直接調節器 的英文怎麼說

中文拼音 [zhíjiēdiàojié]
直接調節器 英文
self-actuated controller
  • : Ⅰ形容詞1 (成直線的; 硬挺的) straight; stiff 2 (跟地面垂直的; 從上到下的; 從前到后的) erect; v...
  • : Ⅰ動詞1 (靠近;接觸) come into contact with; come close to 2 (連接; 使連接) connect; join; put ...
  • 調 : Ⅰ動詞1 (配合得均勻合適) harmonize; suit well; fit in perfectly 2 (使配合得均勻合適) mix; adju...
  • : 節構詞成分。
  • : 名詞1. (器具) implement; utensil; ware 2. (器官) organ 3. (度量; 才能) capacity; talent 4. (姓氏) a surname
  • 直接 : direct; immediate
  • 調節器 : regulator; adjuster; governor; controller; conditioner; actuator; phaser
  • 調節 : regulate; adjust; monitor; measure; take care of; condition; regulation; adjustment; conditioning...
  1. Depend on the comprehensive analysis and study of the structure, principle, and exterior characteristic of the motor, through the methods of system modeling and digital simulation analysis, two kind of control device that work for the low voltage ( lvdc ) and the high voltage ( hvdc ) in avigation are researched respectively. point to the control technique of close - loop speed stabilization at a limited adjustment speed range, we bring out the close - loop speed control method that using the rotor position sensor indirectly measure the speed of the motor

    在全面分析了稀土永磁無刷流電動機的結構特點、工作原理、運行方式以及外部特性的基礎上,通過系統建模和數字模擬分析,分別針對航空低壓流( lvdc )和高壓流( hvdc )兩種電動機構用永磁無刷電動機,在小范圍轉速連續調下的閉環穩速控制技術進行了詳細理論研究,提出了利用轉子位置傳感信號間測量電機轉速進行電機轉速閉環穩速控制的策略。
  2. The load current is handled directly by the controller through semiconductor switching devices.

    負荷電流由調通過半導體開關元件控制。
  3. Long - hole and geometrical proportion type of mixing unit is finally adapted in lpg supply system, and power and torque output of lpg engine are improved by increasing compression ratio, and ignition characteristic is tried to adjusted to satisfy engine performance. meantime emission performance and noise level of lpg engine at full - throttle and other various part - throttle operations are tested and compared with former gasoline engine. ( 3 ) it is verified by engine dyno tests that lpg engine has better synthesized performance at aspects of power and torque, fuel economy, as well as emission than former gasoline engine

    選擇了等比例長孔式混合控制空燃比;通過提高壓縮比來彌補動力性的損失;以動力性為主控目標,對最大功率點、最大扭矩點、中等轉速、最低轉速點所對應的發動機轉速做了點火特性的調;通過空燃比的合理控制,改善發動機的動力性、經濟和排放指標;作為對缸內燃燒過程的理論分析,進行了燃燒特性的實驗測試;對原汽油機和新開發的液化石油氣發動機,進行了外特性和部分負荷特性以及怠速的排放及噪聲對比性測試。
  4. The modulating signals of firing delay angle at the rectifier and firing lead angle at the inverter, and the excitation voltage are chosen to be control variables. the offset of the current of dc line and the extinction angle and the power angle of generator are chosen to be control outputs. then a nonlinear controller is designed for the system under study according to direct feedback linearization theory

    以整流側觸發延遲角的調信號、逆變側觸發超前角的調信號以及發電機勵磁電壓作為控制變量,以流線路電流、逆變側關斷角以及發電機功角的偏移量作為目標輸出,用反饋線性化方法設計了系統的非線性控制
  5. Self-contained system incorporates sensor, controller and controlled device in a single package.

