相析出 的英文怎麼說

中文拼音 [xiāngxīchū]
相析出 英文
phase precipitation
  • 相 : 相Ⅰ名詞1 （相貌; 外貌） looks; appearance 2 （坐、立等的姿態） bearing; posture 3 [物理學] （相位...
  • 析 : Ⅰ動詞1. （分開; 散開） divide; separate 2. （分析） analyse; dissect; resolve Ⅱ名詞（姓氏） a surname
  1. Abstract : through analysis of the components of coking on different parts of desullfur system of single tower and the waste water containing sulfur, we find the cause of coking in the stripping desulur system from single tower is the polymerization reaction of carbohydrate and the separattion of varied solid powders, organic compounds, and all corrosive productions of metal out of waste water in high temperature, therefore, the solving method is how to decrease the oil content, how to depolymerize form the carbohydrate and how to antisepticize by vapour of waste water

    文摘:對單塔脫硫系統中不同部位的垢物及現場催化含硫污水進行了分析測定，結果表明：塔內污垢成分及含量隨塔體部位的不同而不盡相同，單塔汽提脫硫系統中垢物的形成，主要是由於污水中所含各類粉塵、有機物、金屬腐蝕物等在高溫下因石油碳氫化合物的析出及其單體的聚合反應所致.如何降低污水中的含油成分、減少聚合反應的生成、防止污水蒸氣對塔體材料的腐蝕，是阻垢、除垢和防垢應解決的關鍵問題
  2. Based on the analyses on mechanical properties, microstructure and fracture of - the microalloyed steels socrv with various heat treatment technique, it can be affirmed that various fractures arttribute to various mechanism, we can draw conclusion that the strength and toughness of microalloyed steels 50crv will be increase simultaneously by optimal heat treatment technique. to illustrate the mechanism of the strength and toughness of microalloyed steels socrv, we designed the comparative experiment and observed the microstructure of the sample which occurred at different quench and tempering temperature and different tempering time. the last experiment results were determined by the four factors : fined microalloyed elements grains, the decompound of martensite, martensite transformation of remnant austenite and the second phase precipitation

    為解釋微合金化50crv鋼強韌化機理，本文通過對不同淬火溫度，回火溫度，回火時間下的力學性能指標的對比及顯微分析，認為微合金元素的細化晶粒，馬氏體的回火分解，殘余奧氏體的轉變，第二相的沉澱析出共同決定了微合金鋼的強韌化情況，特別是由於微合金元素的存在，其細化晶粒及其碳氮化物的沉澱析出，導致鋼的良好的強韌性，並且如果工藝滿足第二相的沉澱析出強化大於回火馬氏體分解引起的軟化效應，會在硬度曲線中產生明顯的二次硬化現象。
  3. In experiment, the dsc technique was used to analyze the effect of electric fields on the precipitate kinetic of al - li alloy solutionized with electric fields. the energy spectrum, tem and sem techniques are employed to investigate the elements solution, precipitates, fracture character, conductivity and vickers hardness. also, the solidification of al - cu eutectic alloy was conducted with the influence of electric fields

    在實驗上，利用dsc熱分析技術，分析了電場作用對al - li合金相析出動力學的影響；採用能譜成份檢測，透射電鏡和掃描電鏡等多種微觀檢測手段，對鋁合金的析出相，斷裂特徵、合金電導率和維氏硬度等性能在電場作用下的變化進行了系統的研究，並觀察了al - cu共晶合金在電場作用下的凝固組織。
  4. This phenomenon was closely related to the transportation and extraction rate of carbon atoms in the surface of catalysts at different temperatures

