熱風速表 的英文怎麼說
中文拼音 [rèfēngsùbiǎo]
熱風速表
英文
thermoanemometer- 風 : Ⅰ名詞1 (空氣流動) wind 2 (風氣; 風俗) practice; atmosphere; custom 3 (景象) scene; view 4 ...
- 速 : Ⅰ形容詞(迅速; 快) fast; rapid; quick; speedy Ⅱ名詞1 (速度) speed; velocity 2 (姓氏) a surna...
- 表 : Ⅰ名詞1 (外面;外表) outside; surface; external 2 (中表親戚) the relationship between the child...
- 風速 : [氣象學] wind [air] speed; wind [air] velocity
-
The physical models for those sound synthesis methods can exactly describe musical instruments ' s fundamental and harmonious and inharmonious frequencyies, as well as their nautral sounding process. they can be played like real musical instruments, representing players ' s strength, velocity and pattern, as well as emotion. so, the methods are playing very important roles within the sound synthesis domain currently, with mpeg4 published and improvement of computer ' s computational efficiency
由於它可以精確地描述物體的發聲及其發聲過程,精確地再現樂器的基波、高次諧波、非諧波以及asdr過程,象真實樂器一樣可以表達演奏者的演奏力度、速度、風格和情感,隨著計算機處理速度的提高,尤其是mpeg4技術的公布,這種方法日趨活躍,成為目前樂器模擬、聲音合成的研究熱點。It shows that the injection quantity and the difference of temperature distribute as a parabola which is at the same load, and the minimum of the parabola corresponds to the optimum quantity of injection ( g ). under the condition that the quantity of injected mass, the air speed and the heat quantity is respectively g, v and q, the research demonstrates that the pentium iv chip ' s temperature variation can be controlled under 40c and work normally when the wind speed overpass 1. 5m / s and the power dissipation of the chip is 60w. otherwise this paper calculates the flooding limit of thermosiphon with several different methods
對其充灌量、散熱量、電子元件( cpu模擬晶元)表面與環境溫度之差及通風、流速的影響進行了系統的測試,發現充液量與溫差的關系在負荷不變時呈拋物線分佈,其極小值點對應的充液量是最佳充液量g 。在充液量為g時,對風速v 、散熱量q進行的研究表明,當風速超過1 . 5m / s后,奔騰晶元在60w發熱條件下晶元溫度小於40 ,能滿足長期正常工作。Results show that the influence of mainstream reynolds numbers on heat transfer coefficience is little and the heat transfer coefficience raise with the increase of reynolds numbers. the influence of the position of holes on heat transfer coefficience is complex and correlate with the mainstream speed and the balde surface curvature. and the influence of blowing ratio on heat transfer coefficience is more great ( especially to stator ), and show a complex relation to mainstream reynolds number and the position of holes
實驗結果表明,不同孔位出流的換熱由於孔排下游表面來流速度及葉片表面曲率的不同而有不同的規律,而主流雷諾數對葉片表面特別是壓力面和前緣區域的換熱系數比的影響較小,吹風比對換熱系數影響較大(特別是導葉) ,並且隨氣膜孔位置和來流雷諾數的變化而情況復雜。The tests were conducted in the hypersonic low density wind tunnel at nominal test conditions of mach 16, stagnation temperature 923k, stagnation pressure 1. 40mpa and 7. 30mpa. heat - transfer data were obtained on a hemisphere model, a sharp cone and a big blunt cone respectively by means of infrared thermal mapping techniques, that of a 0. 5mm thickness blunt cone by virtues of thermocouples. furth ermore, heat - transfer on all those models was calculated with the theoretical method
最後在名義m _ = 16 、 t _ 0 = 923k 、 p _ 0 = 1 . 40mpa及7 . 30mpa的高超聲速低密度風洞中,利用紅外熱圖技術獲得了半球圓柱、尖錐、大鈍頭三個模型表面熱流分佈,利用薄壁法技術得到了一壁厚為0 . 5mm的鈍錐模型表面的熱流分佈,並通過工程理論方法計算了模型表面的氣動熱,把理論計算結果與上述試驗結果比較,幾者符合得較好。Results showed that moisture content was mostly removed during sublimation period of freeze - drying, while rapidly dropped during earlier period of air - drying and gradually decreased during vacuum belt drying
結果表明:真空冷凍乾燥物料中的大部分水分在升華階段去除,熱風乾燥初期水分含量迅速下降,真空帶式乾燥物料水分隨時間延長呈比較均勻的下降。( 3 ) for parameterization of the sensible heat, the positively correlation between surface temperature and bulk transfer coefficient lead to a positive additional sub - scale flux. its magnitude is determined by the grid average roughness and average wind velocity on the reference level
( 3 )對區域感熱通量的計算而言,由於地表溫度和整體輸送系數產生一個正的次網格通量項,它主要由網格平均粗糙度和參考高度平均風速所決定。Information on the nearest approach together with an estimate of the minimum central pressure of each tropical cyclone during its closest approach, the maximum winds at king s park and chek lap kok and waglan island, the minimum mean sea - level pressure recorded at the hong kong observatory and the maximum storm surge ( the excess of the actual water level over that predicted in the tide tables ) recorded at various tide stations in hong kong are included
