碎裂斷層帶 的英文怎麼說

中文拼音 [suìlièduàncéngdài]
碎裂斷層帶 英文
shattered fault zone
  • : 動詞[書面語] (觸; 撞) strike; bump
  • : 裂動詞[方言] (東西的兩部分向兩旁分開) open
  • : Ⅰ動詞1 (分成段) break; snap 2 (斷絕;隔斷) break off; cut off; stop 3 (戒除) give up; abstai...
  • : i 量詞1 (用於重疊、積累的東西 如樓層、階層、地層) storey; tier; stratum 2 (用於可以分項分步的...
  • 碎裂 : splintering; fragmentation
  • 斷層 : fault; slip; slicle; fracture; dislocation
  1. The fault controlled the magmatism and metallization relevant to the contact zone, and deformed successively and produced cataclastic rocks and two sets of joints ; the second stage was from late cretaceous to eocene. the fault zone deformed right - laterally under ne - sw striking transtention, and new joints zone was produced at the end of the two main faults because of local stress concentration. the fault produced inchoative cataclastic rocks, and two sets of typical joints in plutons ; the third stage of deformation was relatively faint and only a little of microcracks was produced and infilled with vei ns in the deformed rocks, which was during the himalayan movement

    其後的繼承性活動在內形成程度最強達到巖的巖系列構造巖,變形兩側發育兩組典型的共軛剪節理;第二次在晚白堊世?始新世,在北東?南西向近水平擠壓作用下右行張扭性活動,兩主在斜列重疊的端部由於局部應力集中進一步擴展形成節理,而在巖體區也發育兩組典型的共軛剪節理,內形成初巖為主的構造巖;第三次是喜山期以西側抬升、東側下降的強烈升降為主的活動,在基巖中,主兩側圍巖出現微破
  2. The author suggests that the three lithosphere - scale faults, lancangjiang fault, jinshanjiang - ailaoshan fault and axis fault in the middle of the basin, are the main geological structures that control the formation of basin, magmatism and metallogenic congregate district. the anticline structure with an axis of triassic strata and the related fault system within the basin, and gonglang arch - shaped folding structure in the south of the basin are the geological structure controlling the formation of ore fields. junctions of two or more faults with different orientation, interlayer cataclastic structural zone and oxidation - reduction ( redox ) boundary were the favorable position for the formation of ore bodies

    認為瀾滄江、金沙江-哀牢山及盆地中軸這三條巖石圈是主要的控盆-控巖(巖漿巖)構造及礦集區尺度的控礦構造;盆地中以三疊系為軸的背斜構造及相關的系統、盆地西南緣公郎弧形構造等是礦田尺度的控礦構造;多組的交叉、間破及地柱中的氧化還原界面是形成礦體的有利部位。
  3. The reservoirs, which are more fractured and cataclasm, are mainly distributed in fracture belt or near it. that is, the distribution of metamorphite reservoirs is influenced by the structural fracture belts

    縫發育?化強烈的儲集巖主要分佈在及其附近,即構造控制著變質巖儲的形成發育和分佈。
  4. Alkali basite, which came from upper mantle or lower crust, invaded through those structure, which not only bring cu et al mineralizing elements, but also the most important is that thermal energy. it cycled the formation water ( yinmin fonnation and luoxue formation ), and form alkali - rich, middle - high temperature and salinity fluid mixed with alkali - rich magmatic water. there were high rate of percolation and well voidage in the contact zone between yinmin purple stratum and yinmin rubblerocks, which is in favor of the transposition and mineralization of minerogenetic fluids

    因此,總結東川稀礦山式銅礦成礦模式為沉積( fe 、 cu ) ?熱液疊加( cu )改造:晉寧-澄江期,小江深大發生走滑運動,在東川礦區造成右行旋扭及其派生構造,形成「 z 」字形落因破,同時來自深源(下地殼或上地幔)堿基性巖漿侵入,不僅來了大量cu等成礦物質,更重要的是提供了熱源,促使地水(落雪組白雲巖和因民組紫色)循環,與富堿( na和k )巖漿水混合,形成富堿中高溫高鹽度流體。
  5. Seismic survey is a new method used to civil engineering area in recent years. it was widely applied to survey or detecting of roadbase, dam base, foundation of building, tunnel, river bed, lake bed and etc. the chief methods are reflection method, refraction method, wave velocity testing, surface ware survey and transverse wave suivey. seismic survey can divide different layer, measure the incidence of sediment stratum, detect the structure of rock, test the handle effect of surface wave survey, we can calculate the carrying capacity of foundation and other mechanical parameters. this technique can give service to some big engineering departments such as highway developing company, survey design company, water supply company, plan bureau, construct bureau etc

    應用於工程的主要方法有反射波法折射波法波速測井面波法及橫波勘探等。地震勘探能詳細劃分地高精度地確定沉積地的傾角能夠準確探明巖體構造褶皺對于回填工程路基壩基,地震勘探可以檢測其回填處理效果對于隧道工程,可以探測隧道洞體的圍巖分類及洞口地質情況利用面波勘探所得到的瑞利波速度,可以準確推算地基的承載力動彈模量等力學參數。
  6. Fault fracture zones often form in active fault zones and appear as long extension with stable trending, they are jointly controlled by active faulting, underground water concentration and freezing expansion

    縫沿定向分佈,產狀穩定,成群產出,與活動、地下水運移、不均勻凍脹存在密切的關系,是構造變形與融凍變形聯合、內外動力耦合產生的復合成因地縫。
  7. In underground engineering, the cavity axis should be designed to intersect fractures with large - angle ( 90 ) as it traverses fault and joints

    摘要在地下工程中,當洞室穿越、節理等破時,應盡可能使洞軸線走向與破面的走向呈大角度相交( 90 ) 。
分享友人