熱電偶結 的英文怎麼說

中文拼音 [rèdiànǒujiē]
熱電偶結 英文
thermal junction
  • 電 : Ⅰ名詞1 （有電荷存在和電荷變化的現象） electricity 2 （電報） telegram; cable Ⅱ動詞1 （觸電） give...
  • 結 : 結動詞（長出果實或種子） bear （fruit）; form （seed）
  1. We select ni / cr alloy resistor as element together with ceramic embedding hearth ; select small flat - and - disc heat - even hubby ceramic sample holder, select ni / cr & ni / si thermoelectric couple ( type k ) as thermoscope with threads 0. 5 mm in diameter which is installed in the middle of the holders symmetrically ; select aluminum silicate fire - retardant fiber as materials for heat preservation ; design some hardware, for example temperature controller & transporter, signal amplifier etc ; design controlling curve to heat stove ; and introduce the method of least squares nonlinear regression and subsection function to deal with data. in order to obtain the reasonable operation conditions and operation curve, we have also done many theory analysis and experiment discussions

    通過理論和試驗探討，選用鎳鉻合金電阻絲作為加熱元件，配以陶瓷質埋入式爐膛；選用陶瓷質小尺寸扁平?圓盤均熱塊體型樣品支持器；選用0 . 5mm絲徑鎳鉻?鎳硅熱電偶（ k ）作為測溫元件；熱電偶對稱安置在樣品支持器容器的中部；選用硅酸鋁耐火纖維作保溫材料；合理選用和設計了溫度控制器、溫度變送器、信號放大電路等硬體；採用升溫曲線來控制爐膛供熱過程；採用最小二乘法非線性回歸與分段函數相結合的曲線模擬方法，進行圖形處理。
  2. After the temperature measurement system is scaled by the black body furnace, we use least square method and neural network to calculate the temperature respectively according to the images taken from both the black body furnace and the common coal furnace. through comparison the calculation data with the result of thermocouple, an improved method of neural network is proposed. this method is more practical and precise

    根據標定結果，本文用最小二乘和神經網路兩種方法分別對黑體爐和普通煤爐的圖像進行了溫度計算；通過比較熱電偶輸出的溫度值和計算的結果，提出了一種改進的神經網路方法，該方法更適用於工程實際，其測溫精度較高。
  3. In the framework of the transverse ising model ( tim ), landau phase transition theory and the electrostatic field theory, we study the physical properties of the ferroelectric thin film, bilayer, sandwich structure, multilayer with a non - polarization slab and a two - dimension polar lattice model with polar defects. the main work and results are as follows : first, the long - range interaction in ferroelectric material is sometimes neglected in the previous studies. we introduce the long - range interaction in the framework of the tim and the landau theory

    本文在橫場伊辛模型、朗道相變理論以及靜電場等理論的框架內，對鐵電薄膜、鐵電雙層膜、鐵電三明治結構以及含有雜質層的鐵電多層膜和含有偶極缺陷的二維偶極點陣系統等多層鐵電系統的相變、熱電、介電、電滯行為等物理性質進行了深入研究。
  4. A device of measuring the crystallization temperature of mold slag based on single thermocouple wire was introdued

    筆者以保護渣結晶溫度為出發點，提出了一種將雙鉑銠熱電偶絲既作為加熱元件，又作測溫元件的熱絲法技術。
  5. It utilizes the thermoelectric couple and thermal imaging system for the first time to monitor the internal heat conduction of the decoration for the buildings, and the uses the thermal imaging system and thermoelectric couple of copper constantan to follow up the monitoring to the surface temperature of the tiles and the temperatures in many

