燒油加熱 的英文怎麼說

中文拼音 [shāoyóujiā]
燒油加熱 英文
oil heating
  • : Ⅰ動詞1 (使東西著火) burn 2 (加熱或接觸某些化學藥品、放射性物質等使物體起變化) cook; bake; hea...
  • : Ⅰ名詞1 (脂肪; 油脂) oil; fat; grease 2 (姓氏) a surname Ⅱ動詞1 (用桐油、油漆等塗抹) apply t...
  1. Heat up a saucepan, put butter in, sautee garlic, o nion, mushroons for 2 - 3 minutes flamed with brandy, and red wine, put in all ingredient intoa brown sauce reduc tion bring it boil and simmer for 5 - 10minutes and finis hed it with cream add salt and pepper to taste

    沙司鍋,放入黃,炒蒜泥、洋蔥、蘑菇2 - 3分鐘,噴入白蘭地和葡萄酒,放入其餘原料炒,然後倒入濃縮過的黃汁,開,煨5 - 10分鐘,最後入奶開,入鹽和胡椒粉嘗味入蜂蜜、糖、鹽和胡椒粉,嘗味。
  2. Oil - fired heated units with vaporizing burners ; requirements, testing, marking

    裝有氣化燃器的燒油加熱裝置.要求試驗和標記
  3. Analysis of experimental data indicates that there exist several following problems during the whole operation : first, the emission is serious and the density of hc and co smoke is very high at on and off period. second, there is oil dripping from the dripping vitta as a result of the fault of ignition system and combustion structure. the last, there might be accidents of disabled ignition resulted from the improper operation at the beginning

    通過對樣機的試驗分析和研究表明,汽車空氣燃器在整個工作過程中,其排放存在以下三個問題:一、開機和關機兩個階段的排放問題嚴重,廢氣中hc和co的濃度值及煙度測量值都很高;二、因點火系統和燃結構的缺陷而導致開機后一段時間內有滴從滴管滴落;三、在點火過程中,會出現因操作不當而點火失效的現象。
  4. Standard for safety for waste oil - burning air - heating appliances

    空氣設施安全標準
  5. 3. on boiler retrofit, the calculation of fuel burning, the heat calculation of boiler inside structure and convection section, and the design of structure parameter of feed water heat exchanger are made. the flue gas channels " resistance calculation and the boiler strength verifying are also carried out. replacement of water cooling wall improves heat exchanging and decreases loss of heat radiant

    對鍋爐本體進行了燃料燃計算、爐膛結構力計算、對流受面結構力計算、鍋爐給水器結構參數設計、煙道阻力計算及鍋爐元件強度校核等;改進了水冷壁布置使換效果更好,減少輻射換損失;改進對流段結構,更充分的利用爐膛出口煙氣余,提高效率;並且進行了煙氣阻力計算、效率計算和能量平衡測試,對改進后的稠燃料和改進前進行了對比,燃狀況和效率有明顯改善。
  6. Oil fired bath water heaters with vaporizing burners

    裝有汽化燃器的的洗澡水
  7. Abstract : during the heating of scrap with carbon or hydrocarbon contented substances in some process, it will bring problems like explosion of carbon monoxide, fume and smell from oil volatilization, etc. , if incomplete combustion occurs. through laboratory experiments, the time related variation of gas contents and post combustion ratio of fume during the heating of oil - bearing scrap are studied. the results show that the restrictive chain of reaction procedure is the thermolysis of oil ; that temperature and ( co ) / ( co2 ) ratio influence transformation ratio and post - combustion ratio under lower temperature ; that 900 is the temperature above which the complete reaction can be ensured at all ( co ) / ( co2 ) ratios

    文摘:在某些廢鋼熔煉過程中,當爐料中含碳及碳氫物質且燃不充分時,會帶來煙氣中一氧化碳的燃爆、污揮發時造成的煙霧、臭味等問題.通過實驗室裝置研究含廢鋼在過程中煙氣成分隨時間的改變以及二次燃率的變化,試驗結果表明,反應過程的限制性環節是分的分解;在較低的溫度下( co ) / ( co2 )比例影響轉化率和二次燃率;而在任意比例下保證充分反應的溫度為900以上
  8. An experimental study is carried out on the effect of following factors on the combustion performance of a vehicle fuel heater : geometric parameters ( the number, diameter, distribution and direction of combustion chamber intake holes ) and intake and exhaust pressures

    摘要對車用燃器燃室進氣孔徑(流通面積) 、孔的分佈、孔的方向等幾何參數和進排氣壓力對器燃性能的影響進行了試驗研究。
  9. Intermittent operating, back - up mobile oil - fired flame heaters for domestic use without ventilating pipe or special device for evacuation of combustion products

    不帶燃生成物通風管或抽排專用裝置的家用間歇運行的移動式備用燃
  10. This will be dealt with in this paper. the discrimination for noise source from qn700 indicates : the fan noise ( 625hz ), the electromagnetism noise ( 962hz ) and the burning noise are the main noise sources

    對汽車燃空氣器中具有典型代表結構的qn700型樣機的測試分析表明:風扇噪聲( 625hz ) 、電機噪聲( 962hz )和燃噪聲是器的主要噪聲源。
  11. Carbonaceous materials for the production of aluminium. calcined coke. determination of apparent oil content. heating method

    鋁生產用碳質材料.煅焦炭.表觀含量的測定.
  12. Welcome at dungs top technological products and system solutions for the burner, heating, air conditioning and process heat industry are our contribution to safe and clean burning of gases and oil for heat production and efficient heat distribution

