熱水溫度 的英文怎麼說

中文拼音 [rèshuǐwēndù]
熱水溫度 英文
temperature of hot water
  • 水 : 名詞1 （由兩個氫原子和一個氧原子結合而成的液體） water 2 （河流） river 3 （指江、河、湖、海、洋...
  • 溫 : Ⅰ形容詞（不冷不熱） warm; lukewarm; hot; gentle; mild Ⅱ名詞1 （溫度） temperature 2 （瘟） acute ...
  • 度 : 度動詞[書面語] （推測; 估計） surmise; estimate
  • 熱水 : hot water熱水袋 hot water bog; hot water bottle; 熱水供[采]暖 [機械工程] hot water heating; hydra...
  • 溫度 : [物理學] temperature
  1. Automatic cip local cleaning system is specializd equipment used for automatic cleaning for beverage production line and filling facility. acid washing, alkali washing and thermal washing can be chosen. the tempera - ture for acid, alkali and hot water can be set

    自動ctp就地清洗系統，是用來對飲料生產線和灌裝設備進行自動清洗的專用設備；可提供酸洗，堿洗以及熱洗三個程序，設置酸液，堿液濃度及熱水溫度。
  2. The thermoelectric systems come as a turnkey solution including the heating / cooling stage, the temperature controller and the water circulator

    熱電系統作為全套解決方案由冷熱臺、溫度控制器和水循環裝置組成。
  3. As for the dehumidifying conditions, the condensing rate for the humid air increases with reynolds number but decreases as the inlet temperature of cold water increases

    同時濕盤管的熱傳量及除濕率亦也隨著冰水入口溫度的降低而增加，顯熱比隨著冰水溫度的降低而減小。
  4. The temperature of the hot pack should be comfortably warm, not " the hotter the better "

    熱敷的溫度應是中度和暖，切忌使用過熱的溫度或躺于暖水袋上。
  5. For a soil or rock of water - lacked, a heat transfer theoretical model is developed, which is a steady or unsteady, the results show that reservoir temperature, thermal diffusion coefficient, inlet temperature, flow rate of and run time of ground source heat pumps have an effect directly on heat transfer process of dhe. it can deduce that intermit running is favorable for this type of soils and rocks

    對于貧含水地下巖土層建立了穩態與非穩態傳熱的理論模型，分析結果表明，巖土層的熱儲溫度、導溫系數、埋地換熱器進水溫度、流量以及地源熱泵系統的運行時間或開停機比，都對埋地換熱器的傳熱過程產生直接影響，可以推斷，對于該類型巖土層的地源熱泵系統，採用間歇運行將是有利的。
  6. Through adjust the initial vaiue of the water supplied tcmperature in the second - net, the amomation systcm can auto run with a depressed standard to distribllte the energy averagely

    即當供熱能力不足時，通過調整二次供水溫度的設定值，使自動控制系統在降低供熱標準的基礎上自動運行，實現熱量的平均分配。
  7. On the basis of test results, the effects of operation parameters such as material thickness, heating temperature and pressure of drying chamber on vacuum freeze drying are discussed. aiming at decreasing drying time and reducing energy consumption, these parameters are optimized and optimization results agree well with actual results

    在三因素二次正交回歸試驗的結果分析的基礎上，利用降維分析方法探討了凍干厚度、加熱板溫度和系統的真空度對乾燥時間和乾燥能耗的影響，並對混合加熱條件下單位水分能耗和凍干生產率進行了優化分析。
  8. For accumulating heat from piping and making as even the temperatures in various spaces betwiin pipes an possible, gravel foundation is first laid, mortar is mixed fully by mixing ratio of 1 : 2, the floor is finished level and then perfect curig in damp condition is carried out

    為保證管路間蓄熱和溫度均勻應鋪下砂礫層后進行配比為1 ： 2的灰漿完成處理，不僅要保證地板水平，還要在濕潤狀態下自然乾燥，使得到徹底的養護，人為的養護會導致地板雛裂，應予以注意。
  9. We can make sure the temperature of the second - net water isupplied and watcr - returned in the most cold and hot times including our experience, get the temperature change curve of the waer - supp1ied in the first - nct and the second - net with the change of temperatllre outdoor

    根據實際運行經驗可以確定最冷時和最暖時的二次供水和回水溫度參數，得出熱網最大輸送能力時的一次熱網和二次熱網供水溫度隨室外溫度變化曲線。
  10. The paper analyzes the non - lineal relations of the quantity of heat exchange and water flux of coil exchanger in part - load operating condition, the shortage of deciding the water flux in bypass pipe, the disadvantage that the operating condition of pumps and chiller ca n ' t be met with the load change of the air conditioning system in different operating condition of using pressure - difference bypassing control in primary water pump system. using load control method in the change of the operating condition of primary water pump system can realize that the load change is small and reasonable in the on / off condition of pumps and m m chiller by comparing load control method in primary variable - flow water pump system with pressure - difference bypassing control method, back water temperature control method

    本論文從目前空調工程中使用的變流量水系統入手，研究了盤管換熱器在部分負荷下水流量與換熱量的非線性關系，分析了文獻中介紹的旁通管通流能力選擇的不足之處和一次泵水系統採用壓差旁通控制時，工況轉換不能滿足系統控制要求的缺陷；比較了一次泵變流量水系統中壓差旁通控製法、回水溫度控製法、負荷控製法的精確性，並得出了在一次泵水系統的工況轉換時，採用負荷控製法能使冷水機組及其相應水泵在啟停時的負荷變化范圍較小，更符合建築物的冷量需求，節能效果較好的結論。
  11. Effect of hot - pressing temperature and natural curing time on properties of fast - curing cement particle board

