燒結純鐵 的英文怎麼說

中文拼音 [shāojiēchúntiě]
燒結純鐵 英文
pomet
  • 燒 : Ⅰ動詞1 （使東西著火） burn 2 （加熱或接觸某些化學藥品、放射性物質等使物體起變化） cook; bake; hea...
  • 結 : 結動詞（長出果實或種子） bear （fruit）; form （seed）
  • 純 : 形容詞1 （純凈; 不含雜質） pure; unmixed 2 （純粹; 單純） simple; pure and simple 3 （純熟） skil...
  • 鐵 : Ⅰ名詞1 （金屬元素） iron （fe） 2 （指刀槍等） arms; weapon 3 （姓氏） a surname Ⅱ形容詞1 （形容...
  1. The raw materials, the composition, the time of milling, the calcining temperature, the different additives, the sintering temperature and the sintering parameters were investigated. the result showed : it was advantaged to obtain high initial permeability mnzn ferrite with stable frequency characteristic using high - purity raw materials ; in order to obtain mnzn ferrite with high properties, we must control strictly the composition ; it could improve the properties of mnzn ferrite by optimizing calcining temperature. the lower calcining temperature made the permeability higher, and the higher calcining temperature could promote the frequency characteristic of permeability ; we chosen the right time of milling according to the requirement of power diameter ; in order to improve the properties of mnzn ferrite, it is necessary to add effective additives. in this dissertation, the influence of bi2o3 、 moo3 、 k2co3 、 co2o3 were investigated ; the sintering temperature, the time of heat - retaining and sintering parameters were the key factors of preparing high permeability mnzn ferrites

    研究結果表明:採用高純度的fe2o3有利於獲得高起始磁導率且頻率特性優良的鐵氧體;為了制備所需性能的鐵氧體，需要嚴格控制配方中各種原材料的含量，優化配方;由於粉體活性受預燒條件的影響，所以對不同要求的鐵氧體選擇的預燒條件就不一樣，適當降低預燒溫度有利於獲得較高的起始磁導率，而為了獲得良好的頻率特性可以適當地提高預燒溫度;根據對粉體顆粒粒徑的不同需求，可以選擇不同的球磨時間;而有效的添加劑是改善材料性能的必要條件，本文在添加劑的研究中主要對bi2o3 、 moo3 、 k2co3 、 co2o3的影響分別作了詳細地討論;燒結溫度、保溫時間和燒結氣氛是高磁導率mnzn鐵氧體制備最關鍵的工藝，適宜的燒結工藝可以獲得理想微結構和組成，從而得到高性能的鐵氧體材料;而從材料的微結構上來看，要提高材料的截止頻率，就要適當地細化晶粒、增加晶粒內部的氣孔。
  2. Specifications for sintered iron soft magnetic materials

    燒結純鐵軟磁材料.技術條件
  3. A study of combustion of the furnace in high - speed - wire factory of tangshan steel company is made, from which the conclusion is acquired, that is the process is a casual process of nonlinear and distributed parameter with big inertia, pure lag and casual disturbance. this makes prepare for further studies

    研究了唐山鋼鐵公司高線廠的蓄熱式加熱爐的燃燒情況，得出了結論，即其過程為大慣性、純滯后、受隨機干擾的非線性分佈參量過程，為后繼的研究作了準備。
  4. The main research work and contribution of this dissertation are as follows : l. a study of combustion of the furnace in high - speed - wire factory of tangshan steel company is made, and conclusion is acquired, that is the process is casual process of nonlinear and distributed parameter with big inertia, pure lag and disturbed by casual factors

    本文的主要研究的內容有如下幾個方面： 1研究了唐山鋼鐵公司高線廠加熱爐的燃燒情況，得出了結論，即其過程為大慣性、純滯后、受隨機干擾的非線性分佈參量過程，為后繼的研究做了準備。
分享友人
分享到 Line

分享到臉書