燃燒溫度 的英文怎麼說

中文拼音 [ránshāowēndù]
燃燒溫度 英文
burining temperature
  • 燃 : 動詞1. （燃燒） burn 2. （引火點著） ignite; light
  • 燒 : Ⅰ動詞1 （使東西著火） burn 2 （加熱或接觸某些化學藥品、放射性物質等使物體起變化） cook; bake; hea...
  • 溫 : Ⅰ形容詞（不冷不熱） warm; lukewarm; hot; gentle; mild Ⅱ名詞1 （溫度） temperature 2 （瘟） acute ...
  • 度 : 度動詞[書面語] （推測; 估計） surmise; estimate
  • 燃燒 : （物質劇烈氧化而發光、發熱; 燒） burn; kindle; flame; set on fire; [化學] combustion; inflammation; ignition
  • 溫度 : [物理學] temperature
  1. Because of its great latent heat, water can absorb heat and boil away, so as to lower combustion temperature

    水可以利用自身潛熱大的特點吸收熱量而汽化成為過熱蒸汽，從而降低缸內燃燒溫度。
  2. It ' s the first time to explore the combustion characteristics of lpg / diesel mixing fuel engine, and find that, with the change of load and rotation, the changing trend of the ignition delay period of e10 mixing fuel is almost as identical as that of the diesel, but that of e30 mixing fuel is very different. comparing with diesel, the combustion of e10 is improved slightly, but that of e30 greatly changes ; the maximum eruptive pressure decreases ; the maximum pressure increase rate decreases ; the highest releasing heat rate increases ; the highest combustion temperature falls ; the ignition delay period extends

    結果表明: e10混合燃料與柴油的著火滯燃期隨負荷和轉速的變化趨勢基本一致; e30混合燃料與柴油則有所不同; eio混合燃料發動機的燃燒與純柴油相比，略有改善; e30混合燃料的燃燒特性發生明顯的變化，最高爆發壓力下降，最大壓力升高率減小，最大燃燒放熱率增大，最高燃燒溫度下降，滯燃期延長。
  3. A new calculation method for optimizing diesel engine performance, called nonlinear regression - mess method, is put forward. in this paper, 25 groups of simulated values are calculated from the diesel engine working model, specific fuel consumption, peak pressure, rate of pressure rise, nox and peak temperature are fitted into explicit function about compression ratio and fuel injection advance angle

    本文利用柴油機工作過程模型，得出25組模擬計算數據，利用非線性回歸將油耗、最大爆發壓力、壓力升高率、 no _ x濃度及最高燃燒溫度擬合成壓縮比和噴油提前角的顯函數，並用網格法進行優化，用c語言編制了優化計算程序，得出最佳的壓縮比和噴油提前角，使其優化匹配。
  4. The forecast module uses the realtime data to calculate the forecast values. this thesis based on no. 3 blast furnace of the xiangtan iron and steel company. it match esthe hardware and software of the blast furnace

    在預測模塊中，用即時數據來計算預測值，並用調整系數進行調整，得到可靠的預測值，如鐵水溫度、理論燃燒溫度、直接還原度、焦比等。
  5. Peak flame temperature

    最高燃燒溫度
  6. Wall temperature had a remarkable effect on smog exit temperature, whereas its effect on other parameters was not obvious

    壁面溫度對最高燃燒溫度、壁面最大熱流和平均熱流影響不明顯，但煙氣出口溫度隨壁面溫度的升高而增加較大。
  7. Under the condition of constant phosphorus mass flow rate, the smog exit temperature would increase slowly while other parameters would decrease with increasing excess air coefficient

    在燃磷量不變情況下，最高燃燒溫度、壁面最大熱流和平均熱流均隨過剩空氣系數的增大而減小，但煙氣出口溫度緩慢增加。
  8. In addition, radiation absorption coefficient had a remarkable effect on maximum combustion temperature and maximum wall heat flux in the new phosphoric acid tower

    輻射吸收系數對最高燃燒溫度和壁面最大熱流影響很大，隨輻射吸收系數的增大，最高燃燒溫度和煙氣出口溫度會下降，而壁面最大熱流和平均熱流會上升。
  9. The predicted results showed that maximum combustion temperature, smog exit temperature, maximum wall heat flux and averaged wall heat flux would increase with increasing phosphorus mass flow rate when excess - air coefficient or air flow rate was constant

    模擬結果表明，無論過剩空氣系數固定還是空氣流量固定，隨燃磷量的增大，最高燃燒溫度、煙氣出口溫度、壁面平均熱流和最大熱流都呈上升趨勢。
  10. The effects of parameters on maximum combustion temperature, smog exit temperature, maximum wall heat flux, averaged wall heat flux of a new phosphoric acid tower with circular water wall were discussed, including phosphorus consumption, excess - air coefficient, wall temperature and radiation absorption coefficient, with the mathematical model developed in part

