熱能流量計 的英文怎麼說

中文拼音 [rènéngliúliángjì]
熱能流量計 英文
calorimetric flowmeter
  • 能 : 能名詞（姓氏） a surname
  • 流 : Ⅰ動1 （液體移動; 流動） flow 2 （移動不定） drift; move; wander 3 （流傳; 傳播） spread 4 （向壞...
  • 量 : 量動1. （度量） measure 2. （估量） estimate; size up
  • 計 : Ⅰ動詞1 （計算） count; compute; calculate; number 2 （設想; 打算） plan; plot Ⅱ名詞1 （測量或計算...
  • 熱能 : thermal energy; heat energy; thermal power; heat熱能變換器 thermal energy converter; 熱能感受器 c...
  • 流量 : rate of flow; flow; runoff; discharge; throughput; （flow） rate; quantity （of flow）; flux
  1. Also the theoretical basis of the method have been checked through simple deducing simulation and the influences of various physical parameters on the method have been studied. it is shown that the method is theoretically reliable for the production oil wells without very high production rate and is more suitable in field production for oil wells ( i ) in area with bigger geothermal gradient ; ( ii ) producing fluids ( oil and water ) with distinguish thermal characteristics ; ( iii ) producing oil with lower heat capacity or water with higher heat capacity ; ( iv ) with good surface measurement accuracy, as well as the method h as certain requirements on the accuracy of the temperature and flowmeter logs sensors

    就該產出剖面方法的理論基礎進行了簡單的正演模擬和可能影響該方法的各項物理參數進行了全面的考察，結果表明，該方法對于非高產的生產油井來說在理論上是可靠的，在實際生產中適合於（ 1 ） 、油井所在地區地溫梯度較大的油井； （ 2 ） 、油水熱特性差別較大的油井； （ 3 ） 、油比熱容值偏低水比熱容值偏高的油井； （ 4 ） 、井口計量精度較高的油井，並且對井溫測井和流量測井的傳感性精度有一定的要求。
  2. Abstract : based on the analysis of the mathematics models of saturation steam density and superheat steam density the paper states that the deviation of the detection on temperature highly affects the accuracy of intelligent flow totalizer. especially for saturation steam ， the accuracy of the temperature detection circuit shall be designed higher than the accuracy of the instrument. thus a temperature detection circuit based on ratio method with high accuracy is introduced

    文摘:在分析飽和蒸汽和過熱蒸汽密度的數學模型的基礎上指出，溫度檢測的偏差對智能流量積算儀的精度影響極大，尤其是飽和蒸汽，測溫電路的精度應設計為遠高於儀表的精度，同時引入一種基於比率法的高精度測溫電路。
  3. Abstract : through study on energy dissipation of goupitang project on the wu - jiang river, the velocity field in the water cushion pool downstream ski - jump or drop was measured by hot - film anemometers on a fine model with scale 1 380

    文摘:結合烏江構皮灘水利樞紐工程消能問題研究，用熱膜流速儀在比尺為1 380的精細模型上量測了拱壩挑跌流在水墊塘內的流速場，並由試驗成果分析了淹沒射流在水墊塘內的消能過程，計算了消能率。
  4. With the impact test of conditioner airport and anti - dust mesh settings on heat exchange gas flow, the paper illustrates that the improper design may reduce gas flow, influence the refrigerating capacity of the system, and increase energy consumption

    摘要通過空調風口及防塵網設置對換熱氣流流量影響的測試，結果表明，若空調風口及防塵網設計不當，則可能造成氣流量減少，並影響系統製冷量，增大能量消耗。
  5. The mathematical models set up for flow and heat calculations have been applied in the design work of intelligent flow or heat accumulators

    對于流量、熱量計算的數學模型，已在各類智能流量、熱量積算儀的設計中得到了應用。
  6. Experiments on the gas flow patterns in the flowmeter prove that the algorithm used in arm digital gas mass flowmeter is capable of significantly improving the sensitivity of the heat sensor, hence superior in terms of the measurement of gas mass flow

    並將此演算法應用於以arm處理器為核心的數字式氣體質量流量計中實驗證明，該方法能夠明顯改善熱式傳感器的動態響應速度，實現其快速補償。
  7. Focusing on the performance evaluating and the design of tripropellant injector, adopting the cold test rig with background pressure supply, malvem particle analyzer, ccd photography system, tripropellant hot test - bed, numerical simulation software and auxiliary theoretical a nalysis, the d ischarge c haracteristic a s w ell a s a tomization p erformance o f the injector and the combustion performance as well as the mode - transition characteristic of thrust chamber are studied detailedly based on the 3 different structures of coaxial tripropellant injector, large numbers of important conclusions are gained

    本文圍繞三組元噴嘴的性能評定及設計方法。採用反壓冷試臺、馬爾文測粒儀、 ccd高速攝影系統、三組元發動機熱態試驗臺、數值模擬程序及輔助理論分析等多種技術手段和研究方法，對三種結構的同軸式三組元噴嘴深入進行了噴嘴流量特性和霧化特性、推力室燃燒性能和轉工況性能研究，得到了大量重要結果。
  8. The calculated results show that, for low energy protons ( energy less than several decade mev ), the contribution of proton nuclear reaction to energy deposition can be neglected ; while for high energy protons ( energy greater than several hundred mev ), the great difference appears for the above two cases. this gives us an indication that the contribution of proton nuclear reaction to the energy deposition must be concerned for high - energy protons. the propagation process in material of thermal shock wave induced by high - energy intense - current pulsed proton beam irradiation is calculated for several different proton energies

