熱損失 的英文怎麼說

中文拼音 [rèsǔnshī]
熱損失 英文
calorific losses
  • 損 : Ⅰ動詞1 （減少） decrease; lose 2 （損害） harm; damage 3 [方言] （用尖刻的話挖苦人） speak sarcas...
  • 損失 : 1. （失去） lose 2. （失去的東西） loss; wastage
  1. Standard test method for loss on heating of oil and asphaltic compounds

    油及瀝青混合物加熱損失標準試驗方法
  2. Aimed at the high temperature at furnace roof and wall, great lost of body heat radiation, poor leading heating ability and long soaking time, the compound ceramic fiber coating is used to hold temperature of furnace roof and wall, make the heating loss dropped, shorten soaking time, improve heating ability and reduce evergy consumption

    摘要針對環形爐爐頂爐墻表面溫度高、爐體散熱損失大、導致加熱能力低、待溫時間偏長的問題，選用了復合陶瓷纖維保溫塗料，使爐體散熱損失減少，待溫時間縮短，加熱能力提高，且能耗降低。
  3. Determination of loss in weight of montan wax

    褐煤蠟加熱損失量測定方法
  4. Abstract : through analysis on the character and use of geothermal water, expatiate the mechanism of iron removal from geothermal water, adopt the iron removal and manganese removal technology of aeration full oxygen and savageness manganese grit osculate oxidation, and control the intention and time of inverse flush, these make the treated geothermal water reach the standard of iron and manganese chroma, moreover, it won ' t increase bad component or decrease good component it is a perfect iron removal and manganese removal technology that can save installation investment, need low operating cost and reduce the heat losing

    文摘:通過對地熱水的特點及其用途的分析，闡述了地熱水除鐵除錳機理，採用曝氣充氧、天然錳砂接觸氧化的除鐵除錳工藝，並適當控制反沖洗強度和時間，使處理后地熱水含鐵、錳濃度達到標準，且不增加有害成分或減少有益成分.設備投資省、運行成本低，熱損失小，是一種理想的地熱水除鐵工藝
  5. The reheat coil adjusts supply air temperature to offset building heat losses due to transmission.

    再熱盤管調節送風溫度，以補償因傳熱造成的建築熱損失。
  6. This paper introduces that the diffuse heat heating furnace is reduced the consumption of fuel is debased and the preferable effect is got, using the multicrystal mullite fibrous stickup lump to heat preservation in heating furnace wall

    摘要採用多晶莫來石纖維貼面塊對加熱爐爐內壁保溫，減少了爐體的散熱損失，降低了爐子燃耗，取得了較好的效果。
  7. Energy consumption of heating rooms will increase when air exchange rate become large. because the mechanisms of heating methods used currently, such as radiator heating, ceiling heating and warm - air heating, are different from each - other, the indoor thermal environment is not the same when each one of them employed for room heating. for enhancing energy efficiency of heating rooms, indoor thermal comfort and energy saving effects should be investigated when natural ventilation is used to make a good air quality indoors

    房間換氣次數的增加勢必導致供暖房間能耗加大，頂棚輻射、散熱器和熱風等三種採暖方式由於供暖機理不同，形成的室內熱環境特徵不同，通風換氣時產生的通風熱損失也有所區別，為了提高大換氣量房間的供暖節能效果，必須對不同供暖方式在大換氣量情況下的熱舒適性與節能效應進行研究。
  8. In the third chapter of this dissertation, based on the physical and chemical properties of hydrogen and the combustion characteristics of hydrogen, the quasi - dimension combustion calculation model of hydrogen ? fueled engine is set up through analyzing the characteristics of turbulence flame and chemical reaction kinetic of hydrogen ? air mixture. the model includes the dual ? area thermodynamics sub - model, quasi - dimensional turbulent entrainment combustion sub ? model, turbulence flame promulgating sub ? model, hydrogen - air mixture chemical kinetic sub - model and loss of heat transfer sub - model and so on

    本文從氫燃料的物化特性和燃燒特徵著手，通過分析氫空氣混合氣燃燒的湍流火焰結構和燃燒化學反應動力學，基於雙區燃燒模型，建立了包括雙區熱力學、準維湍流卷吸燃燒、湍流火焰傳播速度、氫空氣混合氣燃燒化學反應動力學以及傳熱損失等模塊的燃燒模型，並給出了相應的計算方法。
  9. Electromotor joins with high efficiency selected water pump, scm ( single chip micyoco ) control system commands water pump according to cooling water temperature which substitutes traditional strap - driving mechanism pump and forms tael - level intellectualized control cooling system combining with electromotion control of cooling fan. consequently it realizes that water pump and fan autoregulate with engine working status and assures t hat cooling water temperature keeps in the best range all the time and advances the reliability of engine working and realizes exact control of cooling water temperature in deed

