熱處理實驗室 的英文怎麼說

中文拼音 [rèchǔlǐshíyànshì]
熱處理實驗室 英文
heat treatment lab
  • 處 : 處名詞1 （地方） place 2 （方面; 某一點） part; point 3 （機關或機關里一個部門） department; offi...
  • 理 : Ⅰ名詞1 （物質組織的條紋） texture; grain （in wood skin etc ） 2 （道理;事理） reason; logic; tru...
  • 實 : Ⅰ形容詞1 （內部完全填滿 沒有空隙） solid 2 （真實; 實在） true; real; honest Ⅱ名詞1 （實際; 事實...
  • 驗 : 動詞1. （察看; 查考） examine; check; test 2. （產生預期的效果） prove effective; produce the expected result
  • 熱處理 : [冶金學] heat treatment; heat treating熱處理保護塗料 heat treatment protective coating; 熱處理車...
  1. In trpsin tolerance assay. this virus could resist to 1 % trpsis at 37 in an hour. in acid tolerance assay, this virus was resistant to ph3. 0 and ph5. 0 at 37 in 2 hours, and the average infection litre of the virus decreased little. in heat assay, at 50, the virus was processed from 5 minutes to 150 minutes and at each condition the viral virulence reduced to some certain degree. among these conditions, when at 50 in 30 minutes. the average infection litre of this virus decreased over 2 tilre. and when al 50 in an hour, cpe of ihis virus disappeared. when time was set for an hour. but with processed in different temperature as 50 60 70, 80, the virus losl the multiplication capacity complelely. in biological assay, we selected different cell lines to cultivate this virus by laking advantage of possesional cells at that time in our laboratory. then we found that fcwf cell line was the most sensitive to dxmv and mdck was the second. with f81 cell line, after passaged for 12 times continuously with low concentration of fcs. the virus could produce cpe. however, with vero cell line. the virus could not procuce any cpe after many passages. the hemagglutination and lumadsorption reaction test proved that this virus had no any reaction to erythrocyte of pig, fowl and cavy. by neutrolizaion assay, dxmv could be identified as a kind of ccv

    理化學研究表明，該病毒為rna病毒，對氯仿、乙醚敏感；胰酶試驗中，經37 、 1小時處理的病毒，仍然能夠在貓源細胞fcwf細胞上生長，並且毒力基本保持不變；耐酸性試驗中，病毒分別在ph5 . 0和ph3 . 0經37作用2小時，毒力僅下降一個滴度；耐熱性試驗中，該病毒在恆定溫度50 ，設定不同時間，從5分鐘到150分鐘，毒力均有不同程度下降，其中， 50作用30分鐘，病毒平均滴度下降2個單位； 50 ， 60分鐘， cpe消失；恆定時間1小時，設定不同溫度（ 50 - 60 - 70 - 80 ） ，病毒在細胞上完全喪失增殖能力， cpe消失。生物學試驗，利用實驗室現有條件，選擇不同的細胞系對該病毒進行培養，發現該病毒對貓源細胞fcwf最敏感； mdck細胞次之； f81細胞經多次傳代，亦可出現cpe ；而vero細胞則不敏感。血凝試驗表明，該病毒對豬、雞、人及豚鼠的紅細胞均無血凝性。
  2. Main operating companies : one, quality brands imported power plant auxiliary equipment : including valves, pumps and transducer and thermocouple and actuators, measuring gauges, pressure switches, solenoid valve and ion exchange resins and other rights and the importation of water treatment packages instruments : online various instruments, laboratory instruments 3, chemical water treatment, electro - deionization ( edi ) 4. complete sets of equipment, installation, commissioning and maintenance

    公司主要經營： 1 、代理進口優質品牌電站輔機設備：含閥門、泵類、變送器、熱電偶、執行器、計量儀表、壓力開關、電磁閥、離子交換樹脂等； 2 、代理進口水處理成套儀器儀表：各類在線儀表、實驗室儀表； 3 、化水處理、電除鹽（ edi ） 4 、設備成套安裝、調試、檢修。
  3. There are the production lines established of intermediate - frequency melting, silicasol shuck, precision casting and metal ceramic, and 250 universal devices suck asvacuum melting electric furnaces, high - temperature and intermediate - temperature heat treatment electric furnaces, digitai - control lathes, milling and drilling machines, coreless millers, spherical surface millers, standing milling machines and so on, lt has established the central measuring roomm physicallab, chemical lab, metallic phase lab, crack detection test lab, seat ring lab, rocker lab and ducgt trestle lab, our esported gas engine valve seat to america was rewarded the second prize in terms of sichuan high - quality product

    建有中頻熔煉真空熔煉硅膠溶模精密鑄造粉末冶金生產線。有中頻電爐真空熔練電爐高中溫熱處理電爐數控車床鉆銑床無芯磨外園磨立磨等通用設備250臺套。有中心計量室物理化學金相探傷檢測及座圈搖臂導管臺架實驗室。
  4. Again, because the ion influx technique have a little damnification on the skin - deep structure for the cdte thin films, among the experiment, we have let the doped cdte thin films be annealed a hour with n2 atmosphere at 500, and then slowly cooled until the room temperature. via the test and analyse, heat treatment has very important effect on the comeback of crystallattice surface disfigurements. finally, the films were characterized by x - ray diffraction ( xrd ), scanning electron microscopy ( sem ), ultraviolet visible ( uv ) and the hall effect measurement

