破壞特性 的英文怎麼說

中文拼音 [pòhuàitèxìng]
破壞特性 英文
destruction characteristic
  • 破 : Ⅰ動詞1 （完整的東西受到損傷） be broken; be damaged 2 （使損壞） break; break down; damage 3 （使...
  • 壞 : Ⅰ形容詞1 （不好的; 惡劣的; 使人不滿意的） bad 2 （表示程度深 多用在表示心理狀態的動詞或形容詞後面...
  • 特 : Ⅰ形容詞（特殊; 超出一般） particular; special; exceptional; unusual Ⅱ副詞1 （特別） especially; v...
  • 性 : Ⅰ名詞1 （性格） nature; character; disposition 2 （性能; 性質） property; quality 3 （性別） sex ...
  • 破壞 : 1 （使建築物等損壞） destroy; wreck; ruin 2 （使事物受到損害） do great damage to; do harm to; da...
  • 特性 : characteristic（s）; character; performance; features; properties; behaviour; response; character...
  1. It can be seen from the results that the control beam had good plastic property in the static failure experiment after two million fatigue loading circles. all specimens with corroded main bars were failure under the fatigue loads within one million fatigue circles. fatigue lifespan of reinforced concrete beam was sharply shortened after main bars corroded in it and the beam was destroyed bristly without any prediction

    試驗結果表明，振動測試不能夠對銹蝕鋼筋混凝土梁的疲勞破壞做出可靠的預測;對比梁在經過200萬次疲勞循環加載后的靜力試驗中仍表現出良好的延性破壞特徵;銹蝕梁在100萬次疲勞循環內均因主筋疲勞斷裂而破壞;主筋銹蝕使得梁的疲勞壽命急劇縮短;梁發生脆性破壞而沒有徵兆。
  2. Analyzing the failure characteristics of steel deck plate paving and the actual use of the testing section which uses epoxy asphalt at jiangyin yangtze river bridge, this paper decides to use epoxy asphalt concrete as the repairing material to prevent pavement from deteriorating

    摘要在分析江陰大橋鋼橋面鋪裝破壞特徵的基礎上，結合環氧瀝青混凝土試驗段的實際使用狀況，故決定採用環氧瀝青混凝土對鋪裝層進行預防性維修以避免其繼續惡化。
  3. Abstract : based on destructible feature of plastically drawing unsteadiness of pressure vessel, this paper calculated elastical / viscoplastical drawing unsteadiness of pressure vessel made of revolving shells

    文摘:依據壓力容器拉伸塑性失穩破壞特徵，計算了旋轉薄壁殼壓力容器在彈粘塑性材料下的塑性失穩破壞。
  4. According to experiments, the paper study and make an analysis of beams consolidated by carbon fiber about its damage character, genuflecting bend, limit payload and rigidity, etc

    摘要通過試驗，本文對用碳纖維加固的二次受力鋼?砼梁的破壞特性、屈服彎矩、極限承載力、剛度等進行了研究與分析。
  5. Investigation on failure of granitic residual slope by using centrifugal model test

    用離心模型試驗研究花崗巖殘積土邊坡的破壞特性
  6. According to in - situ construction real time observation and inverse analysis results, refinement numerical artificial analysis on a group of headrace tunnels was conducted and influence of different construction schemes and support parameters on rock mass deformation and failure behavior were researched to provide quantized data and technical aid for project construction decisions

    基於跟蹤施工的現場實時觀測和反演分析結果，對引水發電洞群進行了精細化數值模擬分析，研究了不同施工方案和支護參數對巖體變形、破壞特性的影響，以便為工程的施工決策提供量化資料和技術支持。
  7. In this thesis, four types of steel beam - rectangular cfst column connections, including normal welded flange plate ( wfp ) connection, bolted flange plate ( bfp ) connection, stiffened end plate ( sep ) connection and double split - tee plate ( dst ) connection, were designed based on the configuration of steel frame connection. total 8 models, 2 models of each kind of connections were tested under low - reversed cyclic loading at the end of cfst columns. the relationships between force and displacement at the end of columns, the relationships between the moment and rotation of the joints, degradations of strength and stiffness, ductility, failure mechanism and failure characteristics of these four connections under different axial - compression ratios were presented

