熱面點火溫度 的英文怎麼說

中文拼音 [rèmiàndiǎnhuǒwēndù]
熱面點火溫度 英文
hot surface ignition temperature
  • 面 : Ⅰ名詞1 （頭的前部; 臉） face 2 （物體的表面） surface; top 3 （外露的一層或正面） outside; the ri...
  • 點 : Ⅰ名詞1 （液體的小滴） drop （of liquid） 2 （細小的痕跡） spot; dot; speck 3 （漢字的筆畫「、」）...
  • 火 : fire
  • 溫 : Ⅰ形容詞（不冷不熱） warm; lukewarm; hot; gentle; mild Ⅱ名詞1 （溫度） temperature 2 （瘟） acute ...
  • 度 : 度動詞[書面語] （推測; 估計） surmise; estimate
  • 點火 : 1 （挑起是非） stir up trouble 2 （點燃; 打火） ignite; light the fire; fire up; strike a light; ...
  • 溫度 : [物理學] temperature
  1. Aimed at tube curve by sun shining, it analyzes and calculates the instance of curve when tube up and down face have difference in temperature, and discourses upon it influenced degree to cannon firing accuracy. for hot spread asymmetry caused tube curve, it explains it ' s form cause. for irregularly hot stress acting tube curve, it stressfully analyzes effect of body tube wall thickness difference

    重點分析了身管熱彎曲產生機理，針對太陽照射下的身管彎曲，分析計算了身管上下表面存在溫度差時的彎曲情況，論述了其對火炮射擊精度的影響程度；對于散熱不均引起的身管彎曲說明了其形成原因；對于不規則熱應力作用下的身管彎曲重點分析了身管壁厚差的作用。
  2. This paper aims at the characteristics of thermal response of lpg vesse1 under high temperatue, conjoining the project of " study on transportation safety early - wdring system of lpg dangerous goods " supported by transportation departinen of china and the project of " mechanism study and numerical simulation of the explosion of lpg vessel " supported by science foundation of hubei province. the interdisciplinary research has been done among temperature field distribution of lpg vessel under flame surroundings, intensity calculation, crack propagation predication and mechanism of explosive accident, etc. three parts are analyzed and discussed

    本文針對高溫環境下液化氣壓力容器的熱響應特性問題，結合交通部重點科技項目「液化氣體類危險品運輸安全預警系統的研究」和湖北省自然科學基金項目「液化氣容器爆炸機理研究及數值模擬」 ，對在火焰包圍下的液化氣壓力容器的溫度場分佈、強度計算、裂紋擴展預測以及爆炸事故機理等方面開展了多學科的交叉研究。
  3. Test results show that the ignition process of pc in ignition chamber includes three stages. the effects of velocity, pc concentration and wall temperature on the ignition of pc are studied

    試驗結果證實煤粉氣流在感應加熱點火室內的著火過程分為三個階段，揭示了煤粉入口速度、煤粉濃度、點火室壁面溫度對煤粉氣流著火的影響規律。
  4. It is discovered that the combustion condition of the second stage pc is up to the outlet temperature of the first stage pc and the content of combustible gases in first stage flue also plays positive effect on the ignition of second stage pc. the effects of parameters of two coal - air mixture, wall temperature of first ignition chamber and annular filling air on imfit are studied experimentally in this thesis. in this thesis, the numerical simulations of ignition and combustion of pc in imfit are conducted

    本文通過建立數學模型，對感應加熱煤粉多級無油點火進行數值模擬，研究了一級煤粉煤粉在點火室內的著火過程和二級點燃過程、煤粉粒徑分佈對煤粉多級無油點火的影響，研究了一級點火室壁面溫度、一級煤粉氣流和二級煤粉氣流的風粉參數在煤粉多級無油點火過程中的影響規律；根據二級點燃段的流場和溫度場分佈，研究了環形夾心風推遲二級煤粉著火的機理。
  5. The ideology and experience regarding design of large capacity w flame units in foreign countries should be further acknowledged, this can be an example for us to draw a more reasonable rules and methods of calculation. in this thesis, the systematic numerical simulations were conducted for w flame boiler furnace

    針對邯峰電廠的660mw機組w型火焰鍋爐的特點，編制和完善了爐內熱態流動及燃燒模擬程序，並進行了全面的爐內過程數值計算，得到了鍋爐爐膛內的溫度分佈和速度分佈，對鍋爐性能進行了預報。
  6. The model can be made into difference equation of the temperature field that can be used to simulate calculation ; then we can get the set of edge point, and we can have the function of the fire line, and we can also have the burned area, the length of fire line and the space of fire area ; it also come to the conclusion that the main factor of forest fire is convection heat transfer

    經差分處理，得到進行模擬計算的一組溫度場計算方程；由邊界點條件，求出邊界點的集合后，擬合得出火線函數，積分后可得到時刻火場的過火總面積、火線長度和火場形狀，同時進一步證實了對流傳熱方式是影響林火蔓延的主要因素。
  7. In this article, analysis is made on some problems which must be faced when plasma ignition technology is applied in 600mw unit boiler to achieve a power plant without oil, such as plasma burner disposal, the number of plasma burner, the boiler ignition coursing satisfy the temperature needs, pulverized coal origin, hot air origin, and reconstruction solutions are proposed

    本文詳細分析了某廠2 600mw機組鍋爐採用等離子點火技術實現無燃油電廠所面臨的等離子燃燒器的布置、等離子燃燒器層數的選擇、鍋爐點火啟動滿足升溫速度的要求、煤粉的來源、熱風的來源等問題，並提出了相應的解決方案。
  8. Micro - bore calcium silicate without rock cotton is a white, hard new thermal insulation material which has the features of light unit weight, high hardness, low heat conduction coefficient, heat resisting, corrosion - proofed, cuttable and sawable, and widely used in the pipeline of electric, metallurgy, petrochemistry, architecture and shipbuilding industry, and heat resisting, fireproofed and soundproofed equipment of the house wall

    無石棉微孔硅酸鈣是一種白色、硬質的新型保溫材料，具有容重輕、強度高、導熱系數小、耐高溫、耐腐蝕、能切、能鋸等特點被廣泛應用於電力、冶金、石化、建築、船舶等領域的設備管道、墻體屋面的保溫隔熱和防火隔音。
  9. Fireproof board of magnesium oxychloride has been attracted much attention and become the main part in the fields of inorganic building boards because of its attractive properties such as good fireproof property, mechanical strength, sound insulation, shake resistance, heat preservation and so on. but it also has its own defects of dehylogenation, deformation and poor waterproof, which limit its use and decoration

    氯氧鎂無機防火板以其輕質、高強、粘接性、韌性、隔音、抗震、保溫、隔熱、防火、防潮、防腐蝕、耐酸堿、防蛀、環保性能好、施工安裝方便、施工勞動強度低、快捷、價格低廉等特點，而得到人們的廣泛重視，成為國內目前市面上應用最為廣泛的無機防火板材之一。
  10. The configuration and microstructure of production, the effect of heating temperature and chemistry match ratio on reaction and production, the effect of calcining temperature and time on the changes of production crystal were studied by xrd, tem, dta and microscope

    本文通過xrd 、 tem 、差熱分析、金相顯微鏡等手段對所制備材料的結構、組織形貌、點火溫度和化學配比對反應現象和反應產物的影響、煅燒溫度和煅燒時間對產物晶型轉變的影響等方面進行了分析研究。
分享友人
分享到 Line

分享到臉書