環形加熱試驗 的英文怎麼說

中文拼音 [huánxíngjiāshìyàn]
環形加熱試驗 英文
ring-oven test
  • : Ⅰ名詞1 (環子) ring; hoop 2 (環節) link 3 (姓氏) a surname Ⅱ動詞(圍繞) surround; encircle;...
  • : 名詞(古代占卜用的器具) astrolabe
  • : 動詞1. (察看; 查考) examine; check; test 2. (產生預期的效果) prove effective; produce the expected result
  • 環形 : annular; ringlike; ring form; bight; annularity環形癌 annular carcinoma; 環形電路 [訊] loop circu...
  • 試驗 : trial; experiment; test
  1. Ir - ta - ti metal oxide coated titanium anodes of variable composition were prepared by thermal decomposition. their micro morphorogies and electrochemical properties were characterized by scanning electron microscope, open circuit potential, cyclic voltammetry, consumption rate measurements and accelerated life test. the sem results indicated that all coatings were of a porous and cracked - mud microstructure influenced greatly by the composition of coatings. the electrochemical measurements showed that the ir - ta - ti ternary oxide - coated anodes exhibited excellent electrochemical activity and electrochemical stability in both acidic media and seawater which were affected by the composition and microstructure of the coatings. owing to good corrosion resistance and low consumption rate in seawater, metal oxde coated anodes belong to insoluble material, and can be potentially applid in impressed current cathodic protection systems as an anode

    採用分解方法在鈦基體上制備銥鉭鈦金屬氧化物陽極,用掃描電鏡對陽極塗層顯微貌進行分析,通過強化電解壽命、開路電位測、消耗率及循伏安曲線研究了金屬氧化物陽極的電化學性能. sem分析結果表明銥鉭鈦金屬氧化物陽極塗層呈現多孔多裂紋貌結構.隨陽極塗層組成不同,塗層顯微貌表現出很大差異,這種差異直接影響陽極電化學性能.電化學性能結果表明銥鉭鈦金屬氧化物陽極在酸性介質和海水中具有良好的電化學穩定性和電化學活性.此外,銥鉭鈦金屬氧化物陽極在海水中的消耗率很低,屬于不溶性的陽極材料,作為外電流陰極保護用輔助陽極具有廣泛的應用前景
  2. Abstract : the heating process of the round steel billet in the annular furnace was researched by the method of the thermal state simulating experiment. the test was carried out synchronisticly at the site. according to the results of the experiment and actual measurement, the mathematical pattern was connected, and the amended parameters of the thermal flow were given out correctively

    文摘:應用態模型的方法對爐圓鋼坯過程進行了研究.在此基礎上,進行了現場測,根據實和實測結果,對數學模型進行了修正,給出了不同條件下的流修正系數
分享友人