    選用高效率水泵與電機聯接，改由單片機控制系統根據冷卻水溫控制水泵的工作，代替傳統的皮帶帶動的機械水泵，結合冷卻風扇的電動控制形成兩級智能化控制的冷卻系統，從而，實現了水泵和風扇轉速隨發動機工況變化的自動調節，真正實現了冷卻水溫的精確控制，保證了冷卻水溫始終保持在最佳范圍內，大量減少傳熱損失降低油耗，並提高了發動機工作的可靠性。
  10. 3. on boiler retrofit, the calculation of fuel burning, the heat calculation of boiler inside structure and convection section, and the design of structure parameter of feed water heat exchanger are made. the flue gas channels " resistance calculation and the boiler strength verifying are also carried out. replacement of water cooling wall improves heat exchanging and decreases loss of heat radiant

    對鍋爐本體進行了燃料燃燒計算、爐膛結構熱力計算、對流受熱面結構熱力計算、鍋爐給水加熱器結構參數設計、煙道阻力計算及鍋爐元件強度校核等；改進了水冷壁布置使換熱效果更好，減少輻射換熱損失；改進對流段結構，更充分的利用爐膛出口煙氣余熱，提高熱效率；並且進行了煙氣阻力計算、熱效率計算和能量平衡測試，對改進后的稠油燃料和改進前進行了對比，燃燒狀況和熱效率有明顯改善。
  11. It is found that the climatological mean of wind speed and air - sea humidity difference are both large, the variation of wind speed are almost in phase with air - sea humidity difference, yielding much larger or smaller latent heat flux. so the ocean release the most latent heat in its own winter of the two hemispheres when both wind speed and air - sea humidity difference are large

    發現在南北兩信風區，風速和海氣濕度差的變化幾乎是同位相的，平均背景風速和海氣濕度差都較大，他們互相加強彼此對潛熱通量變化的貢獻，所以海洋潛熱損失最大是發生信風南北兩區的各自風速和海氣濕度差都較大的冬季。
  12. Thermal performance of buildings - transmission heat loss coefficient - calculation method

    建築物熱性能.傳熱損失系數.計算方法
  13. Between glass - cover board and endothermic board, honeycomb is placed, which can eliminate heat loss caused by air natural convection and greatly reduce heat loss caused by radiation, and hence a better transfer heat efficiency

    而在透明玻璃蓋板和吸熱板之間放置蜂窩結構，基本上能消除吸收表面和蓋板之間的空氣自然對流熱損失，並可大大降低輻射損失，顯著提高集熱器的熱轉換效率。
  14. In - situ measurements of heat loss through thermal insulation of equipments and pipes - surface temperature method

    設備及管道絕熱層表面熱損失現場測定表面溫度法
  15. Adopt far - infrared heating technology, with low hot loss, high efficiency, high precisely for control temperature, uniform heating. compared with drying cabinet or electric stove ; it can automatical control temperature, easy to operate, drying effect is very satisfied

    採用了遠紅外輻射加熱技術，與一般烘箱及熱處理用的箱式電爐相比較，具有熱損失小、效率高、控溫精度高，加熱均勻：能自動控溫、一時結束、操作方便等優點，可達到十分滿意的烘乾效果。
  16. Study on effect of heat loss on energy measurement result of cw high energy laser

    熱損失對連續波高能激光能量測試結果影響的研究
  17. This paper has analyzed and synthesized the problems of burning heavy viscosity petroleum about injecting steam boilers in liaohe oil field. the heat balance experiments on injecting steam boilers burning heavy viscosity petroleum is made first. the main causes of low thermal efficiency and heat lose of flue gas are the poor effect of atomization and burning with old - fashioned oil nozzles, worse ash gathered on. heat exchange surface and high temperature of flue gas

    本論文在分析綜述了遼河油田注汽鍋爐燃用高粘度稠油時存在的問題的基礎上，首先對燃用稠油的注汽鍋爐進行了正、反熱平衡試驗，分析了注汽爐熱效率偏低、排煙熱損失偏高的主要原因是原噴油嘴改燒高粘度稠油時霧化和燃燒效果差、換熱面積灰嚴重、排煙溫度太高。
  18. Heat pipe air pre - heater is adopted to recover gas heat to heat up cold air for burning, reducing flue gas temperature and increasing heat efficiency of injecting steam boiler

    採用熱管式空氣預熱器，利用排煙熱量加熱冷空氣，降低了煙氣溫度，減少排煙熱損失，提高注汽爐熱效率。
  19. About heat loss, emphasis was mainly put on the part of exit gas, furthermore, a comprehensive summation in reference to possibilities affecting emission gas temperature increment were made and corresponding measures were given

    在鍋爐的各項漏損中，著重分析影響排煙熱損失的諸因素。對影響鍋爐經濟運行的不利因素給出較為有效的預防措施，達到提高鍋爐運行經濟性的目的。
  20. The ideal operational value of waste - gas temperature is provided through combining the boiler ' s practical operation and the research of heat loss due to exhaust gas, which offers important theory and paves a solid way in optimizing boiler operation

    通過對排煙熱損失的研究，並結合鍋爐的實際運行情況，提出了排煙溫度的運行目標值，此目標值的確定對于鍋爐運行優化有著重要的理論基礎。
分享友人
分享到 Line

分享到臉書