直接傳感器 的英文怎麼說

中文拼音 [zhíjiēzhuàngǎn]
直接傳感器 英文
photostat
  • : Ⅰ形容詞1 (成直線的; 硬挺的) straight; stiff 2 (跟地面垂直的; 從上到下的; 從前到后的) erect; v...
  • : Ⅰ動詞1 (靠近;接觸) come into contact with; come close to 2 (連接; 使連接) connect; join; put ...
  • : 傳名詞1 (解釋經文的著作) commentaries on classics 2 (傳記) biography 3 (敘述歷史故事的作品)...
  • : Ⅰ動詞1 (覺得) feel; sense 2 (懷有謝意) be grateful; be obliged; appreciate 3 (感動) move; t...
  • : 名詞1. (器具) implement; utensil; ware 2. (器官) organ 3. (度量; 才能) capacity; talent 4. (姓氏) a surname
  • 直接 : direct; immediate
  1. This paper discusses the designing and making of the dynamic testing systems of engine electronic control system. base on the construction and operation principle of santana 2000gsi m3. 8. 2 engine electronic control systems, design and manufacture led circuit of dynamic testing and fault imitating electronic control unit. on the inspect board, design and equip with motronic 3. 8. 2 ecu i / o measuring joints, design and set up obd - ii diagnostic communication link, design and install fuel pressure inspecting meter. depend on the obd - ii diagnostic communication link and ecu i / o measuring joints, this dynamic testing system can inspect engine electronic fuel injection system, distributorless ignition system, idle speed control system and evaporative emission control system, and can inspect m3. 8. 2 sensors, ecu and actuators, and can interrogate fault memory and erase fault memory ; and can analyse data stream ; and can carry out fault imitating. besides, this paper analyses sensors and actuators typical fault w aves

    2電控單元電路連設計製成輸入輸出電子控制檢測端子,並在檢測面板上布置了obd -診斷插座和燃油壓力表。使該動態測試系統能實現對電噴發動機的燃油系統、點火系統、怠速控制系統和燃油蒸氣排放控制系統的動態檢測;並通過obd -診斷座、 ecu輸入輸出檢測端子和故障模擬處理單元實現對電噴發動機電控系統各、電控單元、執行進行故障碼讀取與清除;動態數據讀取和波形測試和故障模擬等。此外,本論文還分析了和執行典型故障波形。
  2. Depend on the comprehensive analysis and study of the structure, principle, and exterior characteristic of the motor, through the methods of system modeling and digital simulation analysis, two kind of control device that work for the low voltage ( lvdc ) and the high voltage ( hvdc ) in avigation are researched respectively. point to the control technique of close - loop speed stabilization at a limited adjustment speed range, we bring out the close - loop speed control method that using the rotor position sensor indirectly measure the speed of the motor

    在全面分析了稀土永磁無刷流電動機的結構特點、工作原理、運行方式以及外部特性的基礎上,通過系統建模和數字模擬分析,分別針對航空低壓流( lvdc )和高壓流( hvdc )兩種電動機構用永磁無刷電動機,在小范圍轉速連續調節下的閉環穩速控制技術進行了詳細理論研究,提出了利用轉子位置信號間測量電機轉速進行電機轉速閉環穩速控制的策略。
  3. Lk - coriolis mass flowmeters made according to the coriolis mass inside prineiplecloses the dischange apperrance of the fluid quality. discharge inside the piping, its structure be generally spread feeling machine and signal by signal diagraph to comvert to machine two part constituce

    Lk系列質量流量計是根據科里奧原理製造的一種新型的測量封閉管道內流體質量流量的流量測量儀表,其結構一般由信號測量和信號轉換兩部分組成。
  4. This paper describes a system for preignition in motorcycle engine using spark plus as a detecting probe, the author carries out researches on a method how the ionic current coins into being

    摘要本文描述了一種利用火花塞電極作為檢測南方摩托車發動機早燃的方法,作者在文章中詳細分析及討論了離子電流的產生機理。
  5. Self-contained system incorporates sensor, controller and controlled device in a single package.

    作用式系統統統裝在一隻簡單的匣子里,它包含,控制和調節機構。
  6. A novel low mechanical hysteretic ceramic capacitive pressure transducer has been made, by using of ceramic sealing technology ; integrate circuit ( ic ) technology and thick film plane fixing circuit technology. this transducer is made of a deformable ceramic diaphragm and a ceramic base plate, between which has an air cavum. a coaxial gold electrode was fired onto the diaphragm and the base plate

    本文利用新型陶瓷技術、集成電路技術和厚膜平面安裝電路技術,採用零力學滯后的陶瓷和陶瓷密封材料進行設計製造了一種非充液乾式的電容式壓力,該壓力由較厚的陶瓷基體和較薄的陶瓷膜片構成,中間形成一空氣介質腔,在基座和膜片之間內置同軸的雙電極,組成兩個電容,當膜片承受壓力時發生位移,使電容量產生變化,經後置處理電路轉換為可輸出的流電壓信號。
  7. All dms force transducers are connectable, that can be runned by dc voltage

    此款放大能和所有流電源驅動的dms力
  8. The algorithm can not only eliminate the influence of the cumulative errors of the photoelectric code recorder, but also it can satisfy the requirement of the real - time control. a direct inverse model controller of fuzzy neural network with changeable structure based on takagi - sugeno inference is presented and it is used to the motion control of mobile robot. in order to avoid the obstacles successfully, detection results from ccd and ultrasonic sensors are fused by a fuzzy neural network, which acts as an avoidance controller