    本文借鑒鋼框架節點構造，設計了四種類型矩形鋼管混凝土柱與鋼梁連接節點，包括常規栓焊（ wfp ）節點、翼緣全螺栓連接（ bfp ）節點、雙t板連接（ dst ）節點以及加勁端板連接（ sep ）節點，進行了四類節點8個模型試件在柱端低周反復荷載作用下的抗震性能試驗研究，比較了不同軸壓比下節點的滯回性能、強度與剛度退化、延性、破壞機理與破壞特徵，主要結論有： 1 、節點的位移滯回曲線與轉角滯回曲線為塊型分佈，沒有或略有捏攏現象，耗能能力強； 2 、軸壓比對節點滯回曲線有顯著影響，全部節點都有顯著的剛度退化； 3 、位移與轉角骨架曲線在峰值荷載後有較長的水平或下降段，具有良好的延性性能； 4 、從整體抗震性能上看，翼緣全螺栓連接節點、雙t板連接與加勁端板連接節點都優于常規栓焊節點，可在實際工程中加以推廣。
  8. Based upon the experimental study, the stiffness and its attenuation, bearing capacity, ductility, hysteretic property, energy dissipation and failure phenomena of each shear wall with different design parameters are contrastively analyzed and the seismic mechanism of this new shear wall has been opened out

    對各不同設計參數剪力墻的承載力、剛度及其衰減過程、延性、滯回特性、耗能能力和破壞特徵等進行了較系統的分析，揭示了其抗震機理。
  9. Based upon the experimental study, the stiffness and its attenuation, bearing capacity, ductility, hysteretic property energy dissipation and failure phenomena of each shear wall with different design parameters are contrastively analyzed and the seismic mechamism of this new shear wall has been opened out

    通過試驗，對各不同設計參數剪力墻的承載力、剛度及其衰減過程、延性、滯回特性、耗能能力和破壞特徵等進行了較系統的分析，揭示了其抗震機理。
  10. With the material dynamic constitutive equation including damage and the effect of stain rate the predictable formula about ballistic limit velocity of fiber composite target. secondly based on the damage feature about ceramic / fiber composite target caused by impact load, analysis model about defense performance of ceramic / composite material target is formed and the predictable formula about ballistic limit velocity is also given. lastly using the reflection and projectile theory of stress wave the paper discusses the design of ceramic / composite material target, optimizes the design of double layer ceramic / composite targets, gains optimal coefficient under certain area density and discusses the variety relationship of area density and thickness with optimal coefficient u nder some ballistic limit velocity 3

    首先，分析了纖維類正交鋪層復合靶板在沖擊載荷作用下的損傷破壞機理，結合包含損傷和應變率效應的材料動態本構方程，建立了纖維復合材料板彈道極限速度的預測公式；其次，根據陶瓷/纖維材料復合靶板在沖擊載荷下的破壞特點，建立了陶瓷/復合材料靶板抗彈性能分析模型，給出了彈道極限速度預測公式；最後，利用應力波反射和透射理論討論了陶瓷/復合材料靶板的設計問題，對雙層陶瓷復合靶板的優化設計進行了分析，給出了在一定面密度下的最佳優化系數，討論了一定彈道極限速度下的面密度和厚度隨優化系數的變化關系。
  11. The influences of different reinforcement style of the concealed bracings and different span - height ratio of lintel beams on bearing capacity, stiffness and deterioration process, ductility, hysteresity capacity, energy dissipation and failure features of coupled shear wall were studied through experiment of 7 specimens under low cyclic loading

