follows : ( 1 ) during construction, the cracks in beams and girders were caused by the drop of temperature and by the difference in the inside and outside temperature. the crack in slab was caused by shrinkage due to the loss of water

    通過上述研究工作得出了一些重要的成果： （ 1 ）在施工階段，大面積現澆樓蓋結構主次梁的裂縫由溫度降幅和內外溫差引起，板的裂縫主要由失水收縮引起； （ 2 ）在施工期，由水化熱引起的應力主要分佈在主次梁中，板中應力較小。
分享友人
分享到 Line

分享到臉書