環復分解反應 的英文怎麼說

中文拼音 [huánfùfēnjiěfǎnyīng]
環復分解反應 英文
rcm
  • 環 : Ⅰ名詞1 （環子） ring; hoop 2 （環節） link 3 （姓氏） a surname Ⅱ動詞（圍繞） surround; encircle;...
  • 復 : Ⅰ形容詞1 （重復） repeated; double; duplicate 2 （繁復） complex; compound Ⅱ動詞1 （轉過去或轉過...
  • 分 : 分Ⅰ名詞1. （成分） component 2. （職責和權利的限度） what is within one's duty or rights Ⅱ同 「份」Ⅲ動詞[書面語] （料想） judge
  • 解 : 解動詞（解送） send under guard
  • 反 : Ⅰ名詞1 （方向相背） reverse side 2 （造反） rebellion 3 （指反革命、反動派） counterrevolutionari...
  • 應 : 應動詞1 （回答） answer; respond to; echo 2 （滿足要求） comply with; grant 3 （順應; 適應） suit...
  1. Perovskite - type complex oxides of la1 - xsrxga1 - ymgyo3 compositions are characteristic of superior intermediate temperature oxide - ion conductivity and chemical stability, which are expected to be used in solid oxide fuel cells, sensors, electrocatalysis, membrane separators and membrane reactors. they have highly promising prospects in energy, metallurgy, chemical engineering and environmental protection, etc. in this dissertation, improved embeded sintering method has been employed to prepare la0. 8sr0. 2ga1 - ymgyo3 ( lsgm ) electrolyte, and the contributing factors to preparation, microstructure characteristics, conduction properties and thermology properties of lsgm electrolyte have been investigated

    鈣鈦礦結構la _ （ 1 - x ） sr _ xga _ （ 1 - y ） mg _ yo _ 3復合氧化物具有優異的中溫離子導電特性和化學穩定性，作為固體電解質可用於固體氧化物燃料電池、傳感器、電催化、膜分離和膜反應器等，在能源、冶金、化工、環保等領域具有廣泛的應用前景。
  2. In order to solve the problems with heavy turpentine, such as complex constituents, vicinal boiling point, difficult to separation and hard to comprehensive utilization, the - santalene was converted to natural structure similar product - santalol by light - oxidize reaction, and caryophyllene epoxide was obtained at the same time

    摘要為了解決重質松節油組成復雜、沸點相近導致分離困難、難以深加工綜合利用等問題，利用光氧化反應技術，將其中的-檀香烯轉化為與天然-檀香醇結構相似的檀香型新香料-檀香烯醇，同時可得到環氧石竹烯。
  3. Because of the unique issues in the networks, including mobility - induced disconnection, network partition, high out - of - order delivery ratios and channel errors, the congestion control and the error recovery in the network is challenging. in this environment, the interaction between tcp and mac layer protocols, the affection of route protocols on the performance of tcp and the particular congestion control and error recovery mechanism are first discussed. then a particular transport layer protocol scheme based on the non - feedback mechanism is presented, with emphasis on the analysis and simulation of the key parameter

    文中主要討論了兩種不同網路結構中的無線tcp協議改進方案，其一在最後一跳為無線鏈路的網路環境中，針對基本tcp擁塞控制機制存在的缺陷，文中在現有解決方案的基礎上提出一綜合性的方案，其中包括無線鏈路的高誤碼率和連接斷開問題的解決，並重點對方案中出現的交叉層問題進行分析和模擬；其二，考慮的是分散式網路（ adhoc ） ，在文中較為詳細的分析了tcp和mac層機制間的相互作用、路由協議中造成tcp性能降低的因素、 adhoc網路中應採取的特殊擁塞控制和差錯恢復機制，在此基礎上提出了一種採用非反饋機制的解決方案，重點對方案中的關鍵參數進行分析和模擬，分析和模擬結果表明此機制可在很大程度上提高adhoc網路中tcp的性能。
  4. The fitness of four negative electrode materials such as al, fe, zn, cd, and of six membranes materials : microfiber glass mat separator, polyethylene, polypropylene, polyvinyl chloride, vinylon, soapnated cellulose acetate, and of four current collects : carbon fiber ; nickel foam ; nickel foam sthongthened by iron wire net, punched silver grid in the super - iron alkaline batteries was comparatively studied. the influence of two storaged method ( with and without electrolyte ) and two impurities ( zno, fe ( oh ) 3 ) to the experiment cell ' s self - discharge nature was also comparatively studied. at last, the nature of discharge. structure and electrochemistry of experimental cell with k2feo4 as cathode active material prepared by three different methods : high temperature reaction, hypochlorite oxidizing and electrolysis, was comparative ly studied. we can conclude : i ) the open - circuit potential and the flat of work potential and the percent of capacity of k2feo4 till 1. 0v during the discharge at constant load of experimental cells decreased by the order of al / k2feo4, zn / k2feo4, cd / k2feo4, fe / k2feo4. as for the nature of charge - discharge cycle, cd / k2feo4 fe / k2feo4 zn / k2feo4. in water solute electrolyte, although al / k2feo4 can n ' t be used as storage battery, it have great potential as primary cell or storage cell from the aspect of its discharge capacity. discharge power

