相位平衡電路 的英文怎麼說

中文拼音 [xiāngwèipínghéngdiànlù]
相位平衡電路 英文
phase balancing circuit
  • 相 : 相Ⅰ名詞1 （相貌; 外貌） looks; appearance 2 （坐、立等的姿態） bearing; posture 3 [物理學] （相位...
  • 位 : Ⅰ名詞1 （所在或所佔的地方） place; location 2 （職位; 地位） position; post; status 3 （特指皇帝...
  • 平 : Ⅰ形容詞1 （沒有高低凹凸 不頃斜） flat; level; even; smooth 2 （高度相同; 不相上下） on the same l...
  • 衡 : Ⅰ名詞1 （秤桿） the graduated arm of a steelyard2 （稱重量的器具） weighing apparatus3 （姓氏） a...
  • 電 : Ⅰ名詞1 （有電荷存在和電荷變化的現象） electricity 2 （電報） telegram; cable Ⅱ動詞1 （觸電） give...
  • 路 : 1 （道路） road; way; path 2 （路程） journey; distance 3 （途徑; 門路） way; means 4 （條理） se...
  • 相位 : phase position; phase
  • 電路 : [訊] circuit （ckt）; electric circuit; electrocircuit電路板 circuit board; 電路保持 guard of a c...
  1. Monitor apparatus can measure valid value of three phase voltage and current, power factor, three phase disequilibrium, instant flecker of short time and harmonic without twenty, degree and harmonic distortion total. the paper are laid on the following. ( 1 ) master plan and function of circuit, ( 2 ) hardware design including circuit and principle of a / d conversion, phase lock, liquid crystal display and keystroke and so on, ( 3 ) design of system software including digital filtering, fft, a / d conversion and monitor interface of pc, ( 4 ) system test

    監測儀能夠完成包括三相電壓、三相電流的有效值、功率因數、三相不平衡、電壓短期閃變、以及20次內的諧波、諧波相位、諧波失真總量等的測量。論文重點介紹了以下幾部分： （ 1 ）電路的總體設計和功能； （ 2 ）硬體設計，包括a d轉換、鎖相環、液晶顯示和按鍵輸入等原理和電路。 （ 3 ）系統軟體設計，包括a d轉換、 fft 、數字濾波等程序的原理和演算法以及上位機監控界面的設計； （ 4 ）系統測試。
  2. The carrier wave is modulated directly by the baseband signal at several frequency point in l band and s band. firstly, this paper clarifies the theory of i / q modulation, elaborates evm and acpl, and analyzes the effect of amplitude and phase unbalance and dc offset on evm. secondly we review the basic principle of phase locked loop and it ’ s composing parts, including the basic conception and design method of pll frequency synthesizer, especially introduce the charge pump pll frequency synthesizer in detail

    首先，在闡述i / q正交調制基本原理的基礎上，通過對誤差矢量和鄰近通道功率泄漏的詳細分析，定性、定量地討論了各種非理想電路因素（如相位不平衡、幅度不平衡、直流偏差等）對調制器性能的影響;其次，介紹了鎖相環的工作原理和基本組成部分，包括鎖相環的設計和環路濾波器的設計，特別詳述了電荷泵鎖相頻率源;第三，介紹了採用直接調制技術模擬衛星信號的射頻前端的設計;最後，對整個直接射頻調制系統進行測試，結果基本上達到了課題要求。
  3. In former, image - reject mixer uses phasing to differentiate between two single - balance mixers. it ' s four diode is type of dmk - 2606 by made alphar corporation, module of mixer ' s integrated circuit is simulate by senerade 8. 0 and ads software

    然後介紹了混頻器的基本原理，設計了鏡像抑制混頻器和上變頻器放大電路，鏡像抑制混頻器是利用兩個單平衡混頻器的相位差對鏡頻進行抑制，其中四個混頻二極體採用alphar公司dmk - 2606型。
  4. Aiming at the feature of cm interference in power converters, a new approach ? intrinsic dynamic nodes potential balance is proposed. by building node pair with balance potential and making use of the intrinsic stray capacitor of power semiconductor devices, the cm current can be suppressed effectively

    在對共模干擾建模的基礎上，提出了內在動態節點電位平衡的思想，其思路是通過在電路內部構造動態電位平衡節點對，並利用電路中功率器件固有的對地分佈電容使得電路中的共模干擾電流互相抵消，從而抑制功率變換器的共模emi 。
  5. The resonance network is connected to the gate, then the output and input matching network is designed to satisfy the oscillation criteria. then harmonic balance method is used to analysize and optimize the output power and phase noise. to minimize the load pulling effect a buffer amplifier is designed to isolate the oscillator and the load

    本文在場效應管fet柵極上加上諧振網路（諧振網路是通過cst模擬得到的，它是串聯反饋迴路，介質工作在te01模，對于其後的fet ，它又相當於一個帶阻濾波器） ，然後設計輸入輸出匹配電路，使電路結構滿足起振條件，之後繼續用諧波平衡法模擬和優化，使振蕩器輸出功率合適，相位噪聲很低。
  6. At first, a method for controlling chaos is studied, which is based on phase switching modulation. the n - scroll chua ' s circuit is controlled to its fixed point as well as periodic orbits by using switching modulation on one its phase. its mechanism of control is analysed using the change of the max lyapunov exponent when the system is controlled

    首先，通過對多渦卷蔡氏電路中非線性特性函數的相位進行開關調制，把多渦卷蔡氏電路由混沌狀態控制到其平衡態和周期軌道，並用控制后系統的最大lyapunov指數隨時間的轉變闡述了其控制機制。
  7. During the research, finding some important as follow : if wanting to get an ideal linearity of duamoop feedforward system, needing an accurate balance of amplitude and phase, so the attenuation, the delay and the phase in the circuit must be designed accurately

    本項研究還發現，雙環前饋系統要獲得理想的線性化效果，還需要精確的幅度和相位平衡，這在電路的設計中表現為要對迴路中的衰減和延遲以及移相環節進行準確的設計。
  8. Then, memory cell array and some parts of peripheral circuits used in sram, for example, sense amplifyier and adderss decoder, are designed and verifyied by simulation. furthermore, some novel methods, such as clocked hierarchical word decoding structure, multi - stage sense amplifyier, common data line and data bus equlibruim technology has been applied in the design of 128kbit and imbit sram. what ' s more, we have studied compiler technology applied in the designing course of a imbit full cmos sram from the pointview of methology

    然後對sram的存儲單元電路以及外圍電路中的靈敏放大器和地址譯碼器進行了設計和模擬，在此基礎上，以128kb和1mb全cmossram設計為例，從方法學角度對同步sram設計中的帶時鐘分等級字線譯碼，多級靈敏放大和位線及總線平衡等技術進行了研究，並給出了相應的compiler演算法。
分享友人
分享到 Line

分享到臉書