磁盤緩沖 的英文怎麼說

中文拼音 [cípánhuǎnchōng]
磁盤緩沖 英文
vcache
  • 磁 : 名詞1. [物理學] （磁性; 能吸引鐵、鎳等的性質） magnetism 2. （瓷） porcelain; china
  • 盤 : Ⅰ名詞1 （盤子） tray; plate; dish 2 （形狀或功用像盤的東西） sth shaped like or used as a tray pl...
  • 緩 : Ⅰ形容詞1 （遲; 慢） slow; unhurried 2 （緩和; 不緊張） not tense; relaxed Ⅱ動詞1 （延緩; 推遲） d...
  • 磁盤 : （magnetic） disc [disk]磁盤編輯 disk edit; 磁盤操作系統 disk operating system; 磁盤磁軌 disk tra...
  1. To use an intermediate storage ( magnetic disc ) when making a data transfer between highspeed storage ( usually main storage ) and a device that operates at a lower speed

    當高速存儲器（通常是內存）和低速運行的（外部）設備之間進行數據傳送時，利用中間存儲器（磁盤）作緩沖（的技術或過程） 。
  2. Increasing buffer size is expensive, as it comes from non paged memory that cannot be swapped out to disk, so keep the buffer as small as possible

    增加緩沖區大小的開銷較大，因為它來自無法換出到磁盤的非分頁內存，所以將緩沖區保持得越小越好。
  3. Increasing the size of the buffer is expensive, as it comes from non paged memory that cannot be swapped out to disk, so keep the buffer as small as possible

    增加緩沖區大小的開銷較大，因為它來自無法換出到磁盤的非分頁內存，所以將緩沖區保持得越小越好。
  4. Function to close all open files and write the contents of all file buffers to disk

    函數關閉所有打開的文件，並將所有文件緩沖區的內容寫入磁盤。
  5. Db2 bufferpools and the linux file cache perform largely the same function ; that is, cache a copy of data read from disk

    Db2緩沖池與linux文件緩存基本上執行相同的功能，也就是緩存從磁盤讀出的數據的拷貝。
  6. Db2 page cleaners essentially have the responsibility of removing dirty or unneeded data from the bufferpools to disk

    Db2頁面清理器實際上要負責將臟數據或不需要的數據從緩沖池轉移到磁盤。
  7. If your application uses a disk cache, it also registers with the disk cleanup utility

    如果你的應用程序使用一個磁盤緩沖，它要被磁盤清理應用所記錄。
  8. In practice, buffering may occur at various other levels, such as on the hard disk itself, the controller, or the kernel disk drive device driver, so ours may not make much of a difference

    實際上，緩沖可能發生在其它不同的級別，例如硬盤本身、控制器或內核磁盤驅動設備驅動程序，所以我們的工作可能對性能影響不大。
  9. Linux, under normal circumstances, uses a system file cache to buffer, read, and write requests from disk

    在一般情況下， linux使用一個文件系統緩存為磁盤請求進行緩沖和讀寫。
  10. Well, here s how : since we are using the stdio library, the lower level routines in the library read data from the disk a chunk at a time - where the size of the chunk corresponds to the buffer size we ve specified - and put it into our buffer inbuf

    的調用是如何起作用的。好吧，下面就此進行介紹：因為我們在使用stdio庫，庫中更低級別的程序從磁盤一次一塊地讀取數據這里塊的大小對應於我們已經指定的緩沖區大小並將它置入我們的緩沖區inbuf 。
  11. This post facto synchronization allows the program to determine the seed being used by the random number generator, and to identify the shuffle being used during all future games in under one second

    通常，如果攻擊者利用了您代碼中的緩沖區溢出，那人就可以對磁盤進行原始寫並胡亂修改內核所在內存中的任何數據。
  12. The bufferpool improves database performance by allowing data to be accessed from memory instead of from disk

    緩沖池通過允許從內存而非磁盤訪問數據來提高數據庫的性能。
分享友人
分享到 Line

分享到臉書