資料包括熱帶氣旋最接近香港時的位置及時間和當時估計熱帶氣旋中心附近的最低氣壓、京士柏及赤?角及橫瀾島錄得的最高風速、香港天文臺錄得的最低平均海平面氣壓以及香港各潮汐測量站錄得的最大風暴潮(即實際水位高出潮汐表中預計的部分) 。Information on the nearest approach together with an estimate of the minimum central pressure of each tropical cyclone during its closest approach, the maximum winds at king s park and waglan island, the minimum mean sea - level pressure recorded at the hong kong observatory and the maximum storm surge the excess, in metres, of the actual water level over that predicted in the tide tables recorded at various tide stations in hong kong are included
資料包括熱帶氣旋最接近香港時的位置及時間和當時估計熱帶氣旋中心附近的最低氣壓京士柏及橫瀾島錄得的最高風速香港天文臺錄得的最低平均海平面氣壓以及香港各潮汐測量站錄得的最大風暴潮即實際水位高出潮汐表中預計的部分,單位為米。In equatorial region, the mean air - sea humidity difference is much smaller, so the variations of air - sea humidity difference under large mean wind speed dominate the variations of latent heat flux. the ocean release the most heat during the period from march to may, when sst is highest in the whole year because sst dominates the variation of air - sea humidity difference
在赤道冷舌區,平均的背景海氣濕度差比較小,所以平均風速背景下的海氣濕度差的熱帶大西洋海表潛熱和感熱通量的季節和年際變化研究變化主導該區的潛熱通量的變化。The evaporation section and the condensation section of the heat pipes can ben changed as the temperature of the outdoor air varies. so the heat pipe can be operated through the whole year. after analyzing the characteristics of energy recovery in air - conditioning system, associating heat feature of air - conditioning system with running environment
分析了空調系統排風能量回收的特點后,作者結合空調系統運行環境,建立了該傳熱裝置的數學模型,結果表明:熱虹吸管的傾斜角、充液率、管長和迎面風速對熱虹吸管的傳熱都有重要影響。The results indicate that the critical ventilation speed is direct ratio to the heat release rate and reverse ratio to the height of the smoke barrier which lies in the stairs ' access between platform and concourse
研究表明:臨界通風速度與火災熱釋放速率成正比,與站臺和站廳間樓梯口處的檔煙垂壁高度成反比。According to the working condition of electronic element, a testing system established to test the temperature variety of the electronic element surface on several kinds of radiator which designed on different structure under different working condition. on the basic of the experimental results, integrated theoretical model established which include three part : heat simulation copper block, two - phase closed thermosyphon and heat sink
根據電子器件的運行工況,建立了散熱器性能測試系統,並對所設計的不同型式的熱管型電子器件散熱器進行了在不同工況下的性能實驗,比較了在熱流密度、風速、風溫等實驗工況發生改變的情況下各型式的熱管型電子器件散熱器中電子器件表面溫度的變化規律。This unit utilizes a unique spray nozzle and a high - speed rotary plate ( centrifugal model ) to granulate fluid ( starchy materials ), and sprays hot air to instantly dry the granules as their surface areas are being increased
利用特殊噴嘴或者是高速旋轉圓盤(離心式)將漿料球粒化,並再它表面積增大時,施以連續熱風,使其與熱風接觸后瞬間乾燥。As a main product of our company, spraying drying set is a kind of centrifugal or pressurized, which atomizes liquid materials such as solution, suspension, emulsion or paste into timy droplet ( surface area increased ) and dry them into powder product an once ( several to dozens of seconds ) by contacying hot air
噴霧乾燥機組是一種用離心式或壓力式霧化器,將溶液、懸浮液,乳濁液或漿料等料液霧化成細微液滴(表面積顯著增大) ,經與熱風接觸得以急速乾燥(幾秒到幾十秒) ,從而直接得到粉末產品的裝置。The simulation results indicated that the air flow, airside pressure drop, water flow and flux of heat exchange in water side decreased with the increase of frosting time, and the airside pressure increased
模擬結果表明,隨著結霜量的增加,空氣側換熱器的換熱量減小,風量也將逐漸減小,而阻力卻迅速增加;水側換熱器的換熱量減小,水流量也減小。Built up numerical simulation model of ufad system with single heat and pollutant source, adopted fluent software to study distribution of temperature 、 velocity and contamination ’ concentration, and changes of heat lamination height when temperature and velocity of air - in and surface temperature of heat source were changed and when the leakage of air - in plenum was considered or not. and compared and verified the simulation results with experimental testing data
建立了單一熱污染源地板送風的數值模擬模型,採用fluent軟體研究送風溫度、送風速度、熱源表面溫度的變化及有無考慮送風靜壓層的漏風時,室內溫度、速度和污染物濃度分佈以及熱力分層高度的變化,並與實測分析進行了對比驗證。Film cooling of the surface of a gas turbine blade was studied in a large - scale low - speed opening wind tunnel according to actual requirement of the design of aero - engine. the surface of a gas turbine blade was cooled by cylindrical holes in the experiment, with the hole number of fifteen in stator and eight in rotor
應航空發動機設計的要求,在大尺寸低速葉柵傳熱風洞中分別對發動機渦輪導向葉片和動葉表面的氣膜冷卻特性進行了研究,具體研究在不同氣膜孔出流時,在不同主流雷諾數和吹風比情況下葉片表面局部換熱系數的分佈規律。The intensity is given in terms of the maximum sustained wind speed near the centre of a tropical cyclone
強度以接近熱帶氣旋中心的最高持續風速來表達。E. in addition, information on the intensity of tropical cyclone in terms of the maximum sustained wind speed near its centre will also be provided
此外,亦會提供接近熱帶氣旋中心的最高持續風速以表達熱帶氣旋的強度。分享友人