熱處理過的 的英文怎麼說

中文拼音 [rèchǔlǐguòde]
熱處理過的 英文
heat treated
  • 處 : 處名詞1 （地方） place 2 （方面; 某一點） part; point 3 （機關或機關里一個部門） department; offi...
  • 理 : Ⅰ名詞1 （物質組織的條紋） texture; grain （in wood skin etc ） 2 （道理;事理） reason; logic; tru...
  • 過 : 過Ⅰ動詞[口語] （超越） go beyond the limit; undue; excessiveⅡ名詞（姓氏） a surname
  • 的 : 4次方是 The fourth power of 2 is direction
  • 熱處理 : [冶金學] heat treatment; heat treating熱處理保護塗料 heat treatment protective coating; 熱處理車...
  1. Sagging and creep of the compo ? nents occur during heat treatment as a result of improper support of components or warped hearth in the hardening furnace

    當對部件支持不當或在爐床翹曲的淬火爐中進行淬火時，部件在熱處理過程中會出現弧垂和蠕變現象。
  2. Waste heat and treated sewage effluents are two such discharges that are now being investigated.

    廢熱和處理過的污水，就是目前正進行研究的兩種排放物。
  3. According to the nb - si phase diagram, the temperature of 1550 ?, which is lower than the eutectoid transformation temperature of nbssi ( 1783 ? ), is chosen for heat - treatment. according to the present conditions of the furfaces, heat - treatment by stages is first proposed for the nb - si system intermetallic composites to keep the furface in good conditions. the results indicate that the equilibrium nb + nbssia dual - phase microstructure of the nb - si system intermetallics forms gradually via such eutectoid reaction as nbasi ? nb + nbssis with the heat - treatment time

    根據nb - si二元相圖，選擇略低於nb _ 3si共析轉變溫度t _ f = 1783的1550對鑄態nb - si系金屬間化合物進行不同時間（ 25h - 100h ）的熱處理，並根據目前國內和我院熱處理爐的現狀，首次提出採用分段熱處理的方法來解決nb - si合金熱處理溫度高、連續熱處理時間過長而影響熱處理爐壽命的困難。
  4. No reaction was between the silicon carbide particles and the ferroalloy matrix during the heat treatment

    在復合材料的熱處理過程中並未發現sicp與基體之間反應的進一步進行。
  5. It was found that nitrogen increased the fracture strength of silicon single crystal. we consider that the nitrogen may change the shockley band on silicon surface and form complex to influence the fracture procedure

    本文從硅材料的基本概念入手，闡述了硅單晶材料的脆性斷裂、脆塑轉變以及在熱處理過程中的翹曲研究，並通過這三個部分進行實驗。
  6. Effect of heat treatment on phase transition of barium titanate

    熱處理過程對納米鈦酸鋇相變的影響研究
  7. Surface states and the topmost surface atoms of the batio3 thin films have been analyzed by x - ray photoelectron spectroscopy ( xps ) and angle - resolved x - ray photoelectron spectroscopy ( arxps ). the results show that the as - grown batio3 thin films have an enriched - bao nonstoichiometric surface layer which can be removed by ar + ion sputtering, and the atomic ratio of ba to ti decreases with increasing the depth of ar + ion sputtering

    用x射線光電子能譜技術（ xps ）和角分辨x射線光電子能譜技術（ arxps ）研究了薄膜的表面化學態以及最頂層原子種類和分佈狀況，結果顯示在熱處理過程中薄膜表面形成一層富含bao的非計量鈦氧化物層，並且鋇-鈦原子濃度比隨著探測深度的增大而逐漸減小。
  8. Then, the effect of heavily doped boron on ig of czochralski silicon was also investigated. it is found that no dz ( denuded zones ) were observed in the hb samples subjected to high one - step temperature, ramping annealing respectively. for conventional high - low - high three - step ig annealing, the dz becomes narrower and bmd density is higher in hb samples than that in lb samples, as a result of hb enhancing oxygen precipitation

    結果顯示，單步高溫熱處理時重摻硼樣品不能形成潔凈區；降溫退火中，降溫速度較為緩慢（ 3 / min ）時能生成一定量的氧沉澱，但沒有潔凈區形成；普通高?低?高三步熱處理過程中，形成明顯的潔凈區，但相對輕摻樣品而言，潔凈區較窄，氧沉澱密度明顯偏高，說明重摻硼樣品吸雜能力強。
  9. Standard specification for reinforced autoclaved aerated concrete elements

    增強的熱壓處理過的加氣混凝土構件的標準規范
  10. The function of c2h1obn in ni - w - b alloy electrodeposition has been studied by means of cyclic voltamxnetry ( cv ), the deposition mechanism of ni - w and ni - w - b alloy studied by potentiostafic step and their structures before and after heat treatments investigated by xrd and dsc. the effects of bath compositions and deposition conditions on the structure and properties of ni - w - b alloy and ni - w - b - ptfe composite coatings were explored

