特性曲線值 的英文怎麼說

中文拼音 [tèxìngqūxiànzhí]
特性曲線值 英文
characteristic curve value
  • 特 : Ⅰ形容詞（特殊; 超出一般） particular; special; exceptional; unusual Ⅱ副詞1 （特別） especially; v...
  • 性 : Ⅰ名詞1 （性格） nature; character; disposition 2 （性能; 性質） property; quality 3 （性別） sex ...
  • 曲 : 曲名詞1 （一種韻文形式） qu a type of verse for singing which emerged in the southern song and ji...
  • 線 : 名詞1 （用絲、棉、金屬等製成的細長的東西） thread; string; wire 2 [數學] （一個點任意移動所構成的...
  • 特性 : characteristic（s）; character; performance; features; properties; behaviour; response; character...
  • 曲線 : [數學] curve; bight; bought; profile; net曲線板 french curve; irregular curve; curve board; splin...
  1. This paper deriving the theory work inflection point in the static stage characteristics curve of small measurement range linear dimension measurement. by the way of high pressure and back pressure pneumatic measure and designed the parameter of the mainly and measure spray head, which are the key component in the spray head - baffle pneumatic sensor. the different groups for the main - spray head and the measure spray head, will effect the dynamic and static stage characteristic parameter. the author have done contrast experiment and optimization design to test and verify the theory derivation whereby made the rang of show valve of pneumatic measure system measure range up to 40 u m, the sensitivity up to 100mv / u m, resolution up to 0. 05 p m, the uncertainly of measure is less than 0. o2 u m, satisfaction of requirement of groups the carboy hatch thickness size precise measure of soft shims

    對高壓背壓式氣動測量用於小量程線性尺寸測量的靜態特性曲線的理論工作拐點進行了推導，對氣動測量系統中的噴嘴-擋板型氣動傳感器中的關鍵部件? ?主噴嘴和測量噴嘴的參數進行了理論設計，對主噴嘴和測量噴嘴的不同組合，將影響測量系統靜、動態特性指標的噴嘴參數進行了對比實驗和優化設計，並通過實驗驗證了理論推導，從而使氣動測量系統量程的示值范圍達到40 m ，靈敏度達到100mv m ，解析度達到0 . 05 m ，測量不確定度小於0 . 2 m ，滿足了壓縮機缸蓋軟體墊片厚度尺寸精密測量分組的要求。
  2. A model of the interface state density distribution near by valence band is presented, and the dependence of the threshold voltage on temperature, the c - v characteristics and the subthreshold characteristics are predicted exactly with this model ; the effects of s / d series resistance on the output characteristics, transfer characteristics and effective mobility of sic pmosfets are analyzed. thirdly, the output characteristics and the drain breakdown characteristics are modeled with the procedure medici. the output characteristics in the room temperature and 300 ? are simulated, and the effects of gate voltage. contact resistance, interface state and other factors on sic pmos drain breakdown characteristics are analyzed

    提出了一個價帶附近的界面態分佈模型，用該模型較好地描述了sicpmos器件閾值電壓隨溫度的變化關系、 c - v特性曲線以及亞閾特性曲線；分析了源漏寄生電阻對sicpmos器件輸出特性、轉移特性以及有效遷移率的影響；論文中用模擬軟體medici模擬了sicpmos器件的輸出特性和漏擊穿特性，分別模擬了室溫下和300時sicpmos器件的輸出特性，分析了柵電壓、接觸電阻、界面態以及其他因素對sicpmos擊穿特性的影響。
  3. ( 3 ) process and analyze the experimental data, figure out the temperature characteristic curves and fix the exact value of each sensing fbgs in the network

    （ 3 ）對實驗數據進行了處理和分析，得出了傳感網路中各個測量光柵的溫度一波長特性曲線，最終確定了其溫度值。
  4. But, the measured - data is a very great quantity and every data contain all data of 1 - 25 harmonic, measured time can have hours to days. the count by hand is very heavy and over - elaborate, sometimes the statistics results is error. it won " t reach the analysis purpose and don " t obtain the curve of harmonic oscillation characteristic in a row frequency range

