相位響應函數 的英文怎麼說

中文拼音 [xiāngwèixiǎngyīnghánshǔ]
相位響應函數 英文
phase response function
  • 相 : 相Ⅰ名詞1 （相貌; 外貌） looks; appearance 2 （坐、立等的姿態） bearing; posture 3 [物理學] （相位...
  • 位 : Ⅰ名詞1 （所在或所佔的地方） place; location 2 （職位; 地位） position; post; status 3 （特指皇帝...
  • 應 : 應動詞1 （回答） answer; respond to; echo 2 （滿足要求） comply with; grant 3 （順應; 適應） suit...
  • 函 : 名詞1. [書面語] （匣; 封套） case; envelope 2. （信件） letter 3. （姓氏） a surname
  • 數 : 數副詞（屢次） frequently; repeatedly
  • 相位 : phase position; phase
  • 函數 : [數學] function函數計算機 function computer; 函數計算器 function calculator; 函數運算 functional operation
  1. At the other hand, we can perform the rrpa calculation with the continuum replaced by a set of outgoing single particle resonances, it indicates that the resonances in the continuum play an important role in the description of nuclear dynamical processes, such as collective giant resonances. energies, widths and wave functions of the single particle resonant continuum are determined by solving scattering states of the dirac equation with proper asymptotic conditions for the continuous spectrum in the r ' elativistic mean field theory. the relativistic regular and irregular coulomb wave functions are calculated numerically

    在進行相對論無規位相近似計算時將連續譜中所有的正能態用單粒子共振態來代替，並且在計算中採用單粒子共振態的真實寬度，利用這種方法我們計算了核的同位旋標量巨八極共振響應函數，並且和考慮了連續譜中所有正能態貢獻的結果進行比較，計算結果表明，連續譜中只考慮單粒子共振態對核的集體激發的貢獻時，給出的響應函數基本上能夠重現考慮了所有正能態貢獻時的計算結果，這說明了在核的集體激發中，連續譜中主要是單粒子共振態的貢獻。
  2. On the basis of theory analysis, the average transmitted light intensity ( correspond to dc value ) was determined as characteristic parameter of raw water using photoelectric method for monitoring the fluctuation of transmitted light and photometric dispersion analyzer ( pda ). the dc value was closely related to both particle concentration and surface area of sand clay simultaneously. the experimental results shows that there is an exponential function relation between dc and surface area of sand clay in unit volume water ( sp ) : dc = asbp in which a and b are empirical coefficients. then the formula of macromolecule flocculant dosage is found to be d = f ( dc ) = e ( dc ) f in which e and / are empirical coefficients and the average correlation coefficient equal to 0. 981. so the model of automatical control system of water treatment plant was established using the formula

    應用透光率脈動檢測技術和光散射顆粒粒度分析儀（ pda ） ，通過理論分析，將pda的輸出信號之一? ?平均透光強度（對應于dc值）作為原水的特性表徵參數， dc值可以同時反映顆粒濃度和比表面積因素的影響，試驗結果證明， dc值與單位體積水中泥沙顆粒總表面積s _ p之間具有很好的冪函數關系： dc = cs _ p ~ d ，式中c 、 d為經驗系數，進而得到了以dc值為參數的高分子絮凝劑投藥量公式： d = f （ dc ） = e （ dc ） ~ f ，式中： e 、 f為經驗系數，平均相關系數達0 . 981 ，利用所建立的公式，建立了前饋? ?后饋聯合控制的在線自動投藥模型。
  3. The engendering source of traffic volumes and their general influential factors have been presented, and the situation of nowadays highway transportation has been discussed. according to the introduction of traffic distribution theory and classical assignment method, analysis of traffic flow path selection among cities and that of special influential factors for traffic flow on toll highways, initial analysis to the forming mechanism of traffic volume on road sections has been made, and a probability model for path selection has been set up with the maximum - utility theory and disaggregating model. detailed analysis to impedances on road sections and their functions ( especially to three main composing factors of the impedances as cost of time, transport and toll and to the functional relations with traffic loads ) was made, at the same time, the relative cost calculating model was set up on the basis of the state - of - art achievements in both international and national researches

    主要研究內容包括：交通量的產生根源及一般影響因素分析和當前公路運輸地位討論；從交通分配理論及經典配流方法著手，通過分析城市間交通流路徑選擇行為和收費公路路段交通量特殊影響因素，初步提出路段交通量的形成機理，並採用效用極大原理和非集結模型理論（ disaggregationmodel ） ，建立用戶出行路徑選擇概率模型；對路段阻抗及路阻函數（尤其對行程時間費用、車輛營運費用和道路收費這三個構成路段阻抗的主要因素及其與交通負荷間的函數關系）進行較為詳盡的分析，並以現階段國內外較為先進的研究成果為依據建立相應的成本測算模型，其中，特別提出了兩種確定客貨車輛時間價值的分析方法；離散分析法和時間-費率轉換法，後者是在目前基礎調查、統計數據資料不夠齊全的現實下提出的一種確定道路系統內務車型時間價值的較為實用的新方法；對我國公路收費政策的背景和理論、實踐依據及費率的各種影響因素進行重點分析；從數學的角度證明合理費率的存在性，並以最優化理論為基礎，建立在普通收費公路和擁擠路段交通調控型收費公路兩種模式下合理費率的計算模型等。
  4. It really provides convenience to evaluate and optimize the design result. 3 ) vibration analysis has been fulfilled by calling some math libraries and graphic libraries in matlab to plot graphics such as velocity - time, displacement - velocity, step response, impulse response, gain - frequency and phase - frequency. we can know the capabilities of the spring system from the graphics

