獨立導彈系統 的英文怎麼說

中文拼音 [dǎodàntǒng]
獨立導彈系統 英文
autonomous missile system
  • : Ⅰ形容詞(一個) single; only; sole Ⅱ副詞1 (獨自) alone; by oneself; in solitude 2 (唯獨) only...
  • : 動1 (站) stand; remain in an erect position 2 (使豎立; 使物件的上端向上) erect; stand; set up...
  • : 動詞1. (引導) lead; guide 2. (傳導) transmit; conduct 3. (開導) instruct; teach; give guidance to
  • : 彈名詞1. (彈子; 小球形的東西) ball; pellet 2. (內裝爆炸物, 具有破壞和殺傷能力的東西) bullet; bomb
  • : 系動詞(打結; 扣) tie; fasten; do up; button up
  • : Ⅰ名詞1 (事物間連續的關系) interconnected system 2 (衣服等的筒狀部分) any tube shaped part of ...
  • 獨立 : 1. (單獨站立) stand alone 2. (自主自立; 不受人支配) independence 3. (不依靠他人) independent; on one's own
  • 導彈 : guided missile
  • 系統 : 1. (按一定關系組成的同類事物) system 2. (有條理的;有系統的) systematic
  1. This article describes a way of special ultrasonic system which monitors thermal stress in seamless welded rails. this monitoring system is a non destructive testing system, which adopts avr mcu and high - precise time chip processing as the core of it, and adopts the critically refracted longitudinal wave as the object of measuring. my studying focuses on the theory of the monitoring system, which will be listed in this arctile : according to the snell theory, the theory of motivating of critically refracted longitudinal wave is described in details, and the finite element software is used to emulate the propagating course. the formulas of calculating the pts of swr are taken from the acoustoelasticity theory, and the calculating the parameters is introduced. according to assemble materials, three kinds of ways of monitoring the pts of swr using critically refracted longitudinal wave are described, which are measuring the sound - time in changeless distance, ultrasonic critical - angle refractomery and frequency spectrum, the first way of ways is used in this experiment system. the factors, which effect the monitoring system, are assaid in some degree based

    本文的研究工作重點在無縫焊接鋼軌溫度應力測量的理論模塊,包括根據snell原理,研究極限折射縱波的激發機理,並使用有限元軟體ansys進行模擬;根據聲性理論以及公式推出計算無縫焊接鋼軌中的溫度應力的公式,並對其中參數的求解方法進行介紹;根據收集的資料,介紹了三種使用極限折射縱波測量無縫焊接鋼軌溫度應力的方法,即固定距離測量聲時法、臨界角折射法和頻譜分析法,本實驗使用的是第一種;根據實驗經驗以及相關資料,分析了影響極限折射縱波測量溫度應力的幾個因素,並提出了相應的解決方法;根據實驗的需要,設計並加工出相關配套的實驗設備,包括實驗鋼塊、有機玻璃楔塊、固定件、載荷外框裝置等。
  2. According to the requirements of real - time simulation, this thesis build the independent models of missile weapon systems for numerical simulation considering the independence and coupled relations of physical subsystems or parts and try to reduce the coupled degree. the main content of this thesis include : firstly, the missile weapon systems are divided into several subsystems according to function, and the interface protocols between subsystems

    本文針對實時模擬的要求,以具有清晰的物理概念和足夠的物理性的物理或部件為基礎,充分考慮各子模塊的相對性和耦合性,盡可能的降低模塊間的耦合程度,建整個武器的模擬模型,用於武器的數字模擬。
  3. The characters of bank - to - turn control technology determine that the btt missile ' s mathematical model having kinematical coupling, aero dynamical coupling, inertial coupling and control coupling. so the widely used stt missile ' s autopilot, which is designed to be three - channel independent ca n ' t meet the btt missile ' s control need

    Btt控制技術的控制特點決定了btt的數學模型存在運動學耦合、氣動耦合、慣性耦合和控制耦合等多種耦合因素,因此目前側滑轉彎( stt )廣泛採用的自動駕駛儀三通道設計方法已不能滿足btt控制的設計要求。
分享友人