    摘要利用已建立的數學模型考察了燃磷量、過剩空氣系數、壁面溫度、輻射吸收系數對新型燃磷塔的最高燃燒溫度、煙氣排放溫度、壁面最大熱流和平均熱流的影響。
  11. The heat balance equations on incineration of organic liquid waste in fluidized - bed incinerator with coal as auxiliary fuel is established in this paper. the relations between the feeding rate of auxiliary fuel and the lhv of liquid waste, the incineration temperature, and the preheated combustion air temperature have been discussed. this paper also discussed the relation between the lhv of liquid waste and combustion air temperature as the auxiliary fuel is not necessary, and provides the theoretical foundation for the design and operation on fluidized - bed incinerator

    建立了以煤為輔助燃料的，有機廢液在流化床中焚燒的熱平衡方程，求得輔助燃料耗量與各影響因素的計算式，得出輔助燃料耗量與廢液中可燃基的低位發熱值、密相區燃燒溫度、熱風溫度之間的關系曲線，以及不需要輔助燃料時，有機廢液熱值與熱風溫度之間的關系，為流化床焚燒爐的設計與運行提供了理論依據。
  12. It also researches the mixed combustion process of hot coal gas and preheats combustion - supporting air by utilizing the left heat of fume from industrial furnace so as to improve the theoretical combustion temperature of hot coal gas

    通過利用工業爐的煙氣余熱預熱助燃空氣，提高熱煤氣理論燃燒溫度的辦法，是諸多方法中最經濟有效的方法。
  13. While the speed is very large, the fuel - air mixing behind the airstream is decreased and the span that the fuel flow in the second combustor is reduced, so the combustion efficiency is decreased, h ) if the fuel streams impinge with the airstreams directly at the air - inlet exit, it make against increasing the combustion efficiency, i ) increasing air - to - fuel ratio within proper range can increase the combustion efficiency

    增加燃氣噴射速度有利於增強迴流區強度，頭部燃燒溫度上升，但速度太大則會減弱燃氣同空氣在進氣道下游的摻混燃燒，減少燃氣在室內停留時間，燃燒效率降低； 8燃氣射流與空氣流在進氣道出口直接撞擊不利於燃燒效率的提高； 9在適當范圍內增大空燃比能顯著提高燃燒效率。
  14. In this paper a perfect and flexible experimental system of low nox combustion is established firstly. the influences of the temperature of combustion, the air excess coefficient, a certain amount of vapor added in advance, the temperature of preheated air, adding microwave into gas before combustion, gas recycling combustion and the mode of combustion ( diffused and premixed ) on nox emission are analyzed respectively. the combustion of liquid petroleum gas is simulated with phoenics 3. 5

    首先建立了完善靈活的低no _ x燃燒實驗系統，在實驗系統上完成了燃燒溫度、過量空氣系數、預先加入一定量的水蒸汽、空氣預熱溫度、對燃氣預先進行微波處理、煙氣再循環燃燒以及燃燒方式（擴散式與預混式）對no _ x生成的影響分析；採用phoenics3 . 5軟體進行了液化石油氣燃燒的數值模擬。
  15. The simulations results show that the average combustion temperature is much lower in fuel - rich state and little higher in oxygen - rich state near the best o / f ratio. by extending the post - chamber length the oxidizing gas and the fuel pyrolytic gas can burn completely and the average combustion temperature can be prominently increased. the fuel - rich recirculation zone close to the head of combustion chamber is very important for the combustion

    計算結果分析表明：發動機在富燃狀態下平均燃燒溫度偏低，在接近理想配比的富氧狀態下平均燃燒溫度有所提高；加長補燃室可以大幅度提高發動機的平均燃燒溫度，並促進氧化劑氣體和熱解氣體的充分燃燒；燃燒室頭部的富燃迴流區對發動機的燃燒非常重要，去掉燃燒室頭部突擴段后，氧化劑氣體和燃料熱解氣體不能充分燃燒，發動機的平均燃燒溫度大幅下降。
  16. The effect of various factors on the theoretical combustion temperature of the stove

    各因素對熱風爐理論燃燒溫度的影響
  17. Adiabatic combustion temperature

    絕熱燃燒溫度
  18. Standard test method for hot - surface ignition temperature of dust layers

    塵埃層熱表面燃燒溫度的標準試驗方法
  19. Experimental study on temperature distributions of superadiabatic combustion in porous media with reciprocating flow

    多孔介質內往復流動燃燒溫度分佈的實驗研究
  20. All polymers react with oxygen under extreme conditions, that is, at combustion temperatures.

    所有聚合物，在劇烈條件下，亦即在燃燒溫度下，都同氧發生反應。
分享友人
分享到 Line

分享到臉書