    作用式系統統統裝在一隻簡單的匣子里,它包含傳感,控制調機構。
  6. In this process, the thesis discusses detailedly the method which can improve the resolving power in measuring component and can deal with the probe circuit, and puts forward the design method of applied circuit. then the thesis discusses the methods of line and circle interpretation

    著又討論了計算機數控系統的控制策略,主要包括:知道預定軌跡的線與圓弧插補的方法、連續掃描系統的控制策略、 pid調的設計及pid參數的整定方法等。
  7. The dtc system is a high - performance ac driving system. but conventional speed controller in dtc system is ped adjuster, which ca n ' t make the system have enough quick response, the ability to restrict the noise and strong robustness to the parameters of the system

    作為一種高性能的交流調速系統,在轉矩控制系統中,速度調通常都採用pid調,使得系統的快速性和抗干擾能力及對系統參數擾動的魯棒性不夠理想。
  8. In the paper, a speed estimator based on artificial neural network is designed according to the principle of direct torque control, the speed estimator is optimized by genetic algorithm, and the parameters of pid speed adjuster is also optimized by genetic algorithm. a stator linkage and torque observer based on stator resistance estimator using fuzzy neural network is also designed. eventually, the intelligent control of direct torque control system is implemented

    本文根據異步電動機轉矩控制原理,在應用人工神經網路進行速度辨識的基礎上,利用遺傳演算法對神經網路速度辨識進行了優化設計;運用遺傳演算法對pid速度調的結構和參數進行了整合;在採用模糊神經網路對電機定子電阻辨識的基礎上,進行了定子磁鏈及轉矩的觀測,為最終實現無速度傳感轉矩控制系統的智能控制創造了條件。
  9. The dissertation deals in details with the basic principle of direct torque control. according to the faults of traditional direct torque control and the requirement of an induction motor ' s control strategy change the method of regulating stator flux to make its path approximate to a circle as possible as could. to get quickly torque control, use a three - value regulator

    本論文介紹了電動機轉矩控制的基本原理,並根據傳統轉矩控制存在的缺點以及對電動機調速性能的要求,改變對定子磁鏈的調方式,使定子磁鏈軌跡近似為一圓形,對轉矩採用三值調進行調,以實現轉矩的快速調
  10. Intelligent counter digital frequency rotating speed line velocity display control transmit instruments are all adopt used advanced microprocessor for smart control. input is pulsed quantity or contect switch quantity signal, after cpu operation processing, count, rotating speed or line velocity will be clearly intuitional indicated by high brightness led numeral tube, at the same time, these signals can be changed into standard voltage current signal to transmit output. and have the functions of super - limited alarm, standard serial communication function

    簡易后備操作收從dcs系統或pid調給定的模擬量信號,正常控制時,操作輸入輸出相當于通的,以實現dcs系統或pid調對執行機構的自動控制,當前級dcs系統或pid調發生故障時,操作收到故障狀態信號,即轉為手動控制狀態,由按鍵控制操作信號的輸出,當故障解除,儀表自動恢復自動狀態。
  11. Are all adopt used advanced microprocessor for smart control. input is pulsed quantity or contect switch quantity signal, after cpu operation processing, count, rotating speed or line velocity will be clearly intuitional indicated by high brightness led numeral tube, at the same time, these signals can be changed into standard voltage current signal to transmit output. and have the functions of super - limited alarm, standard serial communication function

    收從dcs系統或pid調給定的模擬量信號,正常控制時,操作輸入輸出相當于通的,以實現dcs系統或pid調對執行機構的自動控制,當前級dcs系統或pid調發生故障時,操作收到故障狀態信號,即轉為手動控制狀態,由按鍵控制操作信號的輸出,當故障解除,儀表自動恢復自動狀態。
  12. Due to the component of natural gas is very complex in different zone of our country, the product has taked on special design, it set up moore component factor of thirteen kinds, which offer user to select and setup, so as to satisfy measurement for contains various component natural gas, at the same time established many take - pressure way in order to suit to different measure device, and have automatic calculate and display super - compression factor function

