燃油冷卻器 的英文怎麼說

中文拼音 [rányóulěngquèqì]
燃油冷卻器 英文
fuel oil cooler
  • 燃 : 動詞1. （燃燒） burn 2. （引火點著） ignite; light
  • 油 : Ⅰ名詞1 （脂肪; 油脂） oil; fat; grease 2 （姓氏） a surname Ⅱ動詞1 （用桐油、油漆等塗抹） apply t...
  • 冷 : Ⅰ形容詞1 （溫度低; 感覺溫度低） cold:冷水 coldwater; 你冷不冷? do you feel cold?; are you feeling...
  • 卻 : Ⅰ動詞1 （後退） step back 2 （使退卻） drive back; repulse 3 （推辭; 拒絕） decline; refuse; reje...
  • 器 : 名詞1. （器具） implement; utensil; ware 2. （器官） organ 3. （度量; 才能） capacity; talent 4. （姓氏） a surname
  • 燃油 : fuel oil燃油艙 [船舶工程] oil bunker; oil fuel tank; 燃油閥 fuel valve; 燃油鍋爐 oil burning boil...
  1. The program is the same with onan and onaf. the temperature rise of high ignition point oil transformer also use the program. some factors are analysed to influence temperature rise of transformer

    該演算法適用於自然油循環變壓器自然風冷卻和吹風冷卻的情況以及冷卻流體為常規變壓器油或高燃點油的情況。
  2. The sprayer is usually connected with water supply network, control value, detection alarm unit, etc. to form an automatic water spray system ( such as sprinkler fire - extinguishing system ) for saving electrical equipment, fighting burning flammable liquid, etc. it is widely used for fire control and cooling protection for such equipment / places as power plant * generating machinery, large size transformer, liquefied petrolatum tank, factory, shopping mall, hotel, warehouse, storied building and so on

    該水霧噴頭通常與供水管網、控制閥門、控測報警器等組成自動噴水滅火系統（如雨淋噴水滅火系統等） ，用來撲救電氣設備，可燃液體火災等，廣泛用於保護電廠的發電設備，大型變壓器，液體石油儲罐、工廠、商場、賓館、倉庫、樓房等必須滅火、控火或防護冷卻等場所。
  3. Siemens vdo serves in the local china market covering the products of ems ( engine management system ), diesel system, tcu ( transmission control unit ), fuel rail, injector, sensor, fuel supply system, engine actuator, acu ( airbag control unit ), bcm ( carbody control module ), window lift motor, engine cooling module, abs motor, rke, instrument panel, audio system ( radio / cassette / cd ), navigation system, vdr ( commercial vehicle data recorder ), etc

    在中國市場上，西門子威迪歐汽車電子中國的產品系列包括ems （發動機電噴管理系統） 、柴油機系統、發動機執行器、 tcu （自動變速箱控制單元） 、油軌、燃油噴嘴、傳感器、油泵、 acu （安全氣囊控制單元） 、 bcm （車身控制模塊） 、搖窗電機、發動機冷卻模塊、 abs電機、駕駛臺儀表、音響、導航和vdr （商用車行車記錄儀）等。
  4. Whole scheme of frame design of test - bed is proposed as : the host fanner supply the firebox the once and twice air required by diesel oil ' s burning and the cooling air ; the export parameter of the test - bed is varied by the adjust of the flux of air and diesel oil. and the air flux is varied by adjusting the rev of the fanner adjusted by transducer and the corner of the fan inlet adjusted by step motor. the quantity of oil is varied by adjusting the oil valve adjusted by step motor ; the measurement of the air flux in the test - bed adopts the method of fanner dynamics performance test in the nation criterion

    確立了實驗臺結構設計方案：主風機為燃燒器提供燃燒所需的一次、二次進風量及冷卻風量；利用變頻器調節主風機轉速、用步進電機調節風門開度來調節風量，用步進電機調節回油閥開度來調節供油量，從而實現對模擬實驗臺出口煙氣熱流量的調節；實驗臺的流量測量採用風機動力性能測試標準中測流量方法等。
  5. Whole scheme of frame design of testing flat is proposed as : the host fanner supply the air required by flamer ’ s burning and cooling, the export parameter of the flat varies by different rotate speed of the fanner 、 angle of the fan inlet and the quantity of oil, the measurement of flow in the testing flat adopts the method of fanner dynamics performance test in the nation criterion

    確立了實驗臺結構設計方案：主風機為燃燒器提供燃燒所需的一次、二次進風量及冷卻風量；模擬實驗臺出口煙氣熱流量是通過調節風機的轉速、風門開度及燃油量來改變；實驗臺的流量測量採用風機動力性能測試標準中流量方法等。
  6. Pit remediation & slop oil, industrial water, cutting & cooling oils, hexavalent chromium, acid & alkali with heavy metal content, steel mill & electro filter dust, spent catalysts, tempering salts, solvents recovery and recycling, sludge treatment and minimization, fuel - blending, thermal desorption and transfer centres

    廢漿池和廢油、工業污水、巖屑和冷卻油、六價鉻、含重金屬成分的酸堿、鋼廠和電過濾器粉塵、反應過后的催化劑、淬火鹽、溶劑還原和回收、油泥處理和最小化、燃料混合、熱吸附和轉運中心。
  7. This cleaned, hot gas, having been piped to an oil cooler for flash cooling from 850 c down to ambient temperature, is set to drive the gas engines which in turn power generators for the production of electricity, and augment the fuel for the boilers to generate the steam for more thermal treatment and electricity

    清潔的熱氣體輸送到機油冷卻器，氣體迅速從850 c冷卻至室溫，同時開始驅動氣體發動機並使其成為產生電能的發電機，增加鍋爐燃料以生成蒸汽用於進行更多的熱處理並生產更多的電能。
  8. The structure, algorithms, and applications of fuzzy control and ann control system is systematically studied. taking the oil cooler heat transfer characteristics measurement system as the research object, this paper present the hardware design method, and uses visual c on the windows as the tool to implement the fuzzy ann control algorithm. this software also implements temperature real - time control, date collection, analysis and processing, and automatic drawing as well as print

    本文以內燃機機油冷卻器測試系統精密溫度控制為研究對象，設計出了符合高精度溫度控制的機械裝置，在windows平臺下用visualc + +作為編程工具開發出了基於模糊神經網路的精密控溫系統及其應用軟體，實現了精密溫度的實時控制、數據的採集、分析與處理和自動繪圖列印等功能。
  9. Internal combustion engines. tube and shell oil coolers. specifications

    內燃機.管殼式機油冷卻器.技術條件
分享友人
分享到 Line

分享到臉書