相位差計 的英文怎麼說

中文拼音 [xiāngwèichājì]
相位差計 英文
phase meter
  • 相 : 相Ⅰ名詞1 （相貌; 外貌） looks; appearance 2 （坐、立等的姿態） bearing; posture 3 [物理學] （相位...
  • 位 : Ⅰ名詞1 （所在或所佔的地方） place; location 2 （職位; 地位） position; post; status 3 （特指皇帝...
  • 差 : 差Ⅰ名詞1 （不相同; 不相合） difference; dissimilarity 2 （差錯） mistake 3 [數學] （差數） differ...
  • 計 : Ⅰ動詞1 （計算） count; compute; calculate; number 2 （設想; 打算） plan; plot Ⅱ名詞1 （測量或計算...
  • 相位 : phase position; phase
  1. As a result, the electromagnetic field intensity is changed accordingly and fluctuating current in the damper coil is created. damping force is mostly produced because of the phase difference between fluctuating current and displacement of rotor. the formulas of fluctuating current and damping coefficient are deduced theoretically, and the calculated results are consistent with the experimental results

    通過分析發現電磁阻尼器線圈內由於轉子渦動時變化的磁場而產生的波動電流與轉子位移間的相位差是產生阻尼的主要原因，推導了波動電流、阻尼系數的計算公式，並通過實驗展示了被動式電磁阻尼器的阻尼效應。
  2. Therefore, the three fundamentals required to obtain high precise measurements are : 1 ) frequency stability and frequency difference stability of the double - frequency laser source as well as the stable equivalent length of bore ; 2 ) the measuring beam and the reference beam are placed very co - axially ; 3 ) capability of recording the sub - division of the period of phase change and a reversible counter system

    因而干涉儀系統達到高精度的基礎是：頻率及頻差穩定的雙頻激光源、穩定的等效腔長；測量光與參考光合光後有很高同軸度的光路結構；能可靠記錄相位差變化周期數的細分及可逆計數系統三部分。
  3. Through coordinated control of wuyi road, a main artery in changsha, we can calculate offsets by graphical analysis in the simulation software

    通過建立長沙市五一路線控系統，可以迅速在模擬軟體中對相位差進行圖解法的計算。
  4. Data reduction was carried out in real time by a minicomputer. the microcora was replaced by a more advanced version, digicora, in 1993

    地面站即時用一部小型電腦從轉播信號的相位差計算出無線電探空儀的位置，從而計算出高空風向和風速。
  5. In order to solve need badly three - ring type gear reducer ( problems of high vibration, high temperature and short spin arm bearing life in operation, by means of power separation flow, elastic ring equilibrating load, tardy down and assimilation vibration of synchronous belt transmission, and mechanism balance principle, the author designs a new type three - ring type gear reducer with arc tooth synchronous belt transmission, the gear reducer is fully balancing, equilibrating load and reducing vibration and phase difference 180 ( of mass eccentricity

    為解決一般三環減速器振動大、溫升高和轉臂軸承使用壽命短等生產中迫切需要解決的問題，依據功率分流、彈性環均載、同步帶緩沖及吸振和機構平衡原理，設計出了一種具有圓弧齒同步帶傳動的完全平衡、均載減振，偏心相位差為180的新型三環減速器。
  6. On the basis of single mode superposition states, the squeezing and quantum statistical properties in the two - mode superposition states have been studied. the influences of the photon number, photon number difference, coefficients in the states and their relative phase on these non - classical properties have also been discussed. we have compared the results in the two - mode superposition states with those in the single - mode case

    在單模光子數疊加態的研究基礎上，研究了雙模光子數疊加態的壓縮性質和量子統計性質，討論了疊加態中粒子數、粒子數差、疊加態系數及疊加相位差對壓縮性質及量子統計性質的影響，並將其結果與單模疊加態進行了比較。
  7. However, df pre - processing is not required in a interferometer direction finder. it only makes use of the phase relations or differences of sensors disposed at different position. azimuth and elevation are caculated from the phase differences or displayed directly on a crt drived by the voltage or current from the phase differences

    干涉儀測向不必進行測向信號預處理而是直接或間接求取在空間上分開的傳感器上感應電勢之間的相位關系，即干涉相位差，方位角或仰角是直接由干涉相位差計算得到，或將兩基線正交的天線陣的干涉相位差轉化為驅動電壓（電流）分別加到crt陰極顯示器的垂直偏轉線圈和水平偏轉線圈，模擬顯示出來波方位，干涉儀測向為典型的相位測向方法。
  8. In former, image - reject mixer uses phasing to differentiate between two single - balance mixers. it ' s four diode is type of dmk - 2606 by made alphar corporation, module of mixer ' s integrated circuit is simulate by senerade 8. 0 and ads software