    A q型操作輸出svout : 010ma 420ma 05v 15v信號,可驅動執行機構變頻或再由伺服放大去驅動電動調閥門或由電氣轉換和閥門定位去驅動氣動薄膜閥。操作處于自動工作狀態時,其信號輸入svin和操作輸出信號相當於是通的。以實現dcs系統或調對執行機構的自動控制。
  13. Each primary mirror will focus its photons onto a separate, 1. 1 - meter secondary reflector, a thin membrane attached to 672 actuators

    每一面主鏡都會將光聚焦在另一面徑1 . 1公尺的次要反射鏡上,反射鏡是有672個調的一片薄膜。
  14. Excitation system is an important part of synchronous generator. and it affects the operating characteristics of generator and power system directly. this paper discusses a new excitation regulator based on dsp ( tms320lf2407 )

    勵磁系統是同步發電機的重要組成部分,影響電機及電力系統的特性,本文介紹了一種新型的基於dsp ( tms320lf2407 )微控制的同步發電機勵磁調的設計研究。
  15. Direct torque control using space vector modulation ( svm - dtc ) scheme is discussed and the detailed designed, including space vector choosing and modulating, to overcome the control difficulties coming with the characteristic of low inductance. comparing with the basic dtc, the simulation results confirm the feasibility and good performance of this strategy. in order to reduce the torque error in dynamic state resulted from the nonlinear relationship between the torque and torque angle, a proportional - plus - integral ( pi ) torque controller with variable proportion is presented to ensure exact and quick control of torque in dynamic state

    系統的闡述了永磁同步電機轉矩控制理論,分析了改進后的svm - dtc控制策略,並具體設計了控制技術的實現方案,包括參考矢量的生成和空間電壓矢量調制的方法;為減小電磁轉矩與轉矩角非線性關系這一因數給電機電磁轉矩動態調造成的誤差,本文實現了變比例系數轉矩pi調的方案,確保了系統穩定性的同時,實現了電磁轉矩在動態過程中快速而準確調
  16. The system of dtc with a three - value torque regulator

    採用三點式轉矩調轉矩控制系統
  17. According to the fault of complicated calculation - control, characteristics easily affected by the induction motor ' s parameters and the different result between practical function and theoretical analysis in vector control and the defect of the traditional dtc, i designed a new dtc which uses a three - value regulator to get quickly torque control and adopt the control scheme of invariable magnetic chain to improve the performance of adjusting velocity of the induction motor

    由於矢量控制技術中出現的運算復雜、特性易受感應電動機參數的影響和實際運行結果難于達到理論分析的結果等缺點,以及傳統的轉矩控制方法的不足之處,設計了新的轉矩控制方案。這種方案是應用三值調來獲得快速的轉矩控制,並且採用磁鏈恆定的控制方法以提高異步電動機的調速性能。
  18. The structure of human body and function all very complex, the function of each organ, system inside body and all sorts of physiology processes are not to isolate the ground undertakes severally, be in however neurological direct or adjust secondhand below control, cooperate mutual connection, mutual influence, closely, make human body becomes a complete and unified organism, come true and keep normal life activity

    人體的結構與功能均極為復雜,體內各官、系統的功能和各種生理過程都不是各自孤立地進行,而是在神經系統的或間調控制下,互相聯系、相互影響、密切配合,使人體成為一個完整統一的有機體,實現和維持正常的生命活動。
  19. For the direct current decouple controller, the p1 adjustor ? parameter of current and voltage loop ? is designed. the correction of the designed parameter is testified by simulating on two phase synchronization coordinate and three phase stationary coordinate, the simulation wave is given

    電流解耦控制的電流環和電壓環的pi調參數進行了設計,並通過在兩相同步坐標系與三相靜態坐標系的模擬驗證了設計參數的正確性,同時也驗證了電流解耦控制方案的可行性,給出了模擬波形。
  20. In ordinary dtc, schmitt trigger is usually employed in the regulating of torque and stator flux, which resulted in the unavoidable influence of the tolerance of the regulators on system performance

    轉矩控制中,轉矩調和磁鏈調一般均採用施密特觸發,這樣系統性能的好壞就與兩個調容差的大小密切相關。
分享友人