燃燒量熱法 的英文怎麼說

中文拼音 [ránshāoliángrèfǎ]
燃燒量熱法 英文
combustion calorimetry
  • 燃 : 動詞1. （燃燒） burn 2. （引火點著） ignite; light
  • 燒 : Ⅰ動詞1 （使東西著火） burn 2 （加熱或接觸某些化學藥品、放射性物質等使物體起變化） cook; bake; hea...
  • 量 : 量動1. （度量） measure 2. （估量） estimate; size up
  • 法 : Ⅰ名詞1 （由國家制定或認可的行為規則的總稱） law 2 （方法; 方式） way; method; mode; means 3 （標...
  • 燃燒 : （物質劇烈氧化而發光、發熱; 燒） burn; kindle; flame; set on fire; [化學] combustion; inflammation; ignition
  1. In the third, this paper makes a survey on components of the exhausted flue gas and waste heat resource, and discusses the possibility and methods of steam generation and air preheating with the waste heat. and then, the analysis on the advantages and disadvantages of heat recovery plants with conventional steel - water heat pipes and inorganic heat - transfer heat pipes is carried out. the paper also gives a valuation about the plan and features of the design of heat recovery

    對余熱源排煙的成分和余熱資源量進行標定，討論余熱回收產生蒸汽或加熱燃燒用空氣的可行性和方法，分析常規余熱回收技術設計、採用普通鋼-水熱管和無機傳熱熱管等傳熱元件的設計余熱回收裝置的優缺點，並對余熱回收設計方案及其特點進行總體評價。
  2. This article aims at the boiler ' s problems in operation : 1 ) under nominal load, the smoke temperature at the outlet of hearth reaches 1200, far more exceeds 1050 the original designed temperature. this will always result in slag inside boiler and the temperature of overheater ' s pipe superheat, so that boiler cannot take nominal load and all these influence boiler ' s nomal operation heavily, 2 ) this article also studied the reason why the assistant oil becoming necessary when coal changes. during the nomal operation, many factors ( makeup of combustor and its disposal, smirch and encrust of water wall, excessive air coefficient, temperature of primary air, coal type and density of coal dust ) can deviate the designed working conditions, then affect the boiler ' s nomal operation

    本文針對該鍋爐在實際運行中存在的問題：在額定負荷下，爐膛出口超溫、低溫段過熱器前煙溫高達936 ，遠遠超過815的設計值；噴燃器四周水冷壁結焦嚴重，過熱器管壁溫度超標，無法帶上額定負荷；甚至有時因燃煤質量的變化，必須投油助燃的嚴重情況進行了分析研究。在實際生產過程中，燃燒器的結構、布置，水冷壁的粘污、結垢，過剩空氣系數、一次風溫、煤種及其濃度變化等許多因素都會偏離鍋爐的設計工況，從而影響爐內的傳熱和燃燒，造成爐膛出口超溫、水冷壁結渣等問題。
  3. Tga. insulating and sheathing materials of electric and optical cables - common test methods - part 4 - 1 : methods specific to polyethylene and polypropylene compounds - resistance to environmental stress cracking - measurement of the melt flow index - carbon black and or mineral filler content measurement in polyethylene by direct combustion - measurement of carbon black content by termogravimetric analysis - assessment of carbon black dispersion in polyethylene using a microscope

    電纜和光纜的絕緣和護套材料.通用試驗方法.第4 - 1部分:聚乙烯和聚丙烯化合物專用方法.抗環境應力致裂.熔化流動指數測量.通過直接燃燒測量聚乙烯中炭黑和或礦物填料含量.通過熱重分析法
  4. Standard test method for heat of combustion of liquid hydrocarbon fuels by bomb calorimeter

    彈式量熱器測定液烴燃料燃燒熱的標準試驗方法
  5. 05. 01 heat of combustion of liquid hydrocarbon fuels by bomb calorimeter, method of test for

    用氧彈式量熱計測定液態烴燃料燃燒熱值的方法
  6. Heat combustion of liquid hydrocarbon fuels by bomb calorimeter intermediate precision method, test method for

    用彈式量熱法測定液態烴類燃料的燃燒熱值的方法
  7. Standard test method for heat of combustion of liquid hydrocarbon fuels by bomb calorimeter precision method

    用彈式量熱器對液態烴類燃料燃燒熱量的標準試驗方法
  8. Test method for determination of fire - test - response characteristics of components or composites of mattresses or furniture for use in correctional facilities after exposure to vandalism, by employing a bench scale oxygen consumption calori

    用實驗室耗氧熱量計測定遭破壞后修復設施中床墊或傢具用部件或合成材料燃燒試驗響應特性的標準試驗方法
  9. This paper describes how to calculate the temperature of high - temp gas at the outlet of combustor by means of limited gas composition and analyses how errors in measuring gas composition, low calorific value of fuel, fuel composition and fuel temperature, etc. affect gas temperature

    摘要敘述了一種根據有限的燃氣成分推算燃燒室出口高溫燃氣溫度的計算方法，並分析了燃氣成分測量誤差、燃料低熱值、燃料成分及燃料溫度等對燃氣溫度的影響。
  10. In this thesis, the measuring methods of main combustion parameters of coal burning boiler are analyzed and compared on the basis of the conclusion of relative experiences of both here and abroad. and by integrating relative knowledge of the combustion regulation of coal burning boiler, a set of the on - line monitoring system of the combustion condition of boiler is designed and developed, which is used to measure the important parameters of the burning process of boiler exactly, and is suitable to the tangentially fired furnace boiler

