界面特性 的英文怎麼說

中文拼音 [jièmiàntèxìng]
界面特性 英文
interface behaviour
  • 界 : 名詞1 （相交的地方; 劃分的界限） boundary 2 （一定的范圍） scope; extent 3 （按職業、工作或性別等...
  • 面 : Ⅰ名詞1 （頭的前部; 臉） face 2 （物體的表面） surface; top 3 （外露的一層或正面） outside; the ri...
  • 特 : Ⅰ形容詞（特殊; 超出一般） particular; special; exceptional; unusual Ⅱ副詞1 （特別） especially; v...
  • 性 : Ⅰ名詞1 （性格） nature; character; disposition 2 （性能; 性質） property; quality 3 （性別） sex ...
  • 界面 : [物理化學] interface; boundary; limiting surface
  • 特性 : characteristic（s）; character; performance; features; properties; behaviour; response; character...
  1. Second, the paper is collected and analyzed the study results of interface properties on reinforced material. then the paper presents the contents and results of interface properties on uniaxial oriented geogrid, warp knitting geogrid, woven geotextile and unwoven geotextile placing in three different kinds of soils

    其次，收集並分析國內外土工加筋材料界面特性的研究成果，通過室內直剪摩擦試驗和拉拔試驗研究常用的三種加筋材料? ?單向土工格柵、經編土工格柵和有紡土工布在不同填料中的界面摩擦特性。
  2. The age hardening characteristic of as - cast cu20ni20mn and cu20ni35mn alloys and the interface characteristic between the alloy and cast tungsten carbide were studied, and on the basis of this study, composites of cu - ni - mn alloy reinforced with different volume fraction ( 0 - 45vol. % ) and different size ( 42 - 362 m ) of cast tungsten carbide particles were made by vacuum hot - pressing liquid sintering technology. pin on disk two body abrasion tests have been performed with different size of sic abrasive under different loads

    本文研究了鑄態cu20ni20mn和cu20ni35mn合金的時效硬化特性及其與鑄造碳化鎢的界面特性，並在此基礎上以不同尺寸（ 42 362 m ）的鑄造碳化鎢顆粒為增強體，採用真空熱壓液相燒結技術制備了不同顆粒含量（ 0 45vol . ）的鑄造碳化鎢顆粒增強cu - ni - mn合金基復合材料；以不同粒度的sic為磨料，在不同載荷條件下利用銷?盤磨損試驗機測試了復合材料的二體磨料磨損性能。
  3. Secondly, the static stress and strain characteristic of polymer - geogrid reinforced earth is summarized, the pulling stress distributing of the reinforced material in the earth walls, the interface characteristeric between the reinforced material and earth and the friction stress distributing between the reinforced material and earth are analysed

    然後，總結了塑料土工格柵加筋土靜應力應變特性的一般理論，分析了塑料土工格柵筋材在擋墻中的拉應力分佈和塑料土工格柵與土的界面特性以及筋土間摩擦應力的分佈。
  4. The fractal theory was used to study the character of liquid - vapor interface in the paper, hence the application of the fractal theory in thermal subjects could be solved and a way to calculate the fractional dimension number in the process of simulation could be put forward. the fractional dimension number describing the character of the liquid - vapor interface was calculated. the distinct fractional dimension numbers in x, y and z direction reveal that the simulation system is an anisotropic one

    並將分形理論運用到汽液界面的研究中，提出了在汽液界面中計算分維數的方法，得到了描述汽液界面特性的數字特徵變量? ?分維數，同時根據所得到的x 、 y和z方向分維數的不同，證明了汽液界面是各向異性的，並對汽液界面進行了定性和定量的分析，得到了汽液界面是典型的分形面的結論。
  5. The minimum shear resistance of beams in the paper is close to the one in the code for design of concrete structures " gb50010 - 2002 '. according to the actual project, the destroy of 448 kinds of beams are analyzed by computer by taking account of the effective coefficient " " of the strength of concrete confined by hoops, the relationship with the section property of beams, the critical point of the arch - rib failure transiting to the shear - compression failure which is advanced in the anti - theory, and the contribution to the beam ' s shear resistance of the concrete in the shear - compression zone

    引用箍筋約束混凝土的有效系數，利用其與梁截面特性的關系並結合理論分析中提出的梁剪壓破壞與斜壓破壞的分界點，同時考慮了剪壓區混凝土的抗剪貢獻，從工程實際出發，編程擬算了448種梁構件的破壞情況，計算結果表明，梁發生在剪壓破壞范圍內的最大抗剪承載力值比混凝土結構設計規范gb50010 - 2002值略高。
  6. Electrical and mechanical interface characteristics and line control protocol using communication control characters for serial data link between a direct numerical control system and numerical control equipment employing asynchronous full duplex transmission

    電子和機械界面特性和在直接數字控制系統與用同步完全雙向傳輸的數字控制設備之間的系列數據鏈接的通信控制字元的線路控制協議
  7. As for the pl mechanism, except the red band, the rest are all originated from luminescence defects related to impurity, and the luminescence centers are affected by configuration of impurities, while the red emitting band may attribute to the quantum confinement effect of nano - si, but will also rely on its interface characteristic

