盤中低點 的英文怎麼說

中文拼音 [pánzhōngdīdiǎn]
盤中低點 英文
session lows
  • 盤 : Ⅰ名詞1 （盤子） tray; plate; dish 2 （形狀或功用像盤的東西） sth shaped like or used as a tray pl...
  • 點 : Ⅰ名詞1 （液體的小滴） drop （of liquid） 2 （細小的痕跡） spot; dot; speck 3 （漢字的筆畫「、」）...
  1. Greenschist facies, low green schist facies and brittle shear deformation facies. the attitude of different structural element of the yagan mcc are keeping coordination. analysis of kinematics demonstrates the sse - directed shearing - off of the hanging wall relative to the footwall along the penetrative mylonitic lineation

    其變形相由變質核中心到上盤巖系（由深至淺）依次為高角閃巖相? ?綠片巖相? ?低綠片巖相? ?脆性剪切變形相，顯示亞干核雜巖由中心向邊部變形層次遞減的特點。
  2. 4 ) in a pre - swirl rotator - stator cavities with discrete pre - swirl nozzles and blade - cooling entry holes, the influences of pre - swirl angle and flow parameter on the flow and heat transfer characteristics were numerically investigated. the correlation for average nusselt number vs rotating reynold number or non - dimensional mass flowrate were established. the results show that : advantage of per - swirl inflow is the effect of cooling the blade - cooling entry holes ; pre - swirl inflow increases heat transfer in rotating disk of pre - swirl chamber ; as pre - swirl angle increases, local nusselt number decreases in pre - swirl chamber ; the temperature of stator of inner rotator - stator chamber and per - swirl chamber decreases as rotating reynold number increases ; when the axial mass flowrate maintains constant, heat transfer in the rotating disk of inner rotator - stator cavities does n ' t change as per - swirl mass flowrate increases, while heat transfer in the rotating disk of per - swirl chamber increases ; when the pre - swirl mass flowrate maintains constant, change of the axial mass flowrate has effect on the whole cavity

    結果表明，預旋進氣的優點在於增強了葉片冷卻孔附近的對流換熱效果，局部努謝爾數隨預旋角的增大而有所減小；隨旋轉雷諾數的增加，不論是內轉靜腔室還是預旋腔室的靜盤上的溫度都不同程度的降低：當軸向中心進氣質量流量不變時，隨預旋進氣的質量流量增加，內轉靜腔室的轉盤盤面上的換熱基本沒有變化，而預旋腔室的轉盤盤面上的換熱效果增強；當預旋進氣質量流量不變時，軸向中心進氣的質量流量的改變對整個盤腔都有影響。
  3. 4, single focuse the single head : is single for single laser head that panasonic lead off to adopt to focuse the double the laser beam for focusing ordering the project, he adopting the special whole synthesizing lens, passing lens in the center part ofly the focusing of formation cd the point, and pass the anastigmatic laser beam of part edge the formation the focusing of dvd the point, this kind of construction because of have no the machining to spread to move, and also can t produce the mechanical trouble, therefore increased to recognize the dish the speed, and however and also lowered the cost. but adoption this project of generation is with part of the next generation dvd nonsupports cdr

    4單聚焦單鏡頭：為panasonic率先採用的單激光頭單聚焦鏡雙聚焦點方案，他採用特別的全息綜合透鏡，通過透鏡中間部分的激光束形成cd的聚焦點，通過透鏡邊緣部分的激光束形成dvd的聚焦點，這種結構由於沒有機械傳動，也不會產生機械故障，所以提高了認盤速度，不過同時也降低了成本。但採用此方案的第一代和部分第二代dvd不支持cdr 。
  4. Elsewhere, the euro remained steady against the major currencies, off earlier highs in narrowly ranged trade, with markets watching comments from a meeting of euro zone finance ministers and central bankers to assess levels of concern over the euro ' s strength

    歐元兌主要貨幣仍然持穩于盤中，略低於早盤高點並在低點附近宰幅波動，目前市場關注的焦點于歐元區財長會議及央行發表的言論來評估歐元進一步的走勢。
  5. With the support of the first manufacturing shop of yuxi hongta group, this project will lucubrate the 101 automatic logistics system of hongta group, which revolves around the group policy of improving quality, bringing front new ideas and reducing expense to manage the logistics management and do better to the enterprise, doing comprehensive and systematic researches, seeking out and solving a series of flaws and questions of the 101 automatic logistics system. ( l ) this project will discuss internal and external present conditions, development divection, interrelated concepts and knowledge of automatic logistics system. ( 2 ) according to the materials characteristic, in connection with the conditions of automatic logistics system, i will model the pallet and hold a synthetical research on all kinds of materials stacking patterns to achieve stacking equitably and steadily

    （ 1 ）論文論述了自動化物流系統的國內外現狀及發展趨勢，自動化物流的相關概念及各類相關知識； （ 2 ）根據101生產所需的物料特點，結合物流系統情況，對托盤進行了選型設計，同時對各類物料的堆碼方式，也通過比較的方法來進行研究，以達到堆碼合理、穩固的目的； （ 3 ）基於101自動化物流系統中agv系統存在著運行效率低的問題，先根據路徑規劃原則，應用統籌方法，對agv行駛路徑進行了研究，得到規劃化路徑方案，接著結合agv調度管理方法的缺陷，對其進行了研究，並加以改進，最後再對輔料的請求管理進行了全面的探討，以此來提高agv系統的運行效率。
  6. On the day that extreme high price of a move is reached after a big advance, if option closes near the low of the day or closes below the halfway point of the day ' s range or closes below the opening, it indicates that the selling is better than the buying and that the option is getting ready to turn the trend down, at least temporarily

