矩形源 的英文怎麼說

中文拼音 [jǔxíngyuán]
矩形源 英文
rectangular source
  • 矩 : 名詞1. （畫直角或正方形、矩形用的曲尺） carpenter's square; square2. （法度; 規則） rules; regulations 3. [物理學] moment
  • 源 : 名詞1. （水流起頭的地方） source （of a river）; fountainhead 2. （來源） source; cause 3. （姓氏） a surname
  1. Based on these theories, this paper discusses the method of design of the rectangular gunn integrated active microstrip patch antenna in detail. the size of the active antenna and the location of the device in the antenna is obtained at the specified operation frequency

    根據這些理論，詳細討論了一種集成gunn二極體的矩形有源微帶貼片天線的設計，得到了在給定的工作頻率下的有源天線尺寸和有源器件的位置。
  2. The best optimum mathematical model is constituted. scalar factor of structural parameter on loop rectangular negative pressure and adsorption slide is calculated. structural parameter, air gas source pressure carrying capacity and thickness of air cell are made sure by hydrodynamics and the theory of gas lubrication

    詳細論述了導軌副的設計過程，運用數學上的拉格朗日條件極值求解法，建立最優化數學模型，求出環矩形負壓吸附導軌的結構參數的比例情況，並運用流體力學和氣體潤滑理論確定了環矩形負壓吸附導軌的結構參數、氣源氣壓、承載能力和氣膜厚度的確定性結論。
  3. The light guiding unit on the surface is composed of sub - micron gratings whose transmission wavelengths are red, green and blue in order. the light source are red 、 green 、 blue led or semiconductor laser array. to enhance the light utilization, the surfaces of light guide plate except the incident and transmitted surfaces are coated with metallic film

    本文設計的亞微米光柵型導光板為矩形狀的，導光板上表面的導光單元是由三套出射光主波長分別是紅光632 . 8nm ，綠光521nm ，藍光441 . 6nm的亞微米光柵組成，光源採用的是紅、綠、藍三色發光二級管或者半導體激光器陣列，為了提高光能利用率，除入光面和出光面外，導光板其餘面都鍍上金屬膜。
  4. The distribution of magnetic induction in rectangular soft - contact mold during electromagnetic continuous casting ( emcc ) was investigated considering the electric frequency

    摘要研究了在電磁軟接觸連鑄過程中，電源輸入頻率的變化對矩形電磁軟接觸結晶器內的磁感應強度分佈規律和彎月面變化情況的影響。
  5. Source excitation and parameter extraction for time - domain simulation of rectangular waveguides

    矩形波導時域模擬中的激勵源設置和參數提取
  6. Notsrccopy copies the inverted source bitmap to the destination

    Notsrccopy將源位圖的反色拷貝到目標矩形中。
  7. Specifies the width ( in logical units ) of the destination rectangle and source bitmap

    指定目標矩形和源位圖的寬度（邏輯單位） 。
  8. Specifies the height ( in logical units ) of the destination rectangle and source bitmap

    指定目標矩形和源位圖的高度（邏輯單位） 。
  9. Mergepaint combines the inverted source bitmap with the destination bitmap using the boolean or operator

    Mergepaint使用or運算符組合源位圖的反色與目標矩形的顏色。
  10. Srcerase inverts the destination bitmap and combines the result with the source bitmap using the boolean and operator

    Srcerase反轉目標矩形的顏色，再使用and運算符將該結果與源位圖組合。
  11. Mergecopy merges the colors of the source rectangle with the brush currently selected in hdcdest, by using the boolean and operator

    將源矩形中的顏色與當前目標設備環境選中的畫刷通過邏輯與操作進行混合。
  12. By means of the rectangular d iaphragm and two orthogonal cylinder lens, the collimated laser is shaped, which is stretched and compressed respectively in two different directions, and the l ine source with ideal shape is achieved

