燒結性能 的英文怎麼說

中文拼音 [shāojiēxìngnéng]
燒結性能 英文
sintering characteristic
  • 燒 : Ⅰ動詞1 （使東西著火） burn 2 （加熱或接觸某些化學藥品、放射性物質等使物體起變化） cook; bake; hea...
  • 結 : 結動詞（長出果實或種子） bear （fruit）; form （seed）
  • 性 : Ⅰ名詞1 （性格） nature; character; disposition 2 （性能; 性質） property; quality 3 （性別） sex ...
  • 能 : 能名詞（姓氏） a surname
  1. The formation of new phase such as mullite and gahnite by solid - phase reaction in multiphase materials can benefit the sintering of materials at 1700, decreased apparent porosity to less than 5 %. reducing atmosphere inhibited the synthesis of mullite and gahnite, played a negative role in the densification of multiphase materials

    固相反應生成的鋅鋁尖晶石和莫來石具有較高的活性，使復相材料在1700燒后顯示出更好的燒結性能，其顯氣孔率降低到5以下；還原性氣氛阻礙了莫來石和鋅鋁尖晶石的生成，不利於復相材料的燒結和緻密化。
  2. Study on the synthesis of corundum - mullite - gahnite multiphase materials by two - step sintering process using kaolinite as raw material showed that impurities introduced by kaolinite mainly increased the liquid amount at high temperature, which can assist sintering of specimen. the experiment results indicated that the samples with lower gahnite content had better sinterability than others. however, if the gahnite content was relative high, the promoting effect on sinterability caused by kaolinite was not significant

    採用天然原料高嶺土二步煅燒合成剛玉?莫來石?鋅鋁尖晶石復相材料研究發現：天然原料中帶入的雜質主要是增加液相量，促進高溫下試樣的燒結；當尖晶石含量較低時，試樣在1300保溫2h時，在1600燒后試樣燒結性能相比之下較好；而當鋅鋁尖晶石含量較高時，天然料對試樣的促燒作用不是非常明顯。
  3. Study on the synthesis of corundum - mullite - gahnite multiphase materials by one - step sintering process using high purity raw materials showed that the more the content of gahnite in multiphase materials, the high the volume expansion would be introduced in the system, which resulted in the sintering difficulty of the multiphase materials. while the content of gahnite was controlled about 30wt % and the content of mullite was about 70wt %, the densified multiphase materials can be obtained after fired at 1600 or 1700

    採用高純原料一步合成剛玉?莫來石?鋅鋁尖晶石復相材料研究表明：復相材料中鋅鋁尖晶石含量越高，則合成鋅鋁尖晶石時產生的體積膨脹越大，燒結性也就越差；當鋅鋁尖晶石含量為30wt ，莫來石含量較高為70wt左右時，在1600或1700燒后都能得到顯微結構較為緻密的復相材料。
  4. Effects of - al2o3 nano - powder additions on sintering of high purity corundum brick

    3納米粉對高純剛玉磚燒結性能的影響
  5. Results from this thesis concluded that numerical simulation can be applied to study " effect of varying the incident angle of dilution air on the performance of the gas turbine combustor "

    本文針對某種航空發動機火焰管模型結構，採用數值模擬方法對「摻混空氣噴射角度對燃燒室性能的影響」這一問題進行了探討。
  6. The questions the researcher concerned are which system will be chosen and how to obtain the good lithium ionic conductor materials, which is the basic departure of the paper. the addition of second phase in composite can change the interface structure and the conduction mechanism, improve the matrix conductivity and other function such as the sintering, crisping and so on, so the research of composites are an interesting field of the ionic conductors. the synthesis of lithium ionic conductor is often by solid state reaction, but this method needs high temperature and leads to the volatility of lithium which not only causes the drift of the compounds but gets the no well - distributed materials

    研究者所關注的問題是選擇新的體系進行研究，以期得到性能更好的鋰離子導體材料，這也正是本論文的基本出發點；復合離子導體中第二相的加入改善了基質的界面結構和導電機制，不僅可以提高基質材料的電導率，還可以在一定程度上改善材料的其它性能，如燒結性能、脆性和機械強度等。因此復合材料的研究是離子導體一個有廣闊前景的發展方向；合成鋰離子導體，特別是成分復雜的體系以傳統的固相合成法為主，但這種方法需要較高的溫度，容易引起鋰的揮發，從而造成產物組成的偏移，而且不易得到顯微結構均勻的材料。
  7. Experimental research on sintering performances of imported powder iron ores with high and medium ignition loss

    中高度燒損進口鐵礦粉燒結性能試驗研究
  8. The effects of additives on the properties of phosphate - bonded unburned alumina bricks

    添加物對磷酸鹽結合高鋁不燒磚性能的影響
  9. In conclusion, the method of adding a function layer through type winding will improve the insulating performances greatly while maintaining its original ablative performances. compared with other technical schemes, no special equipment is needed. hence, sufficient raw materials and feasible process enable its promising prospect

    通過以上研究，得到以下結論：採用布帶纏繞工藝、在防熱層內添加隔熱功能層的方案能顯著提高其隔熱性能，同時保持原有防熱套的燒蝕性能和其他物理機械性能，該方案對后續工序無顯著影響。
  10. Experimental study on blending australian fine ore to baogang sinter

    印度果阿礦粉的燒結性能初探
  11. While adding 1 % binder the preferable target was produced, and the density was 4. 89g. cm - 3, which was 88 % of the theoretic density of the licoo _ 2 with ar as the sputtering gas, the technics of rf sputtering to produce the licoo _ 2 film were studied systematically

