疏鬆材料 的英文怎麼說

中文拼音 [shūsōngcáiliào]
疏鬆材料 英文
bulk material
  • 疏 : Ⅰ動詞1 （疏通） dredge （a river etc ）2 （疏忽） neglect 3 （分散; 使從密變稀） disperse; scatte...
  • 材 : 名詞1 （木料） timber 2 （泛指可以直接製成成品的東西; 材料） material 3 （供寫作或參考的資料） ma...
  • 料 : 名詞1 （材料; 原料） material; stuff 2 （喂牲口用的穀物） feed; fodder 3 （料器） glassware 4 （...
  • 疏鬆 : 1. （土壤等鬆散; 不緊密） loose; puff 2. （使鬆散） loosen
  • 材料 : 1. （原料） material 2. （資料） data; material 3. （適于做某種事的人才） makings; stuff
  1. Fill the new shipping container with at least three - inches ( 7. 62 cm ) of foam - in - place, foam corner or edge pads, inflatable packaging, loosefill peanuts or other suitable dunnage materials

    在新運輸包裝箱中填充至少三英寸（ 7 . 62厘米）厚的現場發泡、泡沫稜角或邊緣襯墊材料、充氣式包裝、疏鬆填充顆粒或其它適用的襯墊材料。
  2. Standard specification for vermiculite loose fill thermal insulation

    蛭石制疏鬆填充隔熱材料的標準規范
  3. It is shown that paraffin can be uniformly absorbed into the pore network of expanded graphite, that expanded graphite remains its vermiform structure in pcms, that the phase - change temperatures of composite pcms are similar to that of paraffin, and that the latent heat of composite pcms is are based on the mass fraction of paraffin in the composite materials

    結果表明：膨脹石墨吸附石蠟后仍然保持了原來疏鬆多孔的蠕蟲狀形態，石蠟被膨脹石墨微孔所吸附；復合相變儲熱材料的相變溫度與石蠟相似，其相變潛熱與基於復合材料中石蠟含量的潛熱計算值相當。
  4. The density of the al bulk nanomaterials is only 75 percent of mat of normal ordinary coarse crystallized counterparts, which means there are a lot of holes or loosen structure in the nano - bulk al

    通過模壓成形的納米金屬鋁和銅的塊體的密度只有普通體材料密度的75左右，表明得到的未經燒結的納米鋁塊體內部可能還存在很多孔隙或很多疏鬆的組織。
  5. Temperature field of hollow ingot solidification is simulated by fem. to different mould, effect of heat transfer coefficient between inner sleeve and cooling medium and thickness of core refractory on final position of solidification, the highest temperature of inner sleeve against cooling medium, and shrinkage cavity and porosity are compared. in addition, change of temperature in typical position of core refractory is also compared

    對空心鋼錠凝固過程的溫度場進行了有限元分析，對不同錠型結構的芯部換熱系數、耐火材料厚度對最終凝固位置、內筒壁最高溫度及縮孔疏鬆的影響進行了對比，並討論了耐火材料典型部位的溫度隨凝固時間的變化。
  6. Abstract : temperature field of hollow ingot solidification is simulated by fem. to different mould, effect of heat transfer coefficient between inner sleeve and cooling medium and thickness of core refractory on final position of solidification, the highest temperature of inner sleeve against cooling medium, and shrinkage cavity and porosity are compared. in addition, change of temperature in typical position of core refractory is also compared

    文摘:對空心鋼錠凝固過程的溫度場進行了有限元分析，對不同錠型結構的芯部換熱系數、耐火材料厚度對最終凝固位置、內筒壁最高溫度及縮孔疏鬆的影響進行了對比，並討論了耐火材料典型部位的溫度隨凝固時間的變化。
  7. Ceramic grain filters ard made of refined pottery clays added with certain modifiers, and processed of grinding, mixing, shaping and high temperature sintering. they do not contain any substances that harmful to people or environment. they are hard and rough in surface, porous inside the structure, and have the advantages of high mechanical strength, large specific surface area and porosity. when used in water treatment, they behave a activated surface property, a great amount of pollutant entrapment, less water head loss in the filter bed, lower consumption of back - flush water, stable in chemical and gbiologic property, and long service life, ceramic grain filters is a new and efficient filter material to increase the water yield, upgrade the water quality, and save chemicals and energy