    3 、在matlab環境下調用相應的數學函數庫和圖形庫對設計的彈簧進行分析，繪制彈簧加載后系統的速度-時間響應曲線、速度-位移響應曲線、階躍響應曲線、脈沖響應曲線、增益-頻率響應曲線和相角-頻率響應曲線，根據曲線來分析系統的各項性能。
  5. This paper relates to some problems about the determination of design ground motion parameters, which include the choice of the attenuation relationship of rock horizontal acceleration response spectrum, the impact of focal depth to rock peak horizontal acceleration and rock response spectrum curves, the choice of intensity envelops function and random input phase, the choice of soil nonlinearity and shear wave velocity, scale of design ground motion response spectrum etc. in the researches of relative aspect, based on a typical section plane of the engineering site, influence of the change of some parameters on design ground motion parameters and the existing errors and corresponding rules are studied by using the method of one dimension model of equivalent linearization

    摘要研究了確定設計地震動參數中涉及的若干問題，其中包括基巖水平加速度反應譜衰減關系的選擇、震源深度對基巖水平加速度峰值及基巖反應譜曲線的影響、強度包絡線函數及輸入隨機相位的選擇、土體非線性特性參數和土層剪切波速值的選擇、設計地震動反應譜的標定等問題。
  6. It ’ s known from the transportation function that the dispersion can only influence the phase of optical pulse ’ s spectrum, which can be easily described by a frequency transfer function

    該方程表明:色散效應只會影響頻譜的相位，而對頻譜的強度分佈沒有影響，而且色散效應可以簡單的由傳遞函數表示出來。
  7. So a computer - aided alignment method for a series of reference lens is studied in detail in this paper. based on analyzing the optical quality affecting factors and optical design, the folio wings are described in detail in this paper : ( 1 ) how to choose merit function of optical quality in terms of the specific reference lens, and sensitive structure parameters to optical quality would be determined according to their tolerance data ; ( 2 ) discussing the relationship between the aberrations and the misalignment of reference lens ; ( 3 ) building the mathematical model for the misalignment optical system, and then calculating the misalignment value by the alignment software compiled on zemax and matlab platforms ; ( 4 ) experiments are made to examine the computer - aided alignment method. the theoretical and experimental data and plots are given in the paper

    本文在分析標準球面透鏡的設計及其光學質量的影響因素基礎上，開展了以下四個方面的研究： （ 1 ）根據系列標準球面透鏡的具體結構特點，選擇透鏡的質量評價指標，研究標準球面透鏡的公差分佈，確定敏感結構參數； （ 2 ）研究光學質量評價指標與失調量之間的函數關系； （ 3 ）建立數學物理模型，根據球面波的實測結果，求解待調系統的失調方位和量值，研究原理上實現計算機輔助裝調的可能性，在zemax和matlab平臺上編寫輔助裝調軟體； （ 4 ）建立實驗裝置，實際研究標準球面透鏡的計算機輔助裝調方法，文中給出相應的理論分析及實驗數據和曲線。
  8. Geometric nonlinear behaviors in large span cable - stayed bridges have been analyzed in this paper, which include the sag of inclined cable stays caused by their own dead weight ; the interaction of large bending and axial deformation in bending members ; and the large displacements effects. then analyzing theories and researching levels of geometric nonlinear problems of modern cable - stayed bridges have summarized. and methods of modeling cable - stayed bridges for nonlinear finite element analysis have been discussed, which are the equivalent modulus of elasticity, introducing stability functions and continuously modifying geometry of structure

    本文分析了大跨徑斜拉橋幾何非線性的主要影響因素，包括斜拉索的垂度效應、彎矩與軸向力組合效應和大變形效應，同時對目前斜拉橋幾何非線性問題的分析理論和研究水平進行了綜述，相應討論了各非線性影響因素的處理方法，即分別採用等效彈性模量法、引入穩定性函數和實時修正結構的幾何位置。
  9. Based on above performances the applications of multi - sensor data fusion in state estimation for maneuvering target is studied systemically. the main work includes : based on the analysis that the extreme value of acceleration presupposed causes influence in the “ current ” statistical model, a modified model is given, which utilizes the functional relationship between maneuvering status and estimation of the neighboring intersample position vector to carry out the self - adaptive of the process noise variance. then combining with the recursive characteristic of kalman filter, an improved self - adaptive filtering algorithm is presented

    基於此，本文針對多傳感器數據融合技術在機動目標狀態估計中的應用進行了系統的研究，其主要工作如下: 1 、基於「當前」統計模型中加速度極限值的預先設定對于濾波效果影響的分析，利用目標機動狀況與相鄰采樣時刻間位置估計量變化之間的函數關系實現噪聲方差自適應，進而提出了一種修正的模型，並結合卡爾曼濾波遞推演算法，提出了一種改進的自適應濾波演算法。
分享友人
分享到 Line

分享到臉書