    這種現象與不同溫度下碳原子在催化劑表面的遷移和析出速率密切相關，也即與不同溫度下催化劑的活性有關。
  5. By analyzing and predicting the microclimate in greenhouse in typical weathers, the conclusions are that high temperature with low humidity weather and high temperature with high humidity appear one after the other. the measures are proposed as the followings : to the former, it should be taken to decrease the temperature with soppy shade - fan or spray inside or outside ; to the latter, it should be taken to enlarge the ventilation area, to fit spray apparatus at the top of roof outside, to adopt havelock outside instead inside, to coat the roof white, etc

    通過對典型天氣下溫室小氣候變化規律分析和預測，其結論是：從7月中旬到8月中下旬，室內相繼出現高溫低溫和高溫高濕天氣，建議分別採取的適宜措施是：濕簾-風機降溫、高壓噴霧降溫、屋頂噴淋降溫和增大屋頂通風窗的通風面積、安裝屋頂噴淋（霧）設備、改溫室內遮陽為外遮陽、塗白溫室屋頂等。
  6. It also has physi - chemical analysis instruments for testing material compositions, metallograph ( analyzing the structure of raw material correctly and clearly )

    還擁有材料成份檢測的理化分析器、金相測試儀（通過對材料能夠準確清楚的分析出原材料的組織結構） 。
  7. All data indicated that f i was a pure substance. third, using modern analytic techniques such as nucleic magnetic resonance ( nmr ), infrared spectroscopy ( ir ), ultraviolet visible absorption spectra ( uv ) and mass spectrometry ( ms ), we analyzed the basic chemical structure of f i and nominated it phthalic acid di ( 3 - methyl ) nanyl ester ( pdne ). we estimated primarily it was a novel natural compound

    第三，利用核磁共振，紅外光譜，紫外分析，質譜等現代分析測試技術對分離提取物f進行結構鑒定，解析出f的結構，初步推斷該物質為鄰苯二甲酸- （ 3 -甲基）壬酯（ pdne ） ，根據目前所掌握的資料，還沒有檢索到該物質相關的報道，初步認定為一種新型的天然產物。
  8. It is just the difficulty that the strongly correlated electron systems can not be studied by analytical methods, a variety of simulative numerical methods come out sequentially. there are a few typical methods such as the exact diagonalization ( ed ), the qutum monte carlo ( qmc ), the variation monte carlo ( qmc ), the renormalization group ( rg ), and the density matrix renormalization group ( dmrg ) and so on

    正是強關聯系統遇到了解析研究的困難，各種數值模擬方法才相繼出現，最典型的數值方法有：嚴格對角化（ ed ） ，量子蒙特卡洛（ qmc ）模擬、變分蒙特卡洛模擬（ vmc ） 、數值重整化群（ rg ）以及密度矩陣重整化群（ dmrg ）等。
  9. This paper presents the principle and the maximum resolution of the spectral imaging followed by taking a case study as an example to discuss the application of this technique to sedimentary facies classification and the practical significance of it in progradation and retrogradation identification of sedimentary environment

    從理論基礎分析出發，首先介紹了頻譜成像的原理、最大解析度，然後結合國內某油田的實際情況，闡述用頻譜成像技術進行沉積相劃分以及判斷沉積環境水進水退的方法及實際效果。
  10. In order to improve the utilization efficiency of energy and equipment, a general steady simulation model of complex cross - feed multi - effect evaporation was established for the purpose of in - depth research on rule of multi - effect evaporation. in this model, the energy - saving measures, including extra steam being led off to preheat material liquid, the condensation water flash and solution flash, were adopted, and the solid separation was also considered in the process of evaporation

    為了提高多效蒸發系統能量與設備的利用效率以及深入研究多效蒸發過程的規律，建立了帶有冷凝水閃蒸、溶液閃蒸和引出額外蒸汽預熱原料液等節能措施並考慮蒸發過程有固相析出的復雜錯流多效蒸發穩態模擬通用模型。
  11. Caculation is carried through adopting mechanism function of the first order reaction, f1 : f ( ) = l -. the results have good linear relativities, a, the precipitated fractions are excellently representative, and f1 is ascertained the most probably mechanism function of " phase precipitation. the electric field reduces activation energies of " phase precipitation and average sizes of " particles both in 2090 and 1420 alloys