    採用組裝實驗電池、 x -射線衍射（ xrd ）和循環伏安（ cv ）的方法，從實驗電池的放電特性、充放電循環特性、自放電特性，不同高鐵酸鹽的結構特性和電化學特性幾個方面，對4種金屬負極材料（ al 、 fe 、 zn 、 cd ） 、 6種隔膜材料（復合玻璃纖維、幅射接枝聚乙烯、改性聚丙烯、聚氯乙烯、維尼綸無紡布、皂化再生纖維素） 、 4種集流體材料（泡沫鎳、以鐵網為加強層的泡沫鎳、切拉銀網、炭纖維編織網）在堿性高鐵電池中的適用性進行了比較研究；對2種雜質組分（ zno 、 fe （ oh ） _ 3 ）和2類不同貯存方式（干、濕）對實驗電池自放電特性的影響進行了比較研究；對3種方法（高溫固相反應、次氯酸鹽氧化、直流電解）所制k _ 2feo _ 4的實驗電池的放電特性、結構特性和電化學性能進行了比較研究。
  5. The reflection approaches based on the theoretic model are firstly used to solve several different kinds of key problems occurring in the co re designing of mobile distributed object platform, i. e., context - awareness, communication adaptation, transparent object caching, remote replication of server objects

    基於上述理論模型，利用反省方法解決了移動分佈對象平臺核心設計中的一些不同類型的關鍵問題，包括：上下文感知、通信環境自適應、透明對象緩存、服務對象異地復制等。
  6. The safety installation of the automobile bumpproof is a very hot topic nowadays, and it is also one of the most important part of intellectual traffic. we use the compound radar and fm coding technology, choose the unique route to produce and develop the expressway automobile bumpproof and alarming installation, which solve the " false alarming " problem that occurs while b eing interrupted in the complicated traffic conditions

    汽車防撞安全裝置是當今世界的熱門話題，是智能交通的重要組成部分，我公司開發生產的高速公路汽車防撞報警裝置採用復合雷達和調頻編碼技術，選擇獨特的技術路線，解決了復雜交通環境下因干擾而產生的"虛警"而且作用距離遠，反應速度快，可靠性高。
  7. The physicochemical characterization was made in depth using various techniques for some resin matrices of advanced composites, such as epoxy resin matrix, phenolic resin matrix and bismaleimide resin. these techniques include infrared spectroscopy ( ir ), nuclear magnetic resonance spectroscopy ( nmr ), mass spectroscopy ( ms ), liquid chromatography ( lc ), thermal analysis ( ta ) and other techniques. the composition, structure, molecular weight, reactivity, reaction temperature and other properties related to performance of resin matrix were studied

    本論文採用紅外光譜、核磁共振波譜、質譜、液相色譜、熱分析等分析技術對實際使用的環氧樹脂、酚醛樹脂以及改性雙馬來酰亞胺樹脂等先進復合材料樹脂基體進行了物理化學表徵，尤其是對與樹脂基體性能密切相關的化學組成與結構、分子量、活性與反應溫度、固化度等進行了表徵；提出了樹脂基體的固化反應機理，獲得了樹脂基體的固化反應動力學參數；對改性雙馬來酰亞胺樹脂的熱分解機理進行了分析，並得到了其熱分解動力學數據。
分享友人
分享到 Line

分享到臉書