    論文中首次利用熱電偶及熱像儀對飾面墻體的內部熱傳導過程進行了監測，利用熱像儀及銅-康銅熱電偶對面磚表面溫度及砂漿內部各層多點溫度進行了跟蹤監測，結果表明面磚表面溫度及砂漿內部各層溫度變化趨勢基本一致，而且從熱像儀測出的面磚表面溫度值與由熱電偶測出的面磚表面溫度值基本相同。
  6. In this paper the development and status in quo about temperature measuring technologies and instruments for temperature measurement are fist summarized, and the characteristics and localizations of the current hardware - based instrument for temperature measurement are also pointed out ; and then we take the thermocouple and thermo - resistance instrument for temperature measurement as the example to analyze the most representative temperature measurement and the principle of instrument, including the temperature measuring mechanism, physical structure and notices ; an advanced manufacture technology of instrument - - - virtual instrument technology and the virtual instrument based on which are introduced in succession. this paper also narrates at length the origin, characteristics and system structure. the virtual instrument and hardware - based instrument are contrasted, which stands out the superiority of virtual instrument ; finally we combine virtual instrument and the technology of temperature measurement, which comes into being the virtual multi - channel instrument for temperature measurement debated in detail in this paper

    本文首先概述了常用的溫度測試技術和溫度測試儀器的發展與現狀，指出了當前硬體化溫度測試儀器的特點和局限性；然後以熱電阻測溫儀和熱電偶測溫儀為代表分析了最具代表性的溫度測試與儀器的原理，其中包括它們的測溫機理、物理結構和注意事項；接著介紹了一種先進的儀器製造技術? ?虛擬儀器技術以及在此基礎上形成的虛擬儀器，對虛擬儀器的產生、特點、系統結構做了較詳細的介紹並和傳統硬體化儀器做了對比，突出了虛擬儀器的優越性；最後把虛擬儀器和溫度測試技術相結合，形成了本文著重介紹的虛擬式多通道溫度測試儀。
  7. Thermocouple and thermal resistance in power station suit to measure temperature of electric generator groups and auxiliary machine correspond to 300000 and 600000 kilowatt, which can substitute one from import with many advantages as shock - proof, pressure - resistant, long in service, and convenience in maintain etc. the protective tube is processed in a special construction by deep - blind hole technology whose end not be welded to enhance the strength and prolong service life. thermocouple or thermal resistance

    本公司生產的電站專用熱電偶阻，適用於我國30萬60萬千瓦等發電機組及輔機的測溫需要，產品安全可替代進口，具有防震耐壓使用壽命長，維修方便，保護管是採用深盲孔技術加工而成，端部不用焊接，提高了保護管的強度和使用壽命，鎧裝熱電偶熱電阻採用彈簧壓著式結構，在運行中保護管與鎧裝熱電偶熱電阻測量端始終保持著良好的接觸，抗震動，減少熱響應時間，鎧裝熱電偶測量端採用絕緣形式，能防止電磁干憂。
  8. ( 1 ) a pair of heat transfer disks were designed for the experiment, thermal couple and thermal imaging vedio were applied to test the disks, the results indicated that the designed disks could be used in the experiment

    （ 1 ）設計了用於換熱實驗的換熱盤，並應用熱電偶和熱成像儀對換熱盤進行了測試驗證，結果表明設計的換熱盤符合實驗要求。
  9. Another requirement will be that all machines being tested to thermal limits above 120degree have its resistance checked immediately after testing is complete in order to check the machines internal thermocouples

    為了檢測設備內熱電偶，還有一個要求，即實驗時熱限界達到120度以上的所有設備在實驗結束時都要立刻對其電阻進行檢測。
  10. En 1434 - 2 heat meters. part 2 : constructional requirements

    熱電偶.第2部分:結構要求
  11. Wear - proof body is manufactured from bar stock of high temperature alloy. double - compound structure of wear - proof coated with double wear - proof layer prolongs service life

    耐磨頭本體採用耐高溫合金鋼棒料整體鉆孔，外噴焊雙層耐磨層，形成雙重復合結構，延長耐磨熱電偶的使用壽命。
  12. 0 - gwfl high temperature hearth thermocouple which outer protective tube made up high temperature metal, the max temperature can arrive at 1300. hearth thermocouple usually use k type with a wide range of temperature from - 270 to 1370