    可是，測試數據經常是大量的，每一組數據又包含從基波到25次諧波的所有數據，測試時間可能是幾個小時，有的甚至是幾天時間，這樣的工作量由人工完成是非常繁重的，又是非常繁瑣的，有時還統計不出正確的數值，起不到應有的測試分析目的，更無法獲得連續頻域內的諧波諧振特性曲線。
  5. We think that the indirect exchange is in relation to the magnetic field, and gain the coefficient relevant to the applied field. the result calculated using the coefficient is in good agreement with the experimental result. that also further perfects the theory of the microscopic mechanism of leading to the anisotropy of ergag

    研究認為間接交換作用的大小與外磁場的大小有關，得到了和外磁場有關的系數，由此計算的磁化強度特性曲線與實驗值符合情況有所改善，進一步完善了導致ergag磁性各向異性產生的微觀機制。
  6. Based on the experimental data of rotor steel 1crmov in the loading of low - cycle fatigue at high temperature, the strength behavior and the fatigue life curve of this material at 550 have been achieved. meanwhile, with respect to three kinds of notched bar, their material damage assessment method under multiaxial stress condition is discussed

    本文在1crmov材料的高溫低周疲勞實驗數據進行了整理和統計的基礎上，得到了材料的疲勞強度特性曲線和疲勞壽命曲線，同時對三種不同缺口形式的圓柱形試件進行了多軸應力狀態下的材料損傷的研究，並通過數值計算方法進行了疲勞壽命評估。
  7. Some types of high value resistor have another imperfection : they have a slightly non - linear voltage / current curve and do not obey ohm ' s law accurately

    有些類型的高阻值電阻器還有另外一個缺陷? ?其伏-安特性曲線呈輕微的非線性，並不完全符合歐姆定律。
  8. Abstract : in this paper, the setting scheme of the current differential protection based on sampled values using fault component is investigated. the setting schemes of the resistance coefficient and the least trip differential current are discussed in detail. the probable protection setting values for the hv transmission lines are described. it testifies the feasibility for the applications of the protection to the hv transmission lines

    文摘:對基於故障分量的采樣值電流差動保護制動特性曲線的整定方法進行了研究，詳細討論了其制動系數和最小動作電流的整定方法，同時對該保護在輸電線路中的應用進行了初步的估算，說明了該保護的優異性能。
  9. The topologies family include single four - quadrant power switch mode, push - pull mode, half - bridge mode, and full - bridge mode circuits. taking full - bridge mode circuit as an example, the operational mode, steady principles, transient voltage feedback control strategy of the converter are investigated. the output characteristic curve, the design for the key circuit parameters and the reference sinusoidal circuit which is synchronous with the signal of n or 1 / n times line voltage frequency are given

    該電路拓撲族包括單四象限功率開關式、推挽式、半橋式、全橋式電路，以全橋式電路為例分析研究了這類換器工作模式、穩態原理與電壓瞬時值反饋控制策略，給出了變換器的外特性曲線、關鍵電路參數、與電網電壓n倍頻或n分頻信號同步的基準正弦電路的設計。
  10. Subsequently, the method is verified by a numerical example of a simply supported beam, and some graphs depicting the driving point impedance characters of the simple supported cracked beam are drawn

    以一裂紋簡支梁為例進行了數值分析，得到了裂紋簡支梁的驅動點阻抗特性曲線。
  11. By numerical work, the time evolvement curves of the corrected solution, phase orbits and v - i characteristics demonstrated the deterministic chaos

    通過數值方法給出解的時間演化曲線、相軌道和伏安特性曲線，它們描述了系統中存在的確定性混沌。
  12. For the cranes which arm angle and length is alterable, its utmost hoist competence is changeable. so we must found the characteristic curve math model of the crane. then the plc programme can provide protection for the crane working according to the math model

    對于臂桿角度和長度可變的起重機而言，其起吊重量極限值是變化的，這就要求事先建立這類起重機的起重特性曲線的數學模型，然後再讓plc程序按照給定的數學模型對起重機進行安全作業保護。
  13. Numerical simulation and analysis of ground reaction curve