    就發光機制而言，除紅光寬帶外，均起源於氧、氮摻雜引起的缺陷發光中心，發光中心受雜質組態影響，紅光寬帶可能聯繫到量子限制效應，同時還依賴于界面特性。
  8. On the study of the influence of the interphase properties on the creep behavior of short fiber enforced metal matrix composites

    界面特性對短纖維金屬基復合材料蠕變行為的影響
  9. This part emphasizes the synthesis of nanoarrays, aiming at controlling the size and distance of nanocrystallites using calixarene derivatives by altering the size, length and chemical structure of the organic molecules ; 2. this part emphasizes in situ synthesis strategy for fabrication of polymer network of zns based nanopowder, aiming at size controls, coating and preventing agglomeration following " one - pot " synthesis ; this method fits to low cost, large scale production ; 3. according to development in zno nanomaterials, we first report on the synthesis, characterization of amorphous zno, aiming at describing the principles and approaches of synthesis techniques, optical properties, spatial structure and doped effect ; the amorphous zno displays cage - like structure, showing a strong ultraviolet emission while the visible emission is nearly fully quenched, a potential uv - emission material ; 4

    本論文以量子結構自組裝為出發點，提出利用杯芳烴及其衍生物的化學受限反應實現尺寸可調半導體納米粒子自組裝；提出有機聚合網路原位組裝zns基納米熒光粉方法，把熒光粉的納米化、包敷、防團聚在「一鍋」反應中完成，適于低成本，批量生產；根據當前zno的研究情況，我們首次合成了非晶zno ，研究了它的光學性質，確定了它的結構，並對其摻雜進行了初步的研究，非晶zno表現出強的深紫外發光特性，而可見發射非常弱，是一種有巨大潛在應用價值的深紫外發光材料；利用非晶zno的亞穩特性，對晶化過程中非晶zno納米晶zno三維受限量子結構特性，界面特性進行了深入的研究；利用固相熱分解一般受擴散控制特性，實現了尺寸可控的zno三維量子結構的自組裝；利用非晶zno的高度分散性，容易均勻成膜特性，實現了非晶籽晶誘導低溫液相外延自組裝生長高取向zno晶體薄膜。
  10. It is necessary to study the effect of weak interfacial bonding on the mechanical behaviour of metal matrix composites ( mmcs ), the micromechanical finite element method and the nonlinear spring element for the interface are employed to predict the effective behaviour of mmcs

    論文採用非線性彈簧元模擬界面，用細觀力學有限元法計算分析了不同界面特性下弱界面粘結的纖維增強金屬基復合材料的宏細觀性能。
  11. Investigation of the effect of bonding characteristics on static and dynamic behavior of a smart functionally graded beam

    界面特性對功能梯度智能梁靜動態響應的影響研究
  12. Abstract : based on research information of geotechnical reinforc ement technology collected extensively in highway and railway engineering, the a uthors analyzed and summed up the research achievements in the in - field me chanical, interfacial and long - term performances of geotechnical reinforcement materials, and emphasized some fields which should be doubly studied

    文摘:主要通過對大量國外公路鐵路工程界關于土工加筋技術的研究及應用資料的調查收集，結合自身近幾年的研究，分析總結了關于土工加筋材料的現場力學特性、界面特性、長期性能等方面的研究成果，並強調了應加強研究的幾個方面。
  13. Study on interaction characteristics between geosynthetics and fill materials by pull out tests

    土工格柵與土界面特性的試驗研究
  14. Nano - si embedded sio2 composite thin film were fabricated by using ball - milling and sol - gel technology, it is found that the red pl band located at about 730nm is affected by the interface characteristic of nano - si, this indicated that the red emitting resulted from nc - si is also rely on its interface characteristic

    採用球磨與溶膠凝膠法結合制備了sioz鑲嵌納米出復合薄膜，發現位於刀on附近的紅光發射帶受納米顆粒界面的影響，說明起源於硅納米顆粒的紅光發射依賴于界面特性。
  15. Test for interface characterictics of geogrid

    土工格柵的界面特性試驗
  16. Influence of temperature on the interface behavior of nylon fiber - rubber composite

    橡膠復合材料界面特性的影響
  17. Identification card systems - device interface characteristics - classes of device interfaces

    識別卡系統.裝置界面特性.裝置界面等級
  18. Influence of stitched area and interface characteristic on mechanical properties of stitched lamina

    縫線區域及界面特性對縫紉復合材料單向板力學性能的影響研究
  19. In the project of reinforced earth, tension properties and interface properties on reinforced material are very important because they will determine the effective of reinforcement

    在加筋土工程中，筋材的拉伸特性及其與土的界面特性是關鍵問題，它決定了加筋的效果。
  20. That the interfacial properties, the forming mechanism and the important influence factors in the wood - plastics composites forming are studied is a very important research area in the wood - plastics composite theory and performance controlling of the composites

    研究木塑復合材料的界面特性以及木塑復合材料性能的影響因子，是當前木塑復合材料理論及材料性能調控研究的重要方面。
分享友人
分享到 Line

分享到臉書