    陶粒濾料是以精製陶土為主要原料，摻加適量改性劑，經粉碎，混練，成型和高溫煅燒而製成的，不含任何對人體和環境有害的物質.其表面堅硬，粗糙，內部疏鬆，多孔，具有機械強度高，比表面積大，孔隙率大的特性.用於水處理中，具有表面性狀好，截污能力強，過濾水頭損失小，反沖洗耗水量低，化學穩定性和生物學穩定性好，使用壽命長的特點.陶粒濾料是一種能增加水產量，提高出水質量，節省藥劑和能耗的新型高效過濾材料
  8. 1. capacity and discharge efficiency of polyacene capacitors were systematically studies and electrolyte is aqueous and aqueous solution a series of pristine sample were prepared by pyrolysis of phenol formaldehyde resin moulded with znc, this inorganic salt used together with the resin served not only as the pore - forming agent to form open pores, which grow into a three - dimensional network structure in the cured material, but also as the microstructure - controlling agent to form a loose structure dopable with bulky dopants such as bf4 and so on

    首次系統地研究了聚並苯導電材料作為雙電層電容器的電極活性材料時，在水系和非水系電解質中的容量及庫侖效率。用化學方法合成可溶性酚醛樹脂，加入的zncl _ 2在聚並苯的制備過程中既是成孔劑，使在處理的材料中形成三維網狀微孔，同時它又是微孔控制劑，形成能被bf4 -等體積較大的摻雜劑所摻雜的疏鬆結構。
  9. ( 5 ) the ability of carry out a porous shock compression experiments with uncertainty less than 20 % has been had, and then there is a possibility to obtain at high pressure with uncertainty less than 10 %. ( 6 ) another method to get, utilizing the method 3 p _ ( c ) and shock compression data, has been investigated. it has been shown preliminarily that there a simple phenomenal project to calculate by utiliaing this method

    第三方面，考察了以實驗數據計算的一些情況，獲得的主要結果為（ 5 ）就目前所能達到的實驗精度，開展具有適當初始疏鬆度的疏鬆材料的沖擊壓縮實驗可提供不確定度10的高壓實驗測量值； （ 6 ）利用本文給出的冷壓與沖擊壓縮實驗數據聯立的方法計算了大量金屬的寬熱力學范圍的男，初步的分析表明，以該方法為基礎可形成一種更多保留實驗信息的gruneisen系數唯象計算方法。
  10. Standard specification for cellulosic fiber loose - fill thermal insulation

    纖維素纖維疏鬆填充絕熱材料的標準規范
  11. Standard practice for simulated aging of cellulosic loose - fill insulation

    纖維素疏鬆填充絕緣材料模擬老化的標準實施規程
  12. Using loosefill peanuts as insulation or packing material in your packages

    在包裹中使用疏鬆填充顆粒作為隔離物或包裝材料。
  13. Fill the bottom of the new shipping container with at least three - inches ( 7. 62 cm ) of foam - in - place, polyethylene corner or edge pads, inflatable packaging, loosefill peanuts or other suitable dunnage material

    在新運輸容器的底部填充至少三英寸（ 7 . 62厘米）厚的現場發泡、聚乙烯稜角或邊沿襯墊材料、充氣式包裝、疏鬆填充顆粒或其它適用的襯墊材料。
  14. Standard test methods for density of granular loose fill insulations

    粒狀疏鬆的填充隔熱材料密度的標準試驗方法
  15. Based on signal from carbon fiber composite defects such as lamination, hole, looseners in ultrasonic testing, this paper performs wavelet packet transform on the ultrasonic signals to extract statistics of approximation coefficients and detail coefficients that contain a great part of signal energy as sample - features

    摘要本文以碳纖維復合材料常見缺陷分層、孔隙、疏鬆的超聲波檢測缺陷信號為研究對象，對超聲波檢測信號進行小波包變換，提取包含信號絕大部分能量的近似系數波形特徵及細節系數的統計量作為樣本的特徵值。
分享友人
分享到 Line

分享到臉書