石墨催化劑 的英文怎麼說

中文拼音 [dànmòcuīhuàjì]
石墨催化劑 英文
graphite catalyst
  • 石 : 石量詞（容量單位, 十斗為一石） dan, a unit of dry measure for grain （= l00 sheng）
  • 墨 : Ⅰ名詞1 （寫字繪畫的用品） china [chinese] ink; ink cake; ink stick2 （寫字、繪畫或印刷用的顏料） ...
  • 劑 : Ⅰ名詞1 （藥劑; 制劑） a pharmaceutical or other chemical preparation 2 （某些有化學作用的物品） a...
  • 石墨 : black lead; graphite: [礦]plumbago石墨棒 graphite rod; 石墨電極 graphite electrode; 石墨潤滑劑 aq...
  1. The catalyst for this reaction is iron chromium oxide with graphite as a binder.

    進行這種反應的催化劑是以石墨為粘接劑的鐵鉻氧化物。
  2. While if pulse laser ablation is applied, the output of mixed target is obviously more than that of plumbago target. the carbon nanotubes prepared by nano - tungsten catalyzer are very straight without any bent and their diameters are under 10nm. it is worth to pay more attention and need to study further

    其中以鎢作為催化劑原料與石墨混合製成固體靶，蒸餾水作為流動相時，得到的納米纖維狀產物直徑不到10nm ，而且形狀筆直，值得關注，目前國內外尚無以鎢作為催化劑成功制備納米一維碳材料的報道，因此該研究具有嶄新而廣闊的研究前景。
  3. Carbon nanotubes were separately synthesized by a new pulsed laser ablation ( pla ) for in - situ growth method and cvd support method in this paper. ft - ir, uv - vis, xfs, laman, tem, xrd, bet methods were used to characterize the sol, carbon nanotube and other products in the experiment. in the pla method, the sols containing carbon nanotubes were successively obtained by using 1064nm pulsed laser to ablate the interface of fe / c, or ni / c targets and ethanol under common temperature and pressure, and then carbon nanotubes were directly acquired by evaporating the ethanol

    脈沖激光轟擊原位生長法是在常溫常壓下使用1064nm波長的脈沖激光轟擊目標靶與乙醇流動相的固液界面來連續制備含有碳納米管的溶膠，進而除去乙醇相得到碳納米管，其中目標靶為石墨與fe 、 ni等金屬催化劑混合壓製成的靶片； cvd基體法是使用自製的六方介孔mcm - 41多孔材料為基體，負載fe催化劑活性組分，通過cvd法催化裂解c2h2來生長碳納米管。
  4. At lower growth temperature, the lower extracting rate of carbon atoms from catalyst particles due to the lower activity of the catalysts resulted in more defects formed in carbon nanotubes. moreover, the lower transportation rate of carbon atoms in catalyst particles also made lots of carbon atoms deposited on the surfaces of grown carbon nanotubes, or on carbon wrapped catalyst particles, even to form amorphous carbon layers

    在較低溫度時，由於催化劑的活性較低，導致石墨面在生長過程中引入的缺陷較多；另一方面，碳原子在催化劑顆粒內遷移速率較低，使得多餘的游離態碳原子（或原子團）可能在納米碳管表面以非晶形式沉積，或者包覆催化劑使其「中毒」失去催化活性，或者直接形成非晶的碳納米顆粒。
分享友人
分享到 Line

分享到臉書