牙齒移位 的英文怎麼說

中文拼音 [yáchǐyíwèi]
牙齒移位 英文
drifting tooth
  • 牙 : 名詞1. （牙齒） tooth 2. （象牙） ivory 3. （形狀像牙齒的東西） tooth-like thing 4. （姓氏） a surname
  • 齒 : Ⅰ名詞1 （牙; 牙齒） tooth 2 （物體上齒形的部分） a tooth like part of anything 3 [書面語] （年齡...
  • 移 : Ⅰ動詞1. （移動） move; remove; shift 2. （改變; 變動） change; alter Ⅱ名詞（姓氏） a surname
  • 位 : Ⅰ名詞1 （所在或所佔的地方） place; location 2 （職位; 地位） position; post; status 3 （特指皇帝...
  • 牙齒 : tooth; cusp
  • 移位 : bit shift
  1. Results : 1 ) under the same condition of loading, the stress and displacement of mesial occlusal rest design was smaller than that of distal occlusal rest design in abutment teeth and soft tissue under the base, however, the magnitude in the soft tissue under base was bigger. 2 ) when a distributed vertical load was applied to the artificial tooth abutment teeth regions, the stress distribution was similar to that of concentrated load in the artifitial tooth, and stress magnitudes were higher. 3 ) under the condition tested, the mesial occlusal rest design caused the stresses that were more in line with the long axes of the abutment teeth than did the distal occlusal rest design

    結果： 1 ）在同一加載條件下，近中（牙合）支托設計與遠中（牙合）支托設計相比，基牙及基托下軟組織的應力和位移值減小；基托下軟組織的應力和位移值大於基牙； 2 ）基牙及義齒整體加載時，各基牙應力分佈規律與人工牙加載相同，但應力值增大； 3 ）近中（牙合）支托設計使基牙受力更趨于軸向。
  2. 3. solve the key problem during the 2d engaging design of the tri - cone rock bit. if you move or rotate any insert with mouse, the other two inserts in the same cycle change same positions

    解決了三牙輪鉆頭二維嚙合設計中的關鍵技術?聯動布齒，通過鼠標移動和旋轉任意一個牙齒，同一齒圈上的其它兩個牙齒做相同的位置變動。
  3. The 16 ) crowns of the teeth move very quickly, but braces are usually worn for about two years, because it takes much longer for the roots to move into place

    齒冠移動的速度很快，但是牙套通常要配戴大約兩年，因為牙根移到正確的位置需要長得多的時間。
  4. Methods : this experiment used finite element analysis ( fen ) in the design of mesial and distal occlusal rest of distal - extension partial removable denture and to test the magnitude of stress and displacement of abutment teeth and soft tissue under the base when under the vertical force of two conditions

    方法：採用有限元法在末端游離缺損義齒的有限元模型上作遠中、近中（牙合）支托設計，分別在人工牙及修復后的牙列（包括義齒及基牙）上作垂直向加載，測試基牙及基托下軟組織的位移及應力值，通過測試結果作對比分析。
分享友人
分享到 Line

分享到臉書