    熱壓溫度和養護時間對快速固化水泥刨花板性能的影響
  12. Based on physical simulation and numerical simulation, the conversion of hot water slug flooding with nitrogen foam is presented and some injection indices are optimized, including foam concentration, gas - liquid ratio, injection rate, temperature of water, slug length. from reservoir research and oilfield development, studying disadvantageous factors, the paper will have guilding value for heavy oil reservoir development of leng 43 block

    對熱水+氮氣泡沫段塞驅的關鍵技術指標，包括泡沫劑濃度、氣液比、注入速度、注水溫度和段塞長度等重要參數進行了優選，提出了注水速度80 100t d 、氣液比1 ： 1 、注水溫度95 100 、溶劑濃度0 . 5的推薦方案。
  13. Thirdly, radiator performance test - bed thermal system control modeling and rule self - organizing fuzzy control simulation were studied. the water supply temperature, radiator inlet temperature, test room temperature based on water temperature regulation, air supply average temperature and test room temperature based on air temperature regulation total five controlled processes transfer function were set. finally, rule self - organizing fuzzy control simulation for two

    通過試驗，辨識了散熱器實驗臺熱工系統中供水溫度、散熱器進水溫度、基於熱水系統調節的測試室溫度、送風平均溫度及基於送風系統調節的測試室溫度共5個被控過程的傳遞函數，並對基於熱水系統調節和基於送風系統調節的測試室溫度響應過程進行了規則自組織模糊控制模擬。
  14. Sea water temperature for designing marine heat exchangers

    設計船舶熱交換器採用的海水溫度
  15. We can figure out the initial value of the watcr supplied tcmperature in the second - net according to the water supplied temperature in the first - net

    根據一次熱網供水溫度計算出二次供水溫度的設定值。
  16. 9 when there is some air in water heater, it will affect the water temperature, please release gas from decontamination devices and radiator

    9當過水熱內有空氣時，將影響出水溫度，請通過除污器放氣或散熱器放氣口放氣
  17. Through developing a 2 - dimensions heat transfer model of buried pipe - in - pipe heat exchanger and simulating the process by computer, the author figures out inter - relations of factors which influence characteristics of buried pipe - in - pipe heat exchanger, such as pipe diameter, pipe length, ratio of pipe diameters, flow rate, inlet water temperature, patterns of water inlet and outlet, and material features made of pipe, and proposes some optimizing indexes of buried pipe - in - pipe heat exchanger. the author studies the " heat - - short circuit " phenomenon as well and gives < wp = 5 > some important results

    本文通過建立地下套管式埋管換熱器傳熱過程的二維傳熱模型，並藉助計算機對分析結果進行解析，弄清了影響埋管換熱器性能的管徑、管長、管徑比、通過流量、進水溫度、進出水方式以及管材等參數的作用，並提出了相應的優化指標，對研究界懸而未決的「熱短路」問題也進行了細致分析，得出了有關結論。
  18. Two conclusions about the tube will be drawn : l ) being used in the heater of 300mw unit, it will cause 57 % decrease of the heater ' s volume and make the workshop ' s area much more smaller, which is gained from the reasonable device of the heater itself ; 2 ) when used in 100mw unit, higher capability lower temperature difference higher feed temperature of the heater will be available and better economic efficiency of the unit will be gained

    應用雙側微肋強化換熱管后體積可以減小為原來的43 ，大大減小了加熱器佔用廠房的面積。 （ 2 ）雙側微肋強化換熱管應用於100mw機組熱電廠加熱器時，進行改造中，由於原加熱器存在很多缺陷，使加熱器傳熱性能降低，此時使用雙側微肋強化換熱管對加熱器進行改造時，可以提高加熱器傳熱性能，減少加熱器端差，提高加熱器給水溫度，提高機組的經濟效益。
  19. Concentric jacket pipe surrounded the test condenser. steam was generated in the boiler, flowed upward to the inlet of connection pipes, then flowed downward into the condenser tube, the cooling water flowed countercurrently through the annulus. the experiment covered the range of the pressure 1. 0 ~ 3. 0bar, heating power 2. 0 ~ 15. 0kw, steam mass flow rate 0. 001 ~ 0. 004kg / s, air mass flow rate 0. 0 ~ 0. 00163kg / s, and cooling water temperature 20 - 60 ?

    在系統壓力為0 . 1 0 . 3mpa ，加熱功率為2 15kw ，蒸汽質量流量為0 . 001 0 . 004kg s ，空氣質量流量為0 . 0 0 . 00163kg s ，二次側冷卻水溫度20 60的范圍內，系統研究了豎直下降管內含有空氣的蒸汽冷凝特性，獲得了不同壓力、不同空氣含量和不同加熱功率下，冷凝段的溫度分佈和局部熱流密度的數據。
  20. It is difficult to apply general pid control to temperature of secondary water of the heating power station with the indeterminate nonlinear and changing parameter characteristics by self - adjusting three parameters k _ ( p ) k _ ( j ) k _ ( d ) on line the fuzzy - pid controller has better response rate and stability property than the general pid controller

    常規的pid控制難以滿足供暖熱水溫度控制要求。據此，本文提出了採用模糊pid演算法實現對熱力站溫度的控制，利用模糊推理對pid參數k _ p 、 k _ i 、 k _ d進行在線整定。
分享友人
分享到 Line

分享到臉書