球晶 的英文怎麼說

中文拼音 [qiújīng]
球晶 英文
sphaerocrystal
  • 球 : 名詞1 （以半圓的直徑為軸 使半圓旋轉一周而成的立體; 由中心到表面各點距離都相等的立體） sphere; glo...
  • 晶 : Ⅰ形容詞（光亮） brilliant; glittering Ⅱ名詞1. （水晶） quartz; （rock） crystal 2. （晶體） any crystalline substance
  1. Both spherical and regular crystalline forms are relatively rare.

    球形的和規則的球晶形成相對來說很稀少。
  2. Pcl could form banded spherulites through blending with poly ( bisphenol a - co - decane ) lamellar structures of banded spherulites of poly ( s - caprolactone ) / poly ( vinyl chloride ) ( pcl / pvc ) blends were observed using tapping mode atomic force microscopy ( afm )

    利用原子力顯微鏡（ afm ）的輕敲（ tapping ）模式，系統地研究了聚-己內酯聚氯乙烯共混體系形成的環帶球晶表面形貌和片晶結構。
  3. The lamellae with edge - on and the flat - on orientation alternated to form the banded spherulites

    利用原子力顯微鏡原位觀察了環帶球晶界面的片晶生長。
  4. The thickness had some influence on the development of the banded spherulites : when the thickness reduced to some degree, pcl would develop chrysanthemum - like spherulites, which had no extinction rings or the maltese cross pattern under the crossed polarized optical microscopy. the results of the phase - contrast microscopy showed that growth speed of the chrysanthemum - like spherulites along the radius was not constant

    發現薄膜厚度對球晶的生長有一定的影響，當共混物膜薄到一定程度時， pcl不能形成環帶球晶，而是形成一種類似菊花狀的晶體，在偏光顯微鏡下看不到環帶，也沒有典型球晶所特有的maltese十字消光圖案。
  5. On the surface of phbv spherulite, some concentric ring like patterns will occur. based on the procedure of the formation of ring - like patterns, the possible mechanism is given

    在球晶的表面出現有同心圓環狀條紋，經實驗驗證為表面的不平整所導致，形成機理主要可能是結晶過程中的體積收縮。
  6. A reasonable mechanism of the concentric ring like patterns on the surface of phbv spherulite was given first. the segregation of hv content between cystal and amorphous parts was observed and the phenomena caused were discussed

    首次對phbv球晶表面觀察到的同心圓環條紋的成因作了合理解釋，揭開了這一現象形成的本質。
  7. The sgr ( spherulite growth rate ) of phbv is related to crystallization temperature. with the increase of temperature, sgr increase first then decrease. some sample ' s sgr will increase again at high temperature area

    Phbv的球晶生長速度與時間無關，隨溫度的升高有先上升後下降的趨勢，部分樣品在最後球晶速度會再次上升。
  8. And the spherulite growth rate of phbv is studied and the factors, which influence the growth rate and the formula of spherulite growth rate, were discussed

    並通過對phbv球晶生長速率的測定，對結。晶生長的速度方程及影響因素做出修正。
  9. The analysis of ir spectrum and melt flow index showed that the composite had a micro - crosslinking structure, and the analysis of dsc discovered there was - spherulite in the aggregate structure of the composite of pp

    紅外光譜分析和熔體質量流動速率的測定表明，復合材料體系產生了微交聯； dsc分析發現， pp材料的聚集態結構中含有球晶。
  10. The results from x - ray diffraction demonstrated that pp / mmtome was a fully intercalated nanocomposite, pp / mmtom and pp / ommt were partly intercalated nanocomposites, but the intercalation effect of pp / mmtom nanocomposite was better ; the crystallization characteristics of pure pp and pp / mmt nanocomposites were investigated by dsc, waxd and pom. the result of these testing showed that mmt nano - layers acted as nucleating agents for the crystallization of pp, the addition of mmt had effect on the crystallization process, leading the increasing of crystallization temperature crystallization rate and crystallinity, but also the dimension of spherulite reduced. but the formation of pp crystal did n ' t change, the formation of pp crystal in three pp / mmt nanocomposites and pure pp were a - form on the whole ; influences of three sorts of mmt on mechanical properties of pp / mmt nanocomposites were studied, as a result, the addition of mmt comprehensively improved mechanical properties of pp : notched impact strength, tensile strength and flexural properties were all increasing, but the extent of increasing were n ' t large

