爆炸載荷 的英文怎麼說

中文拼音 [bàozházǎi]
爆炸載荷 英文
explosive load
  • : 動詞1. (猛然破裂或迸出) explode; burst 2. (放在滾油里快炒) quick-fry
  • : 炸動詞1. (在油里弄熟食物) fry in deep fat or oil 2. [方言] (焯) scald (as a way of cooking)
  • : 載Ⅰ名詞(年) year : 一年半載 six to twelve months; six months to a year; 三年五載 three to five ...
  • : 荷名詞(蓮) lotus
  • 爆炸 : explode; blast; blow up; bomb; burst; detonate; explosion; fulmination; out-burst
  • 載荷 : load; loading載荷變化 load fluctuation; variation in load; 載荷裝置 load device
  1. Impulsive loads for structural tests have been generated by explosive cartridges or by small rockets.

    人們曾用過彈藥筒的或用小型火箭來產生結構試驗所需的脈沖
  2. Non - die explosive forming of thin - wall spherical vessel

    與沖擊下結構和材料動態響應研究的新進展
  3. Dynamic response of rectangular air - back plate to underwater exploding loading

    水下爆炸載荷作用下氣背固支方板的動態響應分析
  4. Finite element of dynamical bond stress of insert rebar under explosive loads

    作用下植筋粘結應力有限元分析
  5. This paper focuses on the research of the stress mechanism of the ribbed shell structure in statics, dynamics and under the explosive load on the basis of the engineering practice of cave depot of single aircraft. in this paper, according to the classical shell theories, the basic differential equilibrium of the ribbed shell structure and the finite element analysis of 3d rippled plate are established, in which the function of annular ribs reinforcement bars and 3d ripped steel plates are distributed in the range of the steel, and the functions along the longitude direction of tension, bending, and torsion are neglected ; applied with dynamic analytical theory, the dynamic model of ribbed shell structure and the analytical theory model of elastic - plastic are set up ; the triangle series method is used to solve the displacement and stress under the distributed load and the concentrated load of the ribbed shell structure

    本文以軍用機場地面單機掩蔽庫工程建設為工程背景,首次對內襯三維波紋鋼板混凝土拱型復合結構的受力機理進行了靜力、動力和的分析研究。根據將橫肋、鋼筋及三維波紋鋼板的作用均勻分佈在殼體范圍內的情況,忽略橫肋、鋼筋及三維波紋鋼板沿殼體母線方向的抗拉、抗彎及其抗扭作用,首次推導出了內襯三維波紋鋼板混凝土殼體的微分平衡方程,建立了有限元計算模型,並採用三角函數法,求解了三維波紋鋼板混凝土拱型復合結構在分佈和集中作用下的位移響應和應力響應,並與普通殼體進行了比較。
  6. In this paper at last. the localized anti - collapsing effect of the cave depot of single aircraft under the explosive load is calculated and analyzed. the explosive result shows that 3d ripped steel plate and ribbed shell structure are effective to raise the capacity of anti - collapsing of the protective structures

    對飛機單機掩蔽庫工程在作用下,抗局部震塌效應進行了計算分析,模擬直接命中的試驗結果表明:鋼筋混凝土內襯三維波紋鋼板組成拱型復合結構,是提高防護結構抗震塌破壞的一種十分有效的措施。
  7. In numerical simulation, the elastic zone is only considered and the effect of blasting waves on the rock medium, after attenuating through crushing zone and ruptured zone, becomes an input load

    數值模擬僅考慮彈性區域,波對巖石介質的作用經粉碎區、破裂區衰減后成為輸入
  8. Damage analysis of concrete subject to explosive loading

    爆炸載荷對混凝土毀傷效應分析
  9. Study on failure mode of stiffened plate and optimized design of structure subjected to blast load

    爆炸載荷作用下加筋板的失效模式分析及結構優化設計
  10. The major research areas of a ship against non - contact underwater explosion include four sectors, namely, ( 1 ) the characteristics of fluid field disturbed by an underwater explosion ( loadings of underwater explosion ) ; ( 2 ) the analysis of transient fluid - structure interactions, and the corresponding dynamic responses of the ship ; ( 3 ) safety assessment of the ship structure undertaking the elastic - plastic dynamic responses ; and ( 4 ) determination of the shock environment imposed on the shipboard equipments, and evaluation of shock protection design