    通過7個結構試件在低周反復荷載作用下的試驗，研究了不同暗支撐配筋形式、不同連梁跨高比對雙肢剪力墻的承載力、剛度及其衰減過程、延性、滯回特性、耗能、破壞特徵等方面的影響。
  12. Based on thermodynamics laws, inner - variable theory and analysis of conventional tn - axial tests data and breakage characteristics of loess, this paper proposed that the loess would produce elastic, plastic and nonreversible damage deformation during loading

    從熱力學定律和內變量理論出發，在對常規三軸試驗數據和土樣的破壞特性分析的基礎上，認為土體在受力過程中將產生彈性變形、塑性變形和不可逆損傷變形。
  13. Elementary analysis on breaking feature of overburden rock during mining under special nappe structure

    特殊推覆體下開采覆巖破壞特性淺析
  14. Research on deformation and subsidence characters of ground and surrounding rock induced by underground mining under thick covering terrain by model test

    厚覆蓋巖層條件下地下采礦的地表及圍巖變形破壞特性模型試驗研究
  15. The results of simulating have shown that it is better on simulating the failure features of reinforced concrete structures and components by extended discrete element method

    算例與分析結果表明：採用改進后的離散單元法可以較好地模擬鋼筋混凝土結構和構件的破壞特性。
  16. On the basis of analyzing strength and layer - crack damage characteristics of thin - layered qinyun - stone ore, the separate blasting and cutting blasting tests are carried out on it

    在分析薄層狀青雲石礦強度特徵和層裂破壞特性的基礎上，對其進行了分離爆破和分割爆破試驗。
  17. However, as a newly introduced technology, the theory of this type of piles has not been fully developed. many of its important characteristics, such as the stress and strain characteristics, have not been determined, as well as the optimal distances between plates and piles

    但是它作為一種新的技術在理論研究上尚不夠成熟，對其受力特徵、沉降特性、破壞特性以及最佳盤間距、樁間距等還不能完全確定。
  18. A number of tests are carried out on different stiffened shells. the buckling behavior of the shells are illustrated with analysis. comparisons between the experiment results and numerical results are made, which validate the theoretical analysis presented in this dissertation

    最後，還針對多個試驗件進行了試驗分析及計算結果對比，描述了試件的破壞特性和破壞過程，其結果進一步證實了所建立的力學模型和理論分析方法的正確性和實用性。
  19. This paper introduces kinds, advantages and shortcomings, designing principles, and its failure properties of adhesive bonded joints and mechanical fastened joints of frp pipe. carry technique research of the frp pipe and steel pipe or steel spare parts. pass the analysis to various adhesive - bonded joint, aim at the actual application of adhesive - bonded joint within frp pipe and steel pipe or spare parts choice strengthen adhesive - bonded joint inside and outside to apply

    本文介紹了玻璃鋼管道膠接連接和機械連接的種類、優缺點、設計原則及其連接的破壞特性，進行了玻璃鋼管本體、玻璃鋼管法蘭、玻璃鋼管與玻璃鋼管法蘭連接處的強度測試試驗，並進行了試驗結果分析，提出進行玻璃鋼管與鋼管及鋼管件膠接技術研究的必要性。
  20. At the moment, the basic theory of loading mechanics is always used to search the problem of rock mass failure, but unloading and loading have different stress road and different destruction effect, so there are much difference in destruction mechanics and deformation between unloading and loading mechanics, if loading mechanics is used to study the destruction property of tunnel excavation and its stability, the result which agree to real engineering cannot be obtained

    目前一直沿用加載巖體力學方面的基本理論研究失穩問題，但本文認為：由於卸荷與連續加載具有完全不同的應力路徑和破壞效應，在破壞機理、二者引起的巖體的變形和破壞特性方面都有很大的不同，因此用加載力學來研究開挖卸荷破壞的力學特性及其穩定性，這顯然不能得出與實際工程一致的結果。
分享友人
分享到 Line

分享到臉書