    通過xrd分析比較這三種pp mmt納米復合材料微觀結構得到， pp mmt _ （ ome ）屬于完全插層， pp mmt _ （ om ）與pp ommt的插層程度相近，但是pp mmt _ （ om ）相對較好；通過對純pp和三種pp mmt納米復合材料的結晶性能研究發現，蒙脫土納米片層對pp結晶產生明顯的異相成核作用，結晶能力增強，使pp的結晶溫度和結晶速率提高，結晶度增加，球晶晶粒細化，但是沒有改變pp的結晶形態，三種pp mmt納米復合材料的結晶形態都屬于晶；通過對pp mmt納米復合材料的力學性能測試得知，蒙脫土的加入全面提高了pp的力學性能，缺口沖擊強度、拉伸強度和彎曲性能都有一定程度的提高，浙江{ _業大學碩十學位論文摘要但是提高幅度都不是很大，不過ommt 、 mmtom和mmtc ） me三種蒙脫土對pp力學性能有著不同的改性作用，其中pp / mmtom最好， pp月邊mto崛次之， pp / ommt最低，這種情況主要是由蒙脫土對pp結晶性能的影響和蒙脫土的納米改性作用造成的。
  11. Dsc and x - ray diffraction results show that after pan - milling, the crystallinity and the size of micro crystals of pa6 decrease. melting point increases and crystallization temperature decreases

    表現為結晶度降低，微晶尺寸減小；熔融溫度降低，結晶溫度升高；球晶尺寸減小。
  12. The lamellae in different directions could join and stop growing by each other at the interface of spherulites, which lead the formation of defects

    在球晶的edge - on片晶生長前沿相遇時，形成片晶束。也有的片晶在互相接觸后停止生長，導致缺陷增多。
  13. Polarized optical microscopy and phase - contrast microscopy were used to observe the banded spherulites of poly ( e - caprolactone ) / poly ( vinyl chloride ) ( pcl / pvc ) blends. the ring spacing and regularity of the banded spherulites decreased with the decrease of the crystallizing temperature

    本文利用偏光顯微鏡和相差顯微鏡觀察了聚-己內酯聚氯乙烯形成的環帶球晶，環帶間距隨溫度的降低而減小，規整性亦隨之下降。
  14. Study on the spherulites of polypropylene

    聚丙烯球晶的研究
  15. The sample thickness declining, provided the number of nuclei per unit volume fix, the value of the avrami exponent n falls, but the values of vc and s almost do n ' t change. when the value of thickness reduce to the average diameter of entities, the turning point turn up after the course of crystallization has begun soon

    當單位體積內晶核數目不變時，樣品厚度h減小， n減小； v _ c和_ s值基本不變：當h降到小於等於體系內球晶的平均直徑時，在結晶最初期，會出現一個初期轉折點。
  16. The crystals of polypropylene were changed which induced by adding montmorillonite and p crystal of polypropylene was found in ppmn

    蒙脫土的加入誘導pp晶型發生轉變，生成了聚丙烯型球晶。
  17. From the pom photos of polypropylene sp herical crystal, we could see that the polypropylene spherical crystal were diminished obviously, which is one of the two reasons that toughness of ppmn was improved

    Pom照片表明， ppmn中pp球晶明顯細化，這與聚丙烯晶型的形成同為ppmn韌性提高的原因。
  18. The surface of the pcl / pvc banded spherulites presented to be concentric periodic ups and downs. the period of the bands corresponded to the extinction rings under the polarized optical microscopy observation

    Pcl環帶球晶的表面由周期性高低起伏的環狀結構組成，其凸凹起伏的環帶與球晶在偏光顯微鏡下的明暗交替相對應。
  19. Polarization microscope had observed that the size of sphere crystal of pp after adding organic rigid particles became smaller, the excellent compatibility of interphase between matrix and organic rigid particles in composite has been proved, and the organic rigid particles were drew out into cavities from matrix in the photograph of the impact breaking section by sem. the reason of enhanced toughness of the composite is that the material absorbed amount of energy at forming cavities, which is the mechanism of the pp composite toughened with the organic rigid particles

    偏光顯微鏡顯示加入有機剛性粒子可使pp的球晶尺寸減小， sem觀察到復合材料中基體材料和剛性粒子的界面相容性較好，在沖擊破壞的材料斷面上，剛性粒子明顯被拔出形成「空穴」 ，這些微小空穴較易產生而吸收能量，從而提高了材料的斷裂韌性，這是剛性粒子復合聚丙烯的增韌機理。
  20. Through the characterization of the molecular weights of pam, sem and dsc of composite, the results clarified the change of mechanical properties of composites. the tensile strength and impact strength of pam2 / pa - 6 composite showed that were related to the content of initiator naoh for the polymerization of e - caprolactam. the intrinsic viscosity of pam, sem and the crystallinity of nylon phase carried out the results, which explained the change of mechanical properties of composites

    對于pam2 pa - 6體系，復合材料的拉伸強度與沖擊強度隨醛胺摩爾比的變化趨勢與引發劑用量有關，通過pam2分子量、尼龍結晶度、球晶形態、 sem以及dsc等表徵方法對這種變化趨勢的研究表明，復合材料的力學性能與上述因素有密切的關系。
分享友人
分享到 Line

分享到臉書