    然後介紹了混頻器的基本原理，設計了鏡像抑制混頻器和上變頻器放大電路，鏡像抑制混頻器是利用兩個單平衡混頻器的相位差對鏡頻進行抑制，其中四個混頻二極體採用alphar公司dmk - 2606型。
  9. Experimental results show it can find the rough toa range in order to lessen the computation burden, while getting rid of glints and disturbing components attached to the phase difference signals, the paper suggests a data compression procedure combined with dynamic smoothing

    為了減小擬合計算量並盡量濾除疊加在相位差序列上的干擾起伏，採用了數據壓縮結合滑動平均的預處理方法，並對該方法的正確性和有效性進行了方差分析驗證。
  10. The system can generate sweep frequency signal with frequency range from 100khz to 150mhz and power range from - 40dbm to + 18dbm, and measure the gain and phase of the crystal. according to the gain and phase information and the iec - 444 standard, crystal parameters can be calculated, such as nominal frequency, series resistance, shunt capacitance, motion capacitance, motion inductance, q factor and so on

    該系統能產生頻率范圍達100khz 150mhz ，功率范圍為? 40dbm + 18dbm的掃頻信號，並能對晶振的增益和相位差進行測量，其測量結果按照iec - 444晶振測量標準進行實時處理和計算，從而得到晶振的串聯諧振頻率、並聯諧振頻率、等效電阻、靜態電容、動態電容、動態電感和品質因數等主要電參數。
  11. The method, combining the aff with sga, can accurately track the signal frequency and calculate the phase difference between two signals

    它將自適應funnel波器和滑動goertzel演算法結合起來，能夠精確地跟蹤信號的頻率，計算相位差。
  12. The simulation results show the method can attain our aim under harmonic condition. then the calculation errors have been analyzed

    模擬結果表明，在有諧波干擾的情況下，數字鎖相環方法可以準確地跟蹤信號頻率的變化和計算相位差。
  13. According to the features of the signal of cmf, i. e. the signal frequency varies in a small range and the signal is subjected to the harmonics, a digital method based on a digital phase locked loop is used to process the signals of cmf, tracks the change of the signal frequency and calculates the phase difference. the technique proposed by the u. s. patent has been improved and made the simulation

    針對科里奧利質量流量計信號的特點，即信號頻率在小范圍內變化和信號易受諧波干擾的特點，採用基於數字鎖相環的方法處理科氏質量流量計的信號，跟蹤信號頻率的變化，計算相位差，對美國專利提出的方法進行了改進，並作了模擬。
  14. Improved design of the precise phase shift network in zero display phase measure

    零示法測量相位差中精密相移網路的改進設計
  15. The principal axis torsion angle, produced by torque, is converted to two channel square waves with phase difference through grating sensor. then the degree of torsion angle is measured by data collection card. finally the value of torque and the other parameters of the axis can be calculated by upper pc

    將主軸受扭矩作用而產生的扭轉角，通過光柵傳感器轉換為兩路有相位差的方波信號，再通過數據採集系統檢測出扭轉角的度數，最後由上位pc機計算出扭矩的大小和主軸的各種參量。
  16. 2. based on interoferometric technique, a parasitic interference configuration was introduced to transpose the wavelength - shift signal into phase - shift signal ; the strains were demodulated by measuring the phase change of the signal with a phase - meter

    利用干涉技術，採用寄生干涉結構對傳感光柵的反射譜進行波長解碼，用相位計觀測波長漂移引起干涉儀兩臂間相位差的變化，進而監測作用在傳感光柵上的待測應變量。
  17. The method based on quadrature demodulation is studied and the equations used to calculate the frequency, magnitude and phase ( difference ) of signals are given. the author has designed two kinds of low pass filters ( lpfs ) and has studied two kinds of frequency - tracking methods

    研究基於正交解調的科里奧利質量流量計信號處理方法，給出了同時求出信號的頻率、幅值和相位（差）的公式，設計兩種濾波器，研究兩種跟蹤方法，並進行模擬和比較，得到較好的方案。
  18. This text analyzed the affect to the extreme phase difference change by different design parameter （ the position parameter of eccentricity and data of eccentricity ） ， and get variety regulation ， by analyzing all data that came from optimal design process

    在對全部優化數據分析過程中，分析了相關設計參數（偏心位置參數及偏心量）變化對極限相位差的影響，並得出了相應的變化規律。
  19. After the host computer sends the broadcast command to order measurement operation, all slave devices will start to sample the input signals synchronously. when the sampling operation has finished, devices installed on the capacitive equipments will calculate the phase angle difference ( oi ) between leakage current and the reference voltage signal, and devices installed on pt will calculate the phase angle difference between secondary voltage and the reference voltage signal ( ou )

    我們把一個50hz的交流基準電源引到每臺下位機內，主機發布一個廣播命令要求pt和電容型設備上的監測裝置同時采樣，電容型監測裝置計算出泄漏電流和基準源之間的相位差_ （ oi ） ， pt上的裝置計算出二次電壓與基準源之間的相位差_ （ ou ） 。
  20. Design of digital phase difference meter based on virtual instrument

    基於虛擬儀器的數字相位差計設計
分享友人
分享到 Line

分享到臉書