    採用一級反應的模型函數f1 ： f （ ） = 1 - ，計算了相析出的動力學，計算結果具有良好的線性相關性，並且具有很好的代表性，確定f1為相析出的最概然機理函數；電場固溶使2090合金和1420合金升溫時效過程的相析出激活能有一定程度的減小，並減小了相顆粒的平均尺寸。
  12. The reversion and precipitation of the second phase which occurs during the course of aging result in electronic conductivity reversion of bar

    時效處理對導條組織和性能的影響是因為時效過程中先後發生了回復、再結晶和第二相析出。
  13. Kinetics of 8 " phase precipitation and influence of electric field applying during solution process are studied by differential scanning calorimetry ( dsc ) technique

    以示差量熱分析技術（ dsc ）研究相析出的動力學及固溶電場的影響。
  14. Strengthening phase mg2si is precipitated in the structure of alloy

    組織中有強化相mg _ 2si相析出。
  15. The interaction of 8 " and t, phases is improved and the composite phase of 8 " and p " increase. both positive and negative electric fields have the similar effects

    電場固溶促進'一相析出，合金中6相的和t ；相的交互作用增強，且廠相和各相的復合相增多。
  16. The dsc results show that the electric fields have little influence on 8 " precipitation of al - li alloy. there is little change of the 8 " precipitate fraction and rate

    首次對電場作用后合金的析出動力學研究， dsc測量分析表明，電場固溶對鋁鋰合金'相析出動力學影響不大， '相的析出百分數和析出速率變化不明顯。
  17. Both the smco5 phase and the sm2co17 phase appear while the annealing temperature is higher than 700. the texture of the thin films is influenced by the annealing temperature remarkably

    結果表明，在低於700的溫度退火時，主要是smco5永磁相析出，而在高於700的溫度退火時，薄膜中同時有smco5和sm2co17永磁相析出。
  18. 6. through analysis and discuss of the precipitation mechanism of cr phase, it can be deduced that primary ( cr ) phase exhibits petal shape or triangular due to solute and heat flow in local fluid

    6通過對初生相（ cr ）相析出機制的初步分析和探討，認為由於熔體局部的溶質和熱流波動，初生相的生長形態有花瓣狀或三棱形。
  19. The mechanical parameters at high temperatures - reduction in area ( ra % ) and tensile strength ( o b ) are measured by means of gleeble - 2000 thermal simulating machine. fracture surfaces are analyzed by scanning electron microscopy and optical microscopy. the segregation of sn is also examined by auger electron spectroscopy

    通過測定試驗鋼種的高溫力學參數（斷面收縮率ra和抗拉強度_ b ） ，觀察金相顯微組織，分析掃描斷口形貌，測試第二相析出物和俄歇能譜試驗等方法，研究了殘留元素sn及冷卻速率對高溫力學性能的影響。
  20. Material balance and energy balance equations of complex multi - effect evaporation system were expressed in matrix equation, which has the advantages of clear structure and high modularization. by holding or omitting correlation block - matrix in matrix equation, matrix equation could be used to describe the difference of forward - feed, back - feed and cross - reed multi - evaporation system with or without solid separation, extra steam being led off to preheat material liquid, condensation water flash, or solution flash. the models include design and operation

    該模型利用矩陣方程具有結構清晰和高度模塊化的特點，將復雜多效蒸發系統的物料及熱量衡算方程組以矩陣形式表達，通過保留或舍棄矩陣中特定功能模塊，模型就能代表有或無固相析出、有或無引出額外蒸汽預熱原料液、有或無冷凝水閃蒸、有或無溶液閃蒸等不同情況以及各種情況任意組合的併流、逆流、錯流多效蒸發過程，從而實現模型的通用性。
分享友人
分享到 Line

分享到臉書