    在冷壓燒結方法制備licoo _ 2靶材的過程中，燒結前添加了不同量粘結劑，就綜合純度和粘結性能兩方面考慮，加入1 %的粘結劑較為理想。所制備的licoo _ 2靶材密度為4 . 89g / cm3 ，達到licoo _ 2理論密度的88 % 。
  12. On the basis of annlyzing the main domestic cocurrent combustor, we adopted the up and down - shade - technology to reform the combustonafter researching the characteristics of main coal and its affecting factors, i. e., density of coal dust, granularity of coal dust, firing characteristics, alteration of coal, we put forward the scheme of coal ' s configuration and reforming plan about structure of combustor and its disposal type. finally, we make a debugging of cool and hot performance and operation optimizing

    因此，本文在分析目前國內主要直流燃燒器性能的基礎上，選用了上下濃淡燃燒技術，改造了燃燒器；通過對現場燃燒的主要煤種特性及煤粉濃度、煤粉細度、著火特性、煤種變動等的分析研究，提出了配煤方案和燃燒器的結構、布置方式改造方案；最後進行了冷、熱態性能與運行優化調試。
  13. In the process of making 95 alumina ceramics, selected five kinds of alumina powder and studied the influence of different alumina powder on the sintering properties and mechanic properties of 95 alumina ceramics, moreover, selected the most agreeable alumina powder according to the apparatus for granularity analysis and scanning electron microscope ( sem ). the influence of different sintering temperature on the sintering mechanic properties, the microstructure of 95 alumina ceramics were investigated by adding y2o3 and la2o3 as two kinds of rare earth additives in alumina ceramics. the results indicated that the additive of la2o3 could improve the properties of 95 alumina ceramics more effectively and could get fine grain and tabular alumina that can enhance the strength of the material

    選用了五種al2o3粉料，研究了其對95al2o3瓷燒結性能和力學性能的影響，並結合粒度分析儀sem對al2o3粉料進行優選；通過添加y2o3 、 la2o3兩種稀土添加劑，研究了不同燒成溫度對95al2o3瓷的燒結性能、力學性能及顯微結構等的影響，結果表明：添加la2o3可以有效提高95氧化鋁瓷燒結性能和力學性能，形成細晶和板狀氧化鋁瓷的顯微結構；通過對比不同氧化鋁粉料制備氧化鋁瓷燒成溫度曲線與燒結性能的關系，確定最佳的燒成溫度范圍為1570 ~ 1600 。
  14. Effects of additives on the sintering properties and electric conductivity of nife2 o4 spinel anode materials

    摻雜對鎳鐵尖晶石陽極材料燒結性能及電導率的影響
  15. Perovskite - type complex oxides of la1 - xcaxcro3 compositions are attracting growing attention because of their superior electronic conductivity and excellent chemical stability in both oxidizing and reducing atmospheres, which makes them promising candidate materials for many important applications, such as interconnectors for solid oxide fuel cells ( sofc ), heating elements for high temperature furnaces, and current collecting electrodes in magneto - hydrodynamics ( mhd ). in this dissertation, the gnp ( glycine - nitrate process ) method has been employed to synthesize la1 - xcaxcro3 oxides. the synthesis and preparation, sinterability, electrical conducting properties and thermal expansion properties of la1 - xcaxcro3 oxides have been investigated

    本文採用gnp （ glycine - nitrateprocess ）法制備了la _ （ 1 - x ） ca _ xcro _ 3材料，對制備方法與工藝參數、材料燒結性能、電性能以及熱膨脹性能進行了研究，分析了ca ~ （ 2 + ）含量、粉體顆粒形態對材料燒結行為、燒結緻密化溫度的影響，並研究了ca ~ （ 2 + ）含量、粉體顆粒形態對材料晶體結構、顯微結構和物理性能的影響，其目的在於為該類高溫電子導體的進一步研究利應用提供實驗和理論依據。
  16. Sintering properties and reaction process of - sialon alumina silica composite in coke bed at high temperatures

    2系材料燒結性能及反應過程研究
  17. It is now known that using powder with fine particle size and homogeneous distribution of ingredients can improve the sinterability of a powder compact, especially in w - cu system, for which the dominant sintering mechanism is particle re - arrangement during the liquid - phase sintering

    而超細、混合均勻的粉末能較大地改善粉末的燒結性能，對以顆粒重排機制為主導的w - cu系液相燒結尤為如此。
  18. The property and micro structure of the resulting powders was studied, with emphasis on the sinterability of different w - cu powders, and the effects of properties of w - cu powders on the microstructure, the mechanical and physical properties of the sintered w - cu parts

    本文對超細w - cu復合粉體的制備及燒結工藝對其燒結性能和組織結構的影響進行了研究，以探索一種制備高性能超細晶粒w - cu復合材料的新途徑。
  19. Effect of additives on the sintering of fired magnesia - calcium brick

    添加劑對燒成鎂鈣磚燒結性能的影響
  20. The physical properties were measured using x ray diffraction analyzing, sem observing, fracture toughness and fracture strength measuring, micro - hardening and density detection etc. the results display that the relative densities are above 98 % for all the samples, especially reaches 99. 8 % for the sample added 2vol % sic nano - particles

    在sic加入量為2vol %時，由於分散比較均勻，對樣品燒結性能影響不大，相對密度可達99 . 8 % 。在未加sic時，四方zro2的含量最高為50 . 5vol % 。隨sic加入量的增加，四方相zro2的含量呈下降趨勢。
分享友人
分享到 Line

分享到臉書