    並應用矩形光闌和兩個相互垂直放置的柱面鏡，對準直后的激光束進行整形，分別在不同的方向進行拉伸和壓縮，得到了形狀理想的線光源。
  13. On the base of analysis of hydrologic geology from aquifer distribution, boundary conditions and dynamic characters etc. in the research area, the paper sums up the hydrologic geologic condition, builds up the conceptual model of groundwater resource evaluation and presents 2d calculation model, as well as numeric solution and computing flow chart. after introducing general solutions of mathematic models and implementation method of rectangular grid, the paper realizes the automatic technique of spatial dispersion rectangular grid of evaluation models based on gis. finally, the paper fulfills the integration of gis with groundwater resource evaluation models from gis - based basic management information, spatio - temporal dispersion of models, definition of subprogram and visual evaluation of parameters, as well as models simulation etc., and visualizes the results of evaluation models

    論文以地下水超采?地下水降落漏斗?地面沉降現象較為嚴重的常州、武進地區作為研究評價區域，在對評價區域的含水層分佈、邊界條件和動態特徵等水文地質條件分析的基礎上，概化了其水文地質條件，構建了相應的地下水資源評價概念模型與數學模型，並給出其數值解法和相應的計算流程；論文在介紹數學模型的兩種常用數值解法和模型空間離散的矩形網格生成技術的基礎上，實現了基於gis的評價模型空間離散矩形網格的自動生成；最後，論文從基於gis的評價模型基本信息管理、模型空間時間離散方法、子程序包與模型計算參數可視化賦值、模型的擬合等方面實現了gis與評價區域的地下水資源評價模型的集成，並將模型評價結果可視化。
  14. In this circuit, reference current sources are used to charge and discharge capacitors. this oscillator ’ s output is very ideal through control circuit under 5. 7v reference voltage, and oscillator ’ s frequency and duty - cycle could be adjusted if reference current source or capacitors in the circuit was adjusted. and the changes of temperature and voltage affect stabilize of the frequency little

    此電路利用系統內部基準源產生的電流信號來對電容進行充放電，然後經過控制電路作用后，產生的輸出振蕩波形的上升時間和下降時間非常小，更接近理想矩形波形;通過調節基準源電流信號或者電容值大小，可調節振蕩波形的頻率和占空比，同時溫度和電壓的變化對振蕩器輸出波形頻率穩定度的影響很小。
  15. Take the normal graded granularity for example, the curve function of the collaring rectangle was derived, which can provide a kind of mathematic model for drawing the lithologic frame of terrigenous elastic rocks in the second development of graphic software

    為了彌補繪圖軟體的這些不足，提出用曲邊矩形代替矩形來繪制陸源碎屑巖巖性框架，並以表示正粒序陸源碎屑巖巖性框架的曲邊矩形為例，詳細推導了其曲邊的函數表達式，為繪圖軟體的二次開發提供了陸源碎屑巖巖性框架繪制的一種數學模型。
  16. If the rectangle exceeds the source surface, it is clipped to the source surface

    。如果該矩形超過源圖面，將對其進行剪裁，直至與源圖面相同。
  17. Abstract : the principal characteristics of pulse power supply with large current are described. the survey of pulse electrochemical machine and the processing technique are introduced. some application examples of pulse electrochemical machining in die - sinking are given

    文摘:簡述了大電流矩形波脈沖電源的基本特點；介紹了脈沖電解機床及加工工藝概況；列舉了脈沖電解加工工藝在模具加工中的應用實例。
  18. Finite difference method can deal with regular boundary conditions. in this paper, we discrete the water domain into rectangular meshes, and simulate the propagation, reflection and diffraction of water waves. we just specify waves source, the movement of water waves can be simulated automatically

    有限差分方法能夠處理具有規則邊界水域的水流現象，在本文中，我們把求解的水域離散成結構矩形網格，對水流的折射、反射、繞射等水流現象進行了動畫模擬，我們僅僅指定產生水流動畫的波源，水流動畫的細節均由數值方法產生，不需要人工的干預。
  19. Srcinvert combines the colors of the source and destination rectangles by using the boolean xor operator

    將源矩形的顏色與目標矩形進行邏輯異或操作。
  20. As for the building wall face is the plane, it is feasible to use multi - mirror images method. but when the building is not only the rectangle ( being the polyhedron ) and the buildings is not merely justified parallel, sheltering tests and mirror image source ' s finding are fairly more complicatedly, and the calculation amount is great

    對于建築物墻面是平面的情況，用多鏡像法是可行的，但當建築物不是矩形（是多面體） ，並且排列不是平行對齊時，遮擋測試和鏡像源找尋就比較復雜，計算量大。
分享友人
分享到 Line

分享到臉書