    包括移動機人的融合自定位問題:移動機人利用光電編碼進行自定位,同時用擴展卡爾曼濾波融合多個超聲波的測量值,採用回朔演算法將融合值用於復位光電編碼,消除了光電編碼累積誤差的影響,並能滿足實時控制的要求:並提出一種基於takagi - sugeno模型的變結構模糊神經網路逆模型控制,並應用於移動機人的運動控制;利用模糊神經網路避障控制融合ccd攝象機與超聲波探測到的環境信息,以實現機人的安全避障。
  9. The pyrogallol was adhered on the surface of the solid electrode by the direct oxidative electropolymerization to construct the chemical sensors for bi ( iii ). the sensor exhibits perfect long stability and reproducibility. a low detection was obtained in the determination of bi ( iii ) and this way can be applied to determine the real samples such as human hair and nails

    2 、將修飾劑鄰苯三酚電聚合到固體電極的表面,研製bi ( )離子化學,該修飾電極穩定性和重現性很好,克服了以往碳糊電極機械強度差、重現性不好的缺陷,測定bi ( )達到了很低的檢出限,應用於人發和指甲等實際樣品的測定。
  10. The vision sensor is fixed on the end - effector of the robot. when the robot makes a linear movement along the " v " measurement track, the linear light from the laser electropult on the sensor is projected on the track to shape laser strip with three turning dots and imaged in ccd camera. the relation between the sensor coordinate and the measurement track coordinate can be computed by image processing and pose measuring, which indirectly describes the characteristic of the robot ' s linear trajectory

    該系統利用結構光幾何成像原理和視覺圖像處理技術,將視覺固定在機人末端,當機人沿「 v 」形測量軌道做線運動時,上的激光發射裝置發出的線狀光源投射在測量軌道上,形成具有三個拐點的激光條,並在ccd攝像機中成像,通過圖像處理技術和位姿測量技術,得到坐標系相對于測量軌道坐標系的位姿關系,從而間描述機人的線軌跡特性。
  11. Special planes called " hurricane hunters " fly directly into these monster storms and drop sensors to measure wind speed, temperature and air pressure, providing vital clues to the hurricane ' s direction

    一種名為「颶風獵人」的特殊飛機可飛進這些風暴怪物內,投放來測量風速、溫度和氣壓,提供有關颶風路徑的關鍵信息。
  12. On the basis of theory research, software and hardware design, the system experiment simulation in matlab toolbox is given, and the simulation results are analyzed and explained. the simulation results show the system has good static and dynamic performance

    在無速度轉矩控制系統理論研究和軟硬體設計的基礎上,利用matlab模擬工具箱完成了整個系統及各個部分的模擬,並對模擬結果進行了分析和說明。
  13. High temperature melt body pressure transmitter / changes delivering, two product and so on force components load cells, torque sensor for the substitution import product, but and overseas similar product direct exchange use

    其中高溫熔體壓力/變送、兩分力測力、扭矩等產品為替代進口產品,可與國外同類產品互換使用。
  14. For the advantages of glucose biosensors are obvious : high specificity, short time, simplicity and low cost of analysis, etc. one of the developments of glucose biosensor is the third generation amperometric enzyme electrode with direct electron transfer, which is commonly prepared by conducting organic salts and conducting polymers

    葡萄糖生物具有選擇性高、簡便、快速的特點,是檢測葡萄糖濃度最常用的方法。為提高的性能,一個發展方向是制備電子遞的第三代電流型葡萄糖生物。目前把利用導電聚合物或導電有機鹽制備的酶電極叫做電子遞的生物
  15. Finally a speed sensorless dtc system is carried out

    在此基礎上,實現了無速度轉矩控制系統。
  16. Sensorless is a major feature of the pmsm dtc system

    無需速度反饋信號是本轉矩控制的一個優異的特性。
  17. In the paper, a speed estimator based on artificial neural network is designed according to the principle of direct torque control, the speed estimator is optimized by genetic algorithm, and the parameters of pid speed adjuster is also optimized by genetic algorithm. a stator linkage and torque observer based on stator resistance estimator using fuzzy neural network is also designed. eventually, the intelligent control of direct torque control system is implemented

    本文根據異步電動機轉矩控制原理,在應用人工神經網路進行速度辨識的基礎上,利用遺演算法對神經網路速度辨識進行了優化設計;運用遺演算法對pid速度調節的結構和參數進行了整合;在採用模糊神經網路對電機定子電阻辨識的基礎上,進行了定子磁鏈及轉矩的觀測,為最終實現無速度轉矩控制系統的智能控制創造了條件。
  18. The results show that the asymmetry of temperature field in detection equipment is influenced by super temperature in natural environment, and the standard temperature sensor and the ones regulated are not installed appropriately in the temperature equipment

    結果表明:造成校準超差的原因是自然環境溫度過高引起溫度校準設備內的溫度分佈不均勻,間原因是標準溫度與被校準溫度在溫度槽內不恰當的安裝。
  19. Namur low - voltage switchgear and controlgear - part 5 - 6 : control circuit devices and switching elements - dc interface for proximity sensors and switching amplifiers

    低壓開關設備和控制設備.第5 - 6部分:控制電路設備和開關元件.近和開關放大流介面
  20. Namur specification for low - voltage switchgear and controlgear - control circuit devices and switching elements - dc interface for proximity sensors and switching amplifiers - dc interface for proximity sensors and switching amplifiers

    低壓開關設備和控制設備規范.控制電路件和開關元件.近和開關放大流介面
分享友人