燃油傳感器 的英文怎麼說

中文拼音 [rányóuzhuàngǎn]
燃油傳感器 英文
fuel sensor
  • : 動詞1. (燃燒) burn 2. (引火點著) ignite; light
  • : Ⅰ名詞1 (脂肪; 油脂) oil; fat; grease 2 (姓氏) a surname Ⅱ動詞1 (用桐油、油漆等塗抹) apply t...
  • : 傳名詞1 (解釋經文的著作) commentaries on classics 2 (傳記) biography 3 (敘述歷史故事的作品)...
  • : Ⅰ動詞1 (覺得) feel; sense 2 (懷有謝意) be grateful; be obliged; appreciate 3 (感動) move; t...
  • : 名詞1. (器具) implement; utensil; ware 2. (器官) organ 3. (度量; 才能) capacity; talent 4. (姓氏) a surname
  • 燃油 : fuel oil燃油艙 [船舶工程] oil bunker; oil fuel tank; 燃油閥 fuel valve; 燃油鍋爐 oil burning boil...
  1. This paper discusses the designing and making of the dynamic testing systems of engine electronic control system. base on the construction and operation principle of santana 2000gsi m3. 8. 2 engine electronic control systems, design and manufacture led circuit of dynamic testing and fault imitating electronic control unit. on the inspect board, design and equip with motronic 3. 8. 2 ecu i / o measuring joints, design and set up obd - ii diagnostic communication link, design and install fuel pressure inspecting meter. depend on the obd - ii diagnostic communication link and ecu i / o measuring joints, this dynamic testing system can inspect engine electronic fuel injection system, distributorless ignition system, idle speed control system and evaporative emission control system, and can inspect m3. 8. 2 sensors, ecu and actuators, and can interrogate fault memory and erase fault memory ; and can analyse data stream ; and can carry out fault imitating. besides, this paper analyses sensors and actuators typical fault w aves

    2電控單元電路連接設計製成輸入輸出電子控制檢測端子,並在檢測面板上布置了obd -診斷插座和壓力表。使該動態測試系統能實現對電噴發動機的系統、直接點火系統、怠速控制系統和蒸氣排放控制系統的動態檢測;並通過obd -診斷座、 ecu輸入輸出檢測端子和故障模擬處理單元實現對電噴發動機電控系統各、電控單元、執行進行故障碼讀取與清除;動態數據讀取和波形測試和故障模擬等。此外,本論文還分析了和執行典型故障波形。
  2. This thesis described fuel management system theory and system reliability design to set forth system fuel management general design thought. many technical details are discussed in the thesis such as : fuel quantity measurement, fuel mass character calculation, fuel density measurement, the accuracy of fuel quantity measurement, the optimum location of fuel gauge probes in the fuel tank. the author brings forward a new method which is based on the software of catia to calculate fuel mass character

    本文對管理系統的工作原理和可靠性設計等問題進行研究,以明晰管理系統的總體設計思路;並對數字式量測量、質量特性計算、密度測量、提高量測量精度的措施、安裝位置優化等具體技術展開研究;提出了一種基於catia軟體的質量特性計算方法;論文最後探討了管理系統的未來發展方向。
  3. Modbus transducer is the key device in the system and is used to offer power supply of pressure and temperature sensor, to collect signal, to linearizate and compensate temperature, to calculate density, volume and mass, to transmit data to modbus network, and display the data. so the modbus transducer is a multi - parament measurement, intelligent control device which can manage multi - signal

    變送是系統的核心設備,其作用是為罐溫度、壓力、液位、可氣濃度等供電,採集信號並進行線性化、溫度補償等處理,完成密度、體積和質量等參數計算,將數據輸出到modbus現場總線測控網路,根據需要現場顯示計測量參數。
  4. General motors electronic fuel-control system includes an exhaust-gas oxygen senor or sniffer.

    通用汽車公司的電子控制系統,包括廢氣氧或嗅探
  5. Siemens vdo serves in the local china market covering the products of ems ( engine management system ), diesel system, tcu ( transmission control unit ), fuel rail, injector, sensor, fuel supply system, engine actuator, acu ( airbag control unit ), bcm ( carbody control module ), window lift motor, engine cooling module, abs motor, rke, instrument panel, audio system ( radio / cassette / cd ), navigation system, vdr ( commercial vehicle data recorder ), etc

    在中國市場上,西門子威迪歐汽車電子中國的產品系列包括ems (發動機電噴管理系統) 、柴機系統、發動機執行、 tcu (自動變速箱控制單元) 、軌、噴嘴、泵、 acu (安全氣囊控制單元) 、 bcm (車身控制模塊) 、搖窗電機、發動機冷卻模塊、 abs電機、駕駛臺儀表、音響、導航和vdr (商用車行車記錄儀)等。
  6. The air - fuel ratio closed loop control adjusts the air - fuel ratio near the theoretical value by controlling the supplementary air of supplementary valve based on the signals of oxygen sensor, running speed and water temperature and which is necessary condition for three - way catalyst converter to work more efficiently