    本文主要以ni - w - b合金為研究對象，運用循環伏安方法研究二甲基胺硼烷在ni - w - b合金電沉積過程中的作用、階躍電位研究ni - w合金和ni - w - b合金電結晶機理、 xrd和dsc方法研究ni - w合金和ni - w - b合金電沉積層的結構以及合金在熱處理過程中的結構變化。
  11. Liu zhuang, wu zhaoji, wu jingzhi, et al. numerical simulation of heat treatment processing [ m ]

    劉莊，吳肇基，吳景之等.熱處理過程的數值模擬[ m ] .北京：科學出版社， 1996
  12. Current researches, applications, preparation and structure of si3n4 are summarized in this paper. a new conclusion is drawn that silicon wafer can react with nitrogen at the temperature higher than 1100 and in super - pure nitrogen by direct - nitridation of silicon at the temperature from 800 to 1200. the prepared silicon nitride samples are tested by xps ( x - ray photoelectron spectroscopy ), sem ( scanning electron microscopy ), optical microscopy, xrd ( x - ray diffraction ) and edx ( energy dispersive x - ray analysis )

    通過矽片在800到1200各個溫度和各種氮氣氣氛下的氮化處理的實驗結果，報道了不同與其他研究者的氮化條件，矽片在氮氣保護的熱處理中的氮化條件為：高於1100的溫度和高純氮的氣氛條件，同時對該氮化硅薄膜進行了金相顯微鏡、掃描電鏡（ sem ） 、 x射線衍射儀（ xrd ） 、 x射線光電子譜（ xps ） 、 x射線能譜儀（ edx ）和抗氧化性等測試和分析。
  13. ( 3 ) according to the study of heat treatment process, heat treatment ambience, airflow and heat treatment temperature were considerd as the important influences on the quality and property of ybco films. through optimizing the process, the ybco films were prepared on sto single crystal, and their room temperature resistance was about 200 ybco films also were fabricated on the sto buffered si substrate, and their room temperature resistance was about 300d

    （ 3 ）根據本文熱處理過程的工藝探索，認為熱處理氣氛、氣流量及處理溫度是影響薄膜質量及性能的重要因素，通過優化工藝過程，在鈦酸鍶（ sto ）單晶上制得的ybco薄膜表面質量良好，室溫電阻200左右；而在預制了鈦酸鍶（ sto ）緩沖層的si基板上制備的ybco薄膜的室溫電阻為300左右。
  14. Chlorine behavior and dechlorination characteristics of polyvinyl chloride in thermal process

    聚氯乙稀在熱處理過程中氯釋放特性的研究
  15. We studied the effect of laser quenching ( harden by phase transformation ) on some representative mould steels. through measuring the rigidity on the surface of samples treated by laser heat treatment, and through photographing microstructures of the steel surface, we find many reasons attribute to high hardness. these reasons include ultra - fine grains, high density dislocation and more content of carbon in martensite

    我們研究的是激光淬火對幾種典型模具鋼的作用，通過對熱處理后的試樣的硬度分佈的測定，用金相和電鏡觀察金相組織的變化，認為激光熱處理產生高硬度的原因是晶粒細化、高的位錯密度和高的馬氏體含量。
  16. Secondly, the character of carbon and the effect of carbon on the oxygen deposition in annealing are studied

    其次，研究了太陽電池用矽片中碳的熱行為以及熱處理過程中碳對矽片中氧沉澱和少子壽命的影響。
  17. The results show that the chemical composition of substrate surface and the heat - treatment regime are the major influencing factors on the formation of silver nanoparticles. during the heat - treatment, sn2 + in the bottom face of the float glasses reduce ag + to ag ? which is the key to form silver nanoparticles

    結果表明，在樣品的熱處理過程中，浮法玻璃下表面的sn ~ （ 2 + ）將ag ~ +還原成ag ~ 0 ，這是銀粒子形成的關鍵；基片中的na ~ +與復合膜中的ag ~ +互擴散促進了銀納米子的形成。
  18. A long nut is positioned in the slotted full - tang ; a hardened bolt is passed through the butt - cap and then threaded into the nut drawing the handle assembly together for a solid fit

    一個長螺母位於整個根部的槽中，一個熱處理過的螺栓貫通了整個粗大的尾冒並且穿過螺母和手柄裝配在一起，從面得到一個堅固的安裝。
  19. The contrast experiment of chemistry reducing process and hydrothermal treatment were studied. the results showed that the crystallinity of copper powders prepared by hydrothermal method clearly increased, and the grain size distribution became narrow comparing with the copper powder prepared by reducing process

    通過化學還原法與水熱法制備銅粉的初步對比試驗，證明水熱處理過的銅粉粒度分佈變窄，結晶度提高，從而具備了還原法所不能比擬的優良性能。
  20. The results showed that the high - speed shear treatment could enhance the solubility of asp, the aggregates of asp solution modified by high - speed shear or heat treatment increased with the temperature rising, while acid and alkali treatment were the opposite

    實驗結果表明，高速剪切處理能提高醇變性大豆蛋白的溶解性；高速剪切和加熱處理過的醇變性大豆蛋白溶解時，隨著溫度的升高溶出的聚集體會增多，而酸和堿處理后的情況則相反。
分享友人
分享到 Line

分享到臉書