    隧道圍巖特性曲線數值模擬與分析
  14. Finally, the paper realize the convenient dialog interface and hydraulic machine ' s test data processing mainly introduces, analyses the multinomial fitting and spling interpolation mathematics models and solves the solution and drawing of constant efficiency value curve and 95 % confining curve in comprehensive specific property curve

    實驗臺的軟體系統實現了友好的人機對話，實驗數據處理部分主要介紹、分析了多項式擬合模型和三次b樣條插值模型，實現了模型轉輪綜合特性曲線中等效率曲線的求解與繪制以及95出力限制線的繪制。
  15. Server workload patterns usually show specific spikes and if you can find servers that spike at very different times of day, although average workload would suggest their workloads could not be combined, more sophisticated analysis would suggest they can

    服務器負載特性曲線通常會顯示具體峰值，假定要合併的服務器24小時內是在不同時間出現負載峰值，那麼即便平均負載顯示它們無法進行負載合併，但如果進行更細致的分析，將有可能發現負載合併是可行的。
  16. In the section of theory, we mainly studied optical parameter effect, discussed physical mechanism of optical parameter laser and normalized coupled wave equation and got the solution. we also carried out the analysis of gain mode of optical parameter oscillation, studied the threshold condition, analyzed output characteristics and then achieved characteristic curve

    本文理論部分主要作了有關光參量效應方面的研究，探討了光參量振蕩器的物理機制、參量振蕩的歸一化耦合波方程，求解得到了參量振蕩器的耦合波函數，同時對光參量振蕩的增益模式進行了分析，研究了使參量振蕩的閾值條件，並對光參量振蕩器的輸出特性進行了分析，得到了特性曲線。
  17. In this paper calculation methods of various characteristics curves considering magnetic field nonlinear effect of synchronous generators is systematically studied. the comparison between the results and those without consideration of nonlinear effect is given. the magnetic field nonlinear effect on the operating characteristics is analyzed and the possible factors causing the nonlinear phenomenon is presented

    本論文系統地研究了同步發電機在考慮磁場非線性的影響下各種特性曲線的計算方法，並與不計磁場非線性時的結果進行比較，分析了磁場非線性對同步發電機運行特性的影響以及可能引起磁場非線性的因素，並研究在考慮三元變量作用下採用插值法估算同步發電機的勵磁電流和功角。
  18. Taking single four - quadrant power switch mode circuit as an example, the operational mode, steady principles, transient voltage feedback control strategy, the auxiliary switching power supply and parallel technology of this kind of converters are investigated. the output characteristic curve and the design for the key circuit parameters are given

    以單四象限功率開關式電路拓撲為例，分析研究了這類變換器工作模式、穩態原理與電壓瞬時值反饋控制策略，給出了變換器的外特性曲線、關鍵電路參數、機內輔助開關電源的設計，對電流源高頻交流環節ac ac變換器並聯擴容技術進行了研究。
  19. Taking single four - quadrant power switch mode circuit as an example, the operational mode, steady principles, transient voltage feedback control strategy of current mode ac - ac mode ac / ac converters with high frequency link are investigated. the output characteristic curve and the design for the key circuit parameters are given

    以單四象限功率開關式拓撲為例，分析研究了電流源交?交型高頻環節ac ac變換器的工作模式、穩態原理與電壓瞬時值反饋控制策略，給出了變換器的關鍵電路參數的設計準則和變換器的外特性曲線。
  20. The estimation procedure is based on the steady - state characteristics versus slip curves. the sum of squares of differences between calculated and experimental characteristics is employed as the fitting criterion. the machine parameters are obtained by minimizing the least - squares cost function using genetic algorithms

    該方法利用電機穩態特性曲線，以特性計算值和實驗值的擬合誤差的平方和作為判斷準則，通過應用遺傳演算法最小化二乘準則函數來獲取電機參數。
分享友人
分享到 Line

分享到臉書