    在總結國內外相關經驗的基礎上，本文分析比較了火電廠燃煤鍋爐主要燃燒參數的測量方法，並結合燃煤鍋爐燃燒調整的有關知識，設計開發了一套鍋爐燃燒在線監測系統，用於對鍋爐燃燒過程的重要參數進行實時準確的測量，適用於中間儲倉式、熱風送粉的四角噴燃鍋爐。
  11. Focusing on the performance evaluating and the design of tripropellant injector, adopting the cold test rig with background pressure supply, malvem particle analyzer, ccd photography system, tripropellant hot test - bed, numerical simulation software and auxiliary theoretical a nalysis, the d ischarge c haracteristic a s w ell a s a tomization p erformance o f the injector and the combustion performance as well as the mode - transition characteristic of thrust chamber are studied detailedly based on the 3 different structures of coaxial tripropellant injector, large numbers of important conclusions are gained

    本文圍繞三組元噴嘴的性能評定及設計方法。採用反壓冷試臺、馬爾文測粒儀、 ccd高速攝影系統、三組元發動機熱態試驗臺、數值模擬程序及輔助理論分析等多種技術手段和研究方法，對三種結構的同軸式三組元噴嘴深入進行了噴嘴流量特性和霧化特性、推力室燃燒性能和轉工況性能研究，得到了大量重要結果。
  12. You should follow the installation instructions for the luminaires, such as installing away from combustible surface ( wall paper, wooden false ceiling ), allowing sufficient room for heat dissipation ( particularly luminaires fitted with tungsten halogen lamps ), ensuring effective earthing connection ( such as adding star and spring washers at the earth terminal ), and adopting proper anchorage to support its weight

    燈飾應按照指示安裝，注意要遠離容易燃燒的表面（例如墻紙、木製假天花） ，預留足夠的散熱空間（尤其是裝有鎢絲鹵燈的燈飾） ，確保有效接地（例如在接地終端加上菊花介指和彈弓介指） ，並因應燈飾的重量，選用適當的安裝方法（例如大型的吊燈，須選用拉爆螺絲等） 。
  13. Whole scheme of frame design of test - bed is proposed as : the host fanner supply the firebox the once and twice air required by diesel oil ' s burning and the cooling air ; the export parameter of the test - bed is varied by the adjust of the flux of air and diesel oil. and the air flux is varied by adjusting the rev of the fanner adjusted by transducer and the corner of the fan inlet adjusted by step motor. the quantity of oil is varied by adjusting the oil valve adjusted by step motor ; the measurement of the air flux in the test - bed adopts the method of fanner dynamics performance test in the nation criterion

    確立了實驗臺結構設計方案：主風機為燃燒器提供燃燒所需的一次、二次進風量及冷卻風量；利用變頻器調節主風機轉速、用步進電機調節風門開度來調節風量，用步進電機調節回油閥開度來調節供油量，從而實現對模擬實驗臺出口煙氣熱流量的調節；實驗臺的流量測量採用風機動力性能測試標準中測流量方法等。
  14. Whole scheme of frame design of testing flat is proposed as : the host fanner supply the air required by flamer ’ s burning and cooling, the export parameter of the flat varies by different rotate speed of the fanner 、 angle of the fan inlet and the quantity of oil, the measurement of flow in the testing flat adopts the method of fanner dynamics performance test in the nation criterion

    確立了實驗臺結構設計方案：主風機為燃燒器提供燃燒所需的一次、二次進風量及冷卻風量；模擬實驗臺出口煙氣熱流量是通過調節風機的轉速、風門開度及燃油量來改變；實驗臺的流量測量採用風機動力性能測試標準中流量方法等。
  15. Test method for heat release, flame spread and mass loss testing of insulating materials contained in electrical or optical fiber cables when burning in a vertical cable tray configuration

    電纜或光纜絕緣材料在立式電纜槽裝置中燃燒時熱發散火焰傳播和質量損失測試的試驗方法
  16. Standard test method for heat release, flame spread, smoke obscuration, and mass loss testing of insulating materials contained in electrical or optical fiber cables when burning in a vertical cable tray configuration

    電纜或光纜絕緣材料在立式電纜槽裝置中燃燒時熱發散火焰傳播煙的昏暗度和質量損失測試的標準試驗方法
  17. Standard test method for flame height, time of burning, and loss of mass of rigid thermoset cellular plastics in a vertical position

    垂直向硬質熱固性泡沫塑料的火焰高度燃燒時間和質量損失的標準試驗方法
  18. Test method for smoke generation from burning or pyrolysis of building materials dual - chamber test

    建築材料燃燒或熱解發煙量的測定方法雙室法
  19. Over the years, the company independent innovation and invention duty, in particular the use of sophisticated technology of modern microelectronics technology, and strive to explore clean coal gasification and combustion heat the best possible use of the method, so as to achieve environmental protection, energy saving, safety and easy - to - use purpose, commitment to the new environmental generation of intelligent energy - saving boiler equipment series product development and manufacturing, through repeated testing, improvement, the test units and hundreds of users use, continuously improve product performance, technology is improving daily, manufacturing production has been stereotyped by the third generation products " disorientated " card microcomputer control automation system gas boiler energy conservation and environmental protection official on the market

    多年來，公司以自主創新和發明創造為己任，利用尖端科技尤其是現代微電子技術，努力探索實現煤炭煤氣化潔凈燃燒和熱能盡可能得到充分利用的方法，從而達到環保、節能、安全和使用方便的目的，致力於新一代智能型環保節能鍋爐設備系列產品的研發和製造，經過反復試驗、改進，試銷和幾百個單位用戶的使用，產品性能不斷提高，技術日臻完善，現已定型製造批量生產的第三代產品「 ?牛」牌微電腦自動化控制煤氣節能環保鍋爐正式推向市場。
  20. Test method for estimation of net heat of combustion of aviation fuels

    航空燃料燃燒凈熱量估算的測試方法
分享友人
分享到 Line

分享到臉書