    比閉環控制是根據氧、轉速和水溫信號,控制化后補氣閥補氣將空比控制在理論值附近,為三元催化轉換高效工作準備必要條件,使其最大限度降低尾氣排放。
  7. Analysis of common failures occurred in engines with electronically controlled fuel injection system is carried out from six aspects : ecu, sensor, acuator, connection, air and fuel lines, as well as air and fuel filters

    從ecu常見故障,故障,執行故障,插接件(或連接導線)連接故障,連接管道松脫故障,空氣、濾清堵塞故障6個方面宏觀分析電噴發動機的常見故障並舉例分析。
  8. For mobile sources, meca members include manufacturers of catalytic converters ( catalysts, substrates, mounting sleeves, and converter housings ) for all fuels ; diesel particulate filters ; oxygen, nox, and temperature sensors ; thermal management strategies ; engine / fuel management technologies ; crankcase emission control technologies ; evaporative emission controls ; enhanced combustion technologies ; plasma / corona technologies ; and components for fuel cell technology

    在移動源方面,其成員主要從事下列產品或技術的生產或研發:各類料的催化轉化(包括相關產品如催化劑、基質、安裝袖和轉化殼) ;柴顆粒過濾;氧氣、氮氣和溫度;熱處理系統;發動機/料操控技術;曲軸箱排放控制技術;蒸發排放控制;強化燒技術;等離子體/電暈技術。
  9. Fuel level warning sensor

    儲量報警
  10. This product acquires engine crank corresponding phase signal and rotating speed signal, which after ecu treatment, are used together with signals collected from other load sensor ( such as shutter location sensor ) to achieve electronic control over engine ignition timing. compared with mechanical ignition timing control, this is more precise and reliable, resulting in optimized performance of engine in oil consumption, exhaust, output and torque

    Fdw465b型電噴分電總成採集發動機曲軸相位信號及轉速信號,同其它負荷(如節氣門等)採集到的信號,經電控單元ecu計算處理后,實現對發動機點火正時的電子控制,較之機械式點火正時控制更加精確、可靠,使汽車發動機系統的綜合性能得到較大提高,特別是發動機的消耗率、排放、輸出功率、扭矩等方面都得到較大優化。
  11. It uses electronic control technology and places an oxide sensor in emission system, then according to the change of the rate of the air to fuel, adjust automatically the ejection of fuel. so it can improve dramatically the automobile performance. after installing three - way catalytic converter, it can make the pollutions lower 20 % ~ 50 % than the same vehicle, and the power of car reduce only 5 %

    對于適合我國現階段的電子閉環控制lpg料混合系統進行研究,此方法採用電子控制技術,在排氣系統中安裝了氧,可以根據排氣空比的變化,自動反饋調節供氣量,使氣汽車性能得到改善,安裝三元催化轉換后,可以使污染物排放較同等水平的汽車降低20 - 50左右,而發動機功率下降僅達5左右。
  12. In this paper, a matching platform for a model lh150 four stroke motorcycle engine is set up and a electronic fuel injection system is designed. the design of the electronic fuel injection system include the fuel supply system design, the intake pipe and throttle body design, the electronic control unit ( ecu ) develop, the way to use sensor of the system and the means to deal with sensor signal

    本論文建立了一套針對lh150型四沖程摩托車發動機的匹配臺架,設計了一套用於摩托車發動機的電控噴射系統,對發動機供系統、進氣系統進行了設計和選配;建立了一套的使用和信號處理方法;設計了一套電控單元硬體,並初步確定了電控單元的控制方法。
  13. This product acquires engine crank corresponding phase signal and rotating speed signal, which after ecu treatment, are used together with signals collected from other load sensor ( such as shutter location sensor ) to achieve electronic control over engine ignition timing, resulting in enhanced performance of engine in oil consumption, exhaust, output and torque

    該產品採集發動機曲軸相位信號及轉速信號,同其它負荷(如節氣門位置等)採集到的信號,經電控單元ecu處理后,實現對發動機點火正時的電子控制,使發動機系統的綜合性能得到較大提高(如發動機的消耗率、排放、輸出功率、扭矩等) 。
  14. These sensors establish ignition and fuel injection timing, and monitor crankshaft speed variation

    這些(的信號)來對點火、噴射定時和曲軸速度變化監控。
  15. The main distinct points are : the development of virtual press sensor and virtual fuel flowmeter for simulating the fuel system status data, the digital signal processing for the sps, and the diagnosis method - system status factor fault diagnosis

    主要特點在於:利用計算機技術,開發了虛擬壓力、流量來模擬系統的實時狀態數據;對信號的分析處理採用數字信號處理技術;提出了一種故障診斷方法? ?系統狀態因子診斷法,並進行了實驗驗證。
  16. Coming of baijia auto parts factory, our company is experienced in fuel sensor manufacturing and fittings

    我司的前身是百佳汽車配件廠,擁有十余年燃油傳感器生產、配套經驗。
  17. Variable resistance fuel level sensor

    可變電阻式儲量
  18. Fuel sensor harness

    燃油傳感器線束
分享友人