    再次，由於離子注入會對薄膜表面的結構造成損傷，本實驗把被注入離子的cdte薄膜在n2氣氛中500下退火1個小時，然後緩慢冷卻至室溫。經測試分析，熱處理對晶格表面缺陷的恢復有很重要的作用。最後，利用xrd 、 sem 、紫外可見分光光度計及hall測試系統研究其結構，表面形貌和光電性能。
  5. The contents of this paper include the following several aspects : ( 1 ) a model of the fractures leakage is built through counting and analyzing the wealthy geological records of hae field, and a model of the fracture water transporting is also built according to the fracture water condition of its recharge and its runoff and its discharge in hae field ; ( 2 ) this paper studies the chemical behavior and the migration parameters of the elenent sr2 + in ground water in hae field, the main contents include : the presence form of the element sr in ground water is analyzed by way of the rmodynamics ; the absorption mechanism that granite and sand stone absorbs sr element is analyzed based on theory and experiment test the diffusion parameters of the element sr in water and in granite and in sand stone are researched with laboratory experiment test ; the partition coefficient of sand stone and granite to sr is tested by the batch way

    其研究內容包括以下幾個方面： （ 1 ）通過對我國hae預選處置場豐富地質資料的大量統計和分析，建立了該處置場的基巖裂隙滲透模型。再根據hae預選處置場基巖裂隙水的補給、徑流、排泄條件及水位動態特徵，建立了預選處置場基巖裂隙水水運動模型。 （ 2 ）對高毒性鍶元素在我國hae預選處置場地下水中的化學行為和遷移參數進行系統的研究，其中主要包括運用熱力學方法分析了鍶元素在地下水中的存在形態，利用理論分析與實驗測試相結合的方法分析了花崗巖和砂巖對核素鍶的吸附機制，採用室內實驗裝置研究了核素鍶在地下水中的擴散參數以及在花崗巖和砂巖中的本徵擴散參數，採用靜態批式法研究了鍶在砂巖和花崗巖中的分配系數。
  6. The results of the experiments show that the ti3al - tcll dual alloys, by vacuum - electron - beam weld, hot die forging and 680c / 12h, ac, heat treatments, have satisfied synthesis properties of intensity, plasticity, hardness. and also it is the feasiblie way. this will establish the supporting technology for the manufacture of the compress disk in the areoengine

    實驗結果表明，經真空電子束焊接ti _ 3al ? tc11雙合金經過熱模鍛造和680 12h ， ac或815 1h + 700 8h ， ac熱處理后，焊接區組織過渡均勻，可以使得焊縫處強度在室溫拉伸時高於ti _ 3al ，而在600拉伸時高於tc11合金，獲得強度、塑性、硬度均令人滿意的綜合性能，且是一條可行的工藝路線。
  7. Safety requirements for electrical equipment for measurement, control, and laboratory use - part 2 - 043 : particular requirements for dry heat sterilizers using either hot air or hot inert gas for the treatment of medical materials, and for laboratory processes

    測量控制和實驗室用電氣設備的安全要求.第2 - 043部分:使用熱空氣或熱惰性氣體的實驗室處理和醫療材料處理用乾熱消毒器的特殊要求
  8. Safety requirements for electrical equipment for measurement, control, and laboratory use - part 3 - 043 : conformity verification report for iec 61010 - 2 - 043 : 1997 ; particular requirements for dry heat sterilizers using either hot air or hot inert gas for the treatment of medical materials and for laboratory processes

    測量控制及實驗室用電氣設備的安全要求.第3 - 043部分: iec 61010 - 2 - 043 : 1997合格鑒定報告.醫療材料處理和實驗室操作用熱氣體或熱惰性氣體乾熱消毒器的特殊要求
  9. A special clamp for etching optical fiber and depositing pd film on the fiber is designed. designed a encapsulation set of the characteristics that is dampproof, shake and eroding resisted. the experimental set - up for hydrogen sensing includes the light source, gas cell, mass flow controller, stainless steel helical tubing and the detector, etc. the experimental results are also discussed

    本文還設計了一套光纖腐蝕用夾具、光纖封裝加熱夾具和一套光纖濺射鍍膜實驗夾具;設計並製作了一套具有防潮、抗震和抗腐蝕功效的光纖傳感頭封裝裝置;設計了一套由激光器、反應混合氣室、光功率計、質子流量計和流量控制器等組成的氫氣定標實驗裝置並對實驗數據進行了分析與處理。
  10. Safety requirements for electrical equipment for measurement, control and laboratory use - particular requirements for dry heat sterilizers using either hot air or hot inert gas for the treatment of medical materials, and for laboratory processes

    測量控制和實驗室用電氣設備安全性要求.醫用材料處理及實驗室處理用熱空氣或熱惰性氣體乾熱滅菌器專門要求
  11. The reason is very simple. the density in the stellar and interstellar environment is extremely low, lower than any vacuum conditions that we can create in the laboratory. such conditions are a far cry from the hot, dense environment in the great depths of the earth where diamonds are formed

    理由很簡單，恆星大氣和星際間環境的密度遠比任何實驗室能製造出來的真空為低，這和地球深處又熱又高密度的環境有著天淵之別，又怎可能製造出鉆石？
分享友人
分享到 Line

分享到臉書