    對于入射能注量為418 （ j cm ~ 2 ）脈沖寬度為0 . 1 s的矩形脈沖強流質子束，計算結果表明，由於質子束能量不同，引起的初始熱激波（ 0 . 1 s時刻的熱激波）有單峰結構，也有雙峰結構，不同能量的強流質子束引起的熱激波在傳播的過程中都會出現明顯的彈性前驅波。
  9. Termal performance of buildings - determination of thermal resistance by hot box method using heat flow meter - masonry ; german version en 1934 : 1998

    建築物熱性能.熱阻測量.熱流計熱箱法.砌墻
  10. Calculating and analysing result indicates that the control point located in the joint of first user and main pipe and the pressure difference equaled to the design value can satisfy the demand flow rate of the users and save energy

    計算分析結果表明，將控制點設置在第一個熱用戶與主幹管的連接處、控制壓差設為該處的設計工況壓差既能保證熱網中各用戶流量又較節能。
  11. Whole scheme of frame design of test - bed is proposed as : the host fanner supply the firebox the once and twice air required by diesel oil ' s burning and the cooling air ; the export parameter of the test - bed is varied by the adjust of the flux of air and diesel oil. and the air flux is varied by adjusting the rev of the fanner adjusted by transducer and the corner of the fan inlet adjusted by step motor. the quantity of oil is varied by adjusting the oil valve adjusted by step motor ; the measurement of the air flux in the test - bed adopts the method of fanner dynamics performance test in the nation criterion

    確立了實驗臺結構設計方案：主風機為燃燒器提供燃燒所需的一次、二次進風量及冷卻風量；利用變頻器調節主風機轉速、用步進電機調節風門開度來調節風量，用步進電機調節回油閥開度來調節供油量，從而實現對模擬實驗臺出口煙氣熱流量的調節；實驗臺的流量測量採用風機動力性能測試標準中測流量方法等。
  12. Whole scheme of frame design of testing flat is proposed as : the host fanner supply the air required by flamer ’ s burning and cooling, the export parameter of the flat varies by different rotate speed of the fanner 、 angle of the fan inlet and the quantity of oil, the measurement of flow in the testing flat adopts the method of fanner dynamics performance test in the nation criterion

    確立了實驗臺結構設計方案：主風機為燃燒器提供燃燒所需的一次、二次進風量及冷卻風量；模擬實驗臺出口煙氣熱流量是通過調節風機的轉速、風門開度及燃油量來改變；實驗臺的流量測量採用風機動力性能測試標準中流量方法等。
  13. A lot of results are made from calculating of case for geothermal reservoir property of earth energy within 200 2000 ( m. ) ， it is helpful to analysis influence of permeability coefficient, kinematic viscosity and thermal diffusion coefficient of soils and rocks on heat transfer performance

    在地表熱能熱儲物性為200 - 2000 （ m . ）的范圍內進行的理論計算，得到了許多重要結果，為分析巖土層滲透系數、流體運動粘度和導溫系數等對傳熱量的影響打下了良好基礎。
  14. Because coriolis mass flowmeters have directly quclity discharge of measuring he flwid measure an accarate, degree high application wide, the rearinghave low request circulate cveaibility. maintain a rate low etc, character istics extensiuely applied cure the gold thermodgnamic energy electrie power food in the petroleum chemical engintring etc discharge of the flow measure

    由於科氏質量流量計具有能夠直接測量流體的質量流量，測量準確度高，應用范圍廣，安裝要求低，儀表運行可靠，維修率低等優點，已廣泛應用於石油化工冶金熱力電力食品等領域的流量測量。
  15. By citing distribution piping loss curve, analyses the two commonly used control methods of constant pump head and constant remote circuit differential pressure and considers that control with a constant remote circuit differential pressure is the better

    通過提出輸配管壓損曲線概念，從理論上分析了計量供熱變流量系統循環水泵常用的恆揚程式控制制和恆定最不利環路壓降控制兩種方案，認為恆定最不利用戶資用壓力方案節能效果較好。
  16. Developing instrument industry chidz has formed intellectual instruments industry, which focus on home application intelligent instruments ( water, electricity, steam and heat ), different kinds of flow meters ( liquid meters ), weighing apparatus, automation control system and nonmetallic material examination instrumentation, depending on several scienic and technological small and medium - sized enterprises

    依託十幾家科技型中小企業，初步形成了以民用智能化儀表（水、電、氣、熱） 、流量計（液位計） 、衡器、自動化控制系統和非金屬材料檢驗檢測儀器為主導產品的智能化儀器儀表產業。
  17. Thermal performance of building products and components - specific criteria for the assessment of laboratories measuring heat transfer properties - measurements by heat flow meter method

    建築產品和元件熱性能.試驗室測量熱傳遞性能評估的特殊標準.用熱流量計法測量
  18. Thermal performance of building products and components. specific criteria for the assessment of laboratories measuring heat transfer properties. part 3 : measurements by heat flow meter method

    建築產品及部件的熱性能.評估實驗室測量熱傳遞性能的專用準則.第3部分:熱流量計測量法
  19. Thermal performance of building materials and products - determination of thermal resistande by means of guarded hot plate and heat flow meter methods - thick products of high and medium thermal resistance

    建築材料和產品的熱性能.用防護熱板和熱流量計法測定熱阻.厚產品的高熱阻和中熱阻
  20. Flow meters may be affected, giving incorrect reading. the rate of corrosion of pipeline may also increase. the abnormal current induced in power grids may damage transformers because of overheating

    流量計可能會受到干擾，使數據失誤管道的腐蝕速度亦可能會增快電力網路上的不正常電流可能使變壓器因過熱而燒毀。
分享友人
分享到 Line

分享到臉書