    即非接觸水下的流場特徵(水下爆炸載荷) 、瞬態流場與結構相互作用所決定的艦船動響應分析方法、以彈塑性動變形響應分析為依據的艦船結構水下安全性評估與防護技術、以船體結構動響應為輸入條件的船用設備沖擊環境的確定方法及相應的設備抗沖擊設計分析方法。
  11. Studies on the dynamic fracture of thin cylindrical shells subject to internal explosive loading

    內部爆炸載荷下薄壁柱殼膨脹斷裂的研究
  12. Dynamic response of pressure - shock - resistant vessel subjected to gas explosion load

    氣體爆炸載荷作用下抗容器的動力學響應
  13. By employing cole ' s classical theory of bubble dynamics, the motion of bubble produced by the underwater explosion and the corresponding bubble pulsating pressure are calculated. a profile function of the shock wave and its parameters are determined according to the principle of wave profile similitude and the equality of impulses. finally an analytic formula is derived to simulate the whole time history of the pressure from the front shock wave to the bubble pulsation, representing the fluid loadings of the underwater explosion

    木文首先應用庫爾的經典水下氣泡運動理論計算出氣泡的運動和脈動的壓力波形,再依據波形相似的原則尋找波形模擬函數,用沖量相等的原則確定波形參數,得出了從沖擊波到氣泡脈動壓力整個過程對水下爆炸載荷進行模擬的解析公式。
  14. This paper using ls - dyna finite element analysis program to model the damage process of oilcan steel plate under no. 3 rock explosive load, analysing the effect of the mass and shape of explosive to steel plates extent of damage and shape of crevasse

    利用ls - dyna有限元程序,模擬了油罐鋼板在3 (上標# )巖石爆炸載荷下的破壞過程,分析了藥質量、藥柱形狀對鋼板破壞程度和破口形狀的影響。
  15. The fluid loadings of underwater explosion excite the dynamic responses of the ship. no reasonable responses of the ship to underwater explosion may be predicted without correct description of the fluid loadings

    水下爆炸載荷是艦船水下動響應的激勵源,爆炸載荷的準確描述是保證艦船動響應分析精度的基礎。
  16. It is of great significance for the defend engineering that the absorbing energy of the filled fluid structure on the action of the explosion load

    摘要研究注液結構在爆炸載荷作用下的能量吸收,對于防護工程有著重要的意義。
  17. With finite element method, the influences caused by hydrostatic pressure to deformation and failure model of ring - stiffened cylindrical shells are analyzed

    摘要應用有限元法,分析靜水壓對受水下爆炸載荷時的加筋圓柱殼體的變形及破壞模式的影響。
  18. By comparing failure modes of shell caused by undex with and without outer hydrostatic pressure, their influences on loading effects are obtained

    通過比較有和沒有外部壓力時,不同沖擊波下結構的破壞形式,得出外部水壓對耐壓結構受爆炸載荷時響應的影響。
  19. Considering cavitation and the coupling of solid and fluid, the structure responses caused by combination of underwater explosion and hydrostatic pressure are simulated through modeling shell structure and its outer water

    通過對殼體結構及外部水域進行建模,並考慮流固耦合及空泡因素,模擬出結構受水下爆炸載荷及靜水壓力聯合作用下的響應。
  20. The comparisons of the results predicted by this formula, and those given by cole ' s theory for the explosions with different explosion weight ( l ~ 1000kg ) in different explosion depth ( 12 ~ 150m ), show that this formula presents satisfactory precision, and can be employed for engineering predictions of the underwater explosion loadings

    利用該公式進行水下12 150m處1 1000kg藥量產生的爆炸載荷,並與數值計算結果比較,表明該公式具有良好的預報精度,可供工程使用。水下作用下艦船的動響應理論是艦船抗沖擊設計的基礎。
分享友人