    H - wrk - 4g0 - gwfl高溫爐膛熱電偶，外套管採用高溫金屬測溫保護套管，最高溫度達到1300 ，熱電偶分度號採用k型，測量范圍270 1370 ，上接保護管部分採用隔漏結構。
  13. The first phase is the period from the furnace ' s order notification to the first time of measuring temperature with thermocouple, the conventional method of statistical analysis - - regression analytical method for forecasting molten steel, was used

    第一階段是爐次通報至第一次用熱電偶測溫，採用傳統的統計分析方法? ?回歸分析法預報鋼水溫度。第二階段是熱電偶第一次測溫至出鋼結束。
  14. The relative intensity method is adjusted to deal with this case. the measurement of the temperature distribution based on this improved method is successful, and the measurement results are compared with the results of the thermocouple method

    並將sq - 2推進劑的結果和熱電偶以及化學平衡計算的結果進行了比較，結果表明譜線法測量不但有很好的精度，而且能在一些熱電偶無法測量的情況下得到好的結果。
  15. Experiments on the measurement of temperature with thermocouple in alternating electromagnetic field are conducted. the effects of factors on the measurement result are studied, such as position, integral time, environment temperature, power supply, heating power and encapsulation mode of thermocouple. effective measures are obtained to decrease the negative effect of alternating magnetic field, which ensure that accurate measurement will be acquired in the following experiments

    本文對交變磁場中熱電偶測溫的問題進行了試驗研究，獲得了熱電偶所處位置、積分時間、環境溫度、供電方式、加熱功率和熱電偶的封裝方式等因素對測量結果的影響規律；並提出了減小交變磁場影響的措施，為在即將進行的試驗研究中獲得可靠的數據奠定了基礎。
  16. According to numerous experiments of eih for air, the transient magnetic field has exerted certain influence on the thermocouple measurement. it is concluded in this thesis that the influence can be reduced or neglected with appropriate measuring parameters, which are fundamenta

    本文進行了電磁感應空氣加熱試驗，研究了交變磁場對熱電偶測溫的影響規律，得出只要採用適當的測量參數，就可以將其影響減少甚至忽略的結論，為以後試驗中的溫度測量打下基礎。
  17. Considering that now the consumptive thermocouple measurement method is widespread in the world, and the technique is comparative mature. so the thermocouple technique has very high reference value to our system, and accordingly, in this text, we give an example of thermocouple to make a contrast with the consumptive optical fiber radiation thermometer

    鑒于目前普遍採用的熱電偶測量鋼水的溫度，在技術上比較成熟，對本系統有很大的參考作用，故本文也給出了一例熱電偶測溫的實例，與本系統作了對比，其對比的結果在文中給出。
  18. It is proved by the simulation that the temperature of samples can be estimated from the thermo - couple placed on the cover glass and the planar temperature distribution of the cryostage is approximately uniform

    分析結果表明：可以利用布置在蓋玻片上表面的熱電偶測量並推算實驗樣品層的溫度；低溫臺載物表面溫度均勻。
  19. 4, mix room an adoption to clip a set of structure, can water cool off or the steam heat, hot conduct effective, mix room bottom to have to measure thermocouple, can carry on a temperature control, whether the low temperature mix a or a heating to mix or not, all can get satisfied result

    4混煉室採用夾套結構，可通水冷卻或蒸汽加熱，熱傳導效果好，混煉室底部裝有測溫熱電偶，可進行溫度控制，無論低溫混煉還是加熱混煉，均可得到滿意的效果。
  20. Input. determine inputs, such as thermocouple signals, timer, or analytical test results

    輸入。確定輸入，比如熱電偶信號，定時器，或分析測試結果。
分享友人
分享到 Line

分享到臉書