    我們的貢獻是通過對燃氣和燃的安全高效清潔衛生的燃獲得量,我們的產品和系統方案在技術上處于領先的地位,被廣泛地應用於燃器工業採暖工業空調工業和工業過程。
  13. Code of practice for oil firing - installations of 45 kw and above output capacity for space heating, hot water and steam supply services

    慣例.第2部分:輸出功率大於等於45kw的空間水和蒸汽供應設備
  14. Abstract : the in servie tubular heaters built early in refineries and chemical plans have low thermal load and low heat efficiency, therefore measures for technical reform are offered, including ( 1 ) enlarging the surface area of convection tubes to increase the thermal load of rhe convection section ; ( 2 ) increasign the heat interchanging area of radiant tubes ; ( 3 ) changing the height of the chimney ; ( 4 ) using new burner with forced air supply to increase calorific capacityu ; ( 5 ) adding air preheater between the convection section and chimney to enhence the temperature of the air entering the furnace ; ( 6 ) adopting high temperature radiant coating to improve the effect of radiant heat interchanging

    文摘:針對早期建造的煉廠和化工廠在役管式負荷和效率低的狀況,提出了若干技術改造措施包括,增大對流管表面積以增大對流段的負荷;增輻射管的換面積;修正煙囪高度;換用新型燃器,變自然通風為強制供風,以增大燃器的發量,減小過剩空氣系數,節省燃料2 % 3 % ;在對流段和煙囪之間增設空氣預器以提高空氣入爐溫度;採用高溫輻射塗料增強輻射換效果,從而增源對爐壁的輻射傳量和爐管的傳量等。
  15. The in servie tubular heaters built early in refineries and chemical plans have low thermal load and low heat efficiency, therefore measures for technical reform are offered, including ( 1 ) enlarging the surface area of convection tubes to increase the thermal load of rhe convection section ; ( 2 ) increasign the heat interchanging area of radiant tubes ; ( 3 ) changing the height of the chimney ; ( 4 ) using new burner with forced air supply to increase calorific capacityu ; ( 5 ) adding air preheater between the convection section and chimney to enhence the temperature of the air entering the furnace ; ( 6 ) adopting high temperature radiant coating to improve the effect of radiant heat interchanging

    針對早期建造的煉廠和化工廠在役管式負荷和效率低的狀況,提出了若干技術改造措施包括,增大對流管表面積以增大對流段的負荷;增輻射管的換面積;修正煙囪高度;換用新型燃器,變自然通風為強制供風,以增大燃器的發量,減小過剩空氣系數,節省燃料2 % 3 % ;在對流段和煙囪之間增設空氣預器以提高空氣入爐溫度;採用高溫輻射塗料增強輻射換效果,從而增源對爐壁的輻射傳量和爐管的傳量等。
  16. Through the choice of combustion controlling equation, the close of equation group and the decision of boundary condition, it completely introduces the numerical simulation theory with flame combustion on the heating furnace for carrying crude oil

    通過燃控制方程的選用、方程組的封閉以及邊界條件的確定,系統介紹了原輸運爐煤氣有焰燃數值模擬的理論基礎。
  17. Experiment results show that such burners are safe enough, feature good adaptability in operation and ease of use, have litter investment, are provided with good economical benefit, etc. they have broad prospects for use in utility boilers that consume no oil for ignition and maintain the stability of flame

    試驗結果表明,本燃器具有安全可靠、適應性強、操作方便、投資小、經濟效益高等優點,在電站鍋爐無點火方面有著廣泛的應用前景。本文應用電磁感應直接點火技術,對吉林電廠5號爐進行實際工程應用設計,並取得點火成功。
  18. The paper adopts active measure, reconstructs parts on the equipment, and come up with micro - computer controlling system which will be used on the domestic oil heaters, taking into account the change of users ' needs and the current situation all over the world, based on machanism of emission producing and theorizition of combustion

    本研究採取主動措施,根據污染物的生成機理、傳學、燃理論等,針對該設備的部分結構進行了合理改進,並按照用戶使用要求的變化以及國外的發展狀況,提出了在國產汽車燃器上採用微型計算機控制的技術方案。
  19. However, with the demand for environmental prelection inhancing, the emission which had not been taken into account is noticed now. in order to improve heater emission and performance and to meet the full needs of users and the development of futurel automobile environment pretection, the paper which uses qn700 air oil - heater as the research objective, theoretically analyzes, experimentally do researches, searches for the main emission source, and brings up efficient improving methods based on the process of combustion x the characteristics of exhaust. the principle of operation

    為了使器的燃排放性能更完善,充分滿足用戶的使用要求和未來汽車環保要求發展的需要,本論文以國產大型客車廣泛使用的qn700型空氣燃器為研究對象(其燃結構和工作原理具有一定的典型性) ,針對這一典型的國產空氣燃器的燃過程、排放特性以及工作原理進行理論分析和試驗研究,找出主要污染源及其產生機理,並在此基礎上根據現有的結構提出有效的改進方案。
  20. The subject in this study is the yj - q27. 9 / 2x type vehicle oil heater made by peking vehicle equipment company, and performing the methods of theory and testing, and realizing the function of burning nature gas on the basis of the least modification of the oil heater ' s configuration

    本課題以北京京威汽車設備有限公司生產的yj ? q27 . 9 2x型汽車液體燃器為研究對象,採用理論與試驗相結合的研究方法,在盡量少改動原機型結構的基礎上實現了燃天然氣的功能。
分享友人