熱荷載試驗 的英文怎麼說

中文拼音 [rèhézǎishìyàn]
熱荷載試驗 英文
hot load test
  • 荷 : 荷名詞（蓮） lotus
  • 載 : 載Ⅰ名詞（年） year : 一年半載 six to twelve months; six months to a year; 三年五載 three to five ...
  • 試 : 名詞（古代占卜用的器具） astrolabe
  • 驗 : 動詞1. （察看; 查考） examine; check; test 2. （產生預期的效果） prove effective; produce the expected result
  • 試驗 : trial; experiment; test
  1. The age hardening characteristic of as - cast cu20ni20mn and cu20ni35mn alloys and the interface characteristic between the alloy and cast tungsten carbide were studied, and on the basis of this study, composites of cu - ni - mn alloy reinforced with different volume fraction ( 0 - 45vol. % ) and different size ( 42 - 362 m ) of cast tungsten carbide particles were made by vacuum hot - pressing liquid sintering technology. pin on disk two body abrasion tests have been performed with different size of sic abrasive under different loads

    本文研究了鑄態cu20ni20mn和cu20ni35mn合金的時效硬化特性及其與鑄造碳化鎢的界面特性，並在此基礎上以不同尺寸（ 42 362 m ）的鑄造碳化鎢顆粒為增強體，採用真空熱壓液相燒結技術制備了不同顆粒含量（ 0 45vol . ）的鑄造碳化鎢顆粒增強cu - ni - mn合金基復合材料；以不同粒度的sic為磨料，在不同載荷條件下利用銷?盤磨損試驗機測試了復合材料的二體磨料磨損性能。
  2. On the basic theory of transfer heat, tribology of rolling bearings and rotor dynamics, taking gdz48a electrospindle as an example, the paper puts forward the spindle bearing ' s quasi - dynamics analysis model with the influences of the friction heat and preloadings analyzes the friction moment, velocities, contact loads, friction heat and stiffness and studies the influences of the friction heat, structure and application parameters on the speed and dynamics

    本文以傳熱學、滾動軸承摩擦學和轉子動力學為理論基礎，以gdz48a型電主軸為例，建立了考慮摩擦熱和預緊方式影響的主軸軸承擬動力學分析模型，分析了軸承的摩擦力矩、運動、載荷和剛度，研究了軸承的熱特性、設計和應用參數對速度和動力學性能的影響，並進行了試驗驗證。
  3. Standard test method for determining stress - corrosion cracking resistance of heat - treatable aluminum alloy products using breaking load method

    用破壞載荷法測定可熱處理鋁合金製品的抗應力腐蝕開裂特性的標準試驗方法
  4. In the master thesis, the fatigue characteristics of the ferroelectric films under thermal load and electrical load were investigated. the thermal load was induced by a pulse laser beam of nd : yag and the electrical load was made by rt6000s ferroelectric tester t o act on the films respectively. the effect of thermal or electric loads on the films properties was discussed

    本文對鐵電薄膜在循環的熱載荷和電載荷作用下的疲勞特性進行了研究，分別用nd ： yag脈沖激光器模擬熱載荷、用rt6000s鐵電測試儀模擬電載荷作用於鐵電薄膜，根據實驗結果探討了這兩種載荷對鐵電薄膜性能的影響。
分享友人
分享到 Line

分享到臉書