    在一輪大牛市結束到達極限高點價格的那天，如果當天開盤價接近收盤價，或者收盤價低於當天中價（應該是最高一最低的一半） ，或者收在開盤價下面，那麼預示賣者多於買者，至少行情準備轉勢了。
  7. The method of positioning synchronous control used pho toencoder as position measure and s5 - 100u plc is introduced in this paper. this system has advantages of high control accuracy, high reliability and low cost etc. in practice

    介紹了在全數字控制系統中利用光電碼盤作為位置檢測，利用s5 - 100u可編程序控制器完成位置同步控制的一種方法，並以推鋼機系統為例介紹此同步控制方法的硬體構成及軟體特點，通過實際應用表明，本系統具有控制精度高，可靠性強，成本低等優點。
  8. Abstract : the method of positioning synchronous control used pho toencoder as position measure and s5 - 100u plc is introduced in this paper. this system has advantages of high control accuracy, high reliability and low cost etc. in practice

    文摘:介紹了在全數字控制系統中利用光電碼盤作為位置檢測，利用s5 - 100u可編程序控制器完成位置同步控制的一種方法，並以推鋼機系統為例介紹此同步控制方法的硬體構成及軟體特點，通過實際應用表明，本系統具有控制精度高，可靠性強，成本低等優點。
  9. Indian shares tumbled as much 11 per cent before recovering a little to end the day 7. 4 per cent down, hong kong closed 5. 5 per cent down ? its biggest fall since the aftermath of the september 11 attacks ? and japan ' s nikkei average slid by nearly four per cent to its lowest level for more than two years

    印度股市盤中一度重挫達11 % ，尾盤略有回升，收盤跌7 . 4 % ；香港股市下跌5 . 5 % ，創下「 911 」事件以來最大跌幅；日本日經指數下挫近4個百分點，收于兩年多來的最低點。
  10. There are two different ideas about the massive star formation. some investigators suggest that high - mass stars form via dynamical collapse of cloud cores, resulting in disk accretion and molecular outflows, similar to their low - mass counterparts ; some peoples suggest that high - mass stars form by the coalescence of low - to intermediate - mass stars

    關于大質量恆星的形成有兩種觀點：一種觀點認為大質量恆星通過雲核的塌縮，然後產生一個吸積盤和外流，即相似於低質量恆星的形成；另一種觀點認為大質量恆星通過中小質量的恆星併合而成。
  11. Relatively reliable suction goods drop should pass the explore below a few diving in share price, be far from all valence 3 above, float of short that day line prepares this position to already did not wish again shipment, even if cast sheet greatly to also be done not have new low, banker also discovers the chip prediction of a person ' s luck in a given year that makes small conference cause certain level to go up again, so this position should be in the relatively reliable suction in washing dish of movement goods is nodded, even if won ' t turn over a body that day up, also be that day area of an opposite low, calm view of ok and easy ground its change, enjoy the short poor profit in washing pan zhen to swing

    較為穩妥的吸貨點應在股價經過幾波跳水下探，遠離均價3以上，此位置當日短線浮籌已不願再出貨，即使是大的拋單也沒新低，莊家也發現再打低會造成一定程度上的籌碼流失，所以這個位置應該是在洗盤動作中較為穩妥的吸貨點，就算當日不會反身向上，也是當日一個相對低價區，可以從容地靜觀其變，享受在洗盤震蕩中的短差利潤。
  12. In order to fully develop the theory of squeezed branch piles, in particular, the justification of its superior performance in terms of the bearing capacity and sinking displacement, we have derived the analytical formulas of the axial load and the strain at arbitrary depth ; based on existing static loading test results and research on belled pile, together with the analysis of on - site testing data, we have applied the expand theory on sphere holes to the computation of radial stress of squeezed branch piles under hole expansion ; taking the oil pressure of hole expansion in to account, we have find the a branch force under certain hole pressures, hence we can estimate the maximum bearing capacity of single piles ; we have introduced the experiential formulas for the bearing capacity of squeezed branch piles based on its stress characteristic and pile testing data ; we have also done numerical simulations of squeezed branch piles utilizing finite element method software ansys ; we have matched the simulation res ults with those of on - site basic load experiments, regenerating the distributions of stress fields and strain fields of squeezed branch piles, and from those distributions, we can determine the optimal distances between plates and piles

    為了完善支盤樁的設計理論，探求支盤樁高承載力和低沉降量的內涵，本文推導出了支盤樁任意深度的截面荷載以及位移隨深度變化的理論公式；基於已有的靜載試驗成果及有關擴底樁的研究成果，從對現場測試數據的分析，將球形孔擴張理論引入到支盤樁擴孔時徑向應力的計算，考慮到擴孔時的油壓數據，求得某一孔壓下的支盤力，據此估算單樁極限承載力；同時根據對支盤樁的受力特點和試樁數據的分析，提出了支盤樁承載力計算的經驗公式；用有限元分析的方法，利用大型有限元分析軟體ansys對支盤樁進行數值模擬，並將模擬結果同現場的靜載試驗結果進行對比，再現了支盤樁在荷載作用下土中應力場和位移場的變化，根據應力場和位移場的變化范圍，指出最佳盤間距和樁間距；為支盤樁的設計和施工提供了一個可量化的設計依據。
分享友人
分享到 Line

分享到臉書