磁通密度 的英文怎麼說

中文拼音 [cítōngmìdù]
磁通密度 英文
density of magnetic flux
  • 磁 : 名詞1. [物理學] （磁性; 能吸引鐵、鎳等的性質） magnetism 2. （瓷） porcelain; china
  • 通 : 通量詞（用於動作）
  • 密 : Ⅰ名詞1 （秘密） secret 2 [紡織] （密度） density 3 （姓氏） a surname Ⅱ形容詞1 （距離近; 空隙小）...
  • 度 : 度動詞[書面語] （推測; 估計） surmise; estimate
  1. Surface magnetic flux density

    表面磁通密度mt
  2. Residual magnetic flux density

    殘余磁通密度
  3. Remanence flux density

    剩餘磁通密度br
  4. From the model, we can solve and gain the values and change orders of charging current, charging voltage, discharging current, discharging voltage and inductive current. after that, the electromagnetic fields can be created from two circuits " currents, and their magnetic rector and flux can be simulated from ansys solver

    用ansys multiphysics模塊求解出充電電流、充電電壓、放電電流、放電電壓和感應電流以及這些參數隨時間變化的規律：然後利用兩個迴路的電流耦合出電磁場，並模擬出磁矢量、磁通密度。
  5. Analysis for magnetic field of srm is very complicated since the flux waveforms in different parts of the motor vary with motor phase, stator pole and rotor number, also with the winding connections, etc, which results in the srm losses, especially iron loss calculation difficult. the temperature analysis due to the losses has become a study hot spot

    Sr電機鐵心的磁通波形不僅與電機的相數有關，還與定、轉子齒極數、定子繞組連接方式等密切相關，從而使得sr電機磁場分析很復雜，復雜的磁通密度波形導致電機損耗特別是鐵損的計算非常困難。電機的損耗又會引起電機的溫升，因此高性能的sr電機的熱分析也成為目前的研究熱點。
  6. And the subroutine is developed to add the periodic condition in the commercial 3d fem software. 3d electromagnetic field analysis is done to analyze the magnetic flux distribution in the tfpm. base on the field analysis, the mathematical model is given

    採用簡化的三維電磁場計算方法對橫向磁通永磁電機內部磁通分佈進行了研究，計算了各部分的磁通密度分佈和漏磁通的走向，得到了電機的空載漏磁系數及空載反電動勢以及主要的漏磁通分量。
  7. Bssaturation magnetic fluxdensity @ h 1194a m

    飽和磁通密度
  8. Saturation magnetic fluxdensity @ h 1194a m

    飽和磁通密度b
  9. Specification - cores made of ferromagnetic oxides for use in high flux density transformers

    高磁通密度變壓器用鐵氧體鐵芯規范
  10. Recommended practice for instrumentation for magnetic flux density and electric field strength meters - 10hz to 3khz

    10hz - 3khz磁通密度檢測儀表和電場強度計的推薦實施規程
  11. Firstly, srm magnetic field analysis is performed to get the flux density waveforms in motor core

    本文首先對sr電機的磁場進行了有限元分析，得到了電機鐵心各點的磁通密度波形及變化規律。
  12. Based on the analysis of the magnetic circuit, the computation expressions of the magnetic force, magnetic flux density and inductance are derived

    在磁路分析的基礎上，推導了磁力、磁通密度和電感的計算公式。
  13. By magnetic field analysis for the stage, three formulas reached : one is magnetic road magnetic force calculational formula of magnetic levitation system that except flux leakage, the second is magnetic driving force calculational formula for open magnetic road dc linear motor, the third is magnetic flux density calculational formula for dc linear motor. these formulas make reference for design, analysis and control

    本文對磁懸浮定位平臺進行了電磁場分析，推導出磁懸浮系統不計漏磁的簡單磁路、磁力計算公式和原理樣機所採用的開磁路直流直線電機推力及磁通密度計算公式，為設計、分析及控制提供參考。
  14. The hybrid claw - pole alternators have magnetic fields contributed by permanent magnet as well as excitation coil, and the advantages are high efficiency, have good low - speed characteristics, excitation adjustable and high flux densities. for the reason of complex claw - pole construction and 3 - d magnetic field distributions, there is lack of the research on the alternators

    混合勵磁爪極發電機是由永磁體和勵磁線圈共同產生電機磁場的一種發電機，與傳統的爪極發電機相比有高效、低速性能好和集線圈勵磁的電壓調節性能與高磁通密度的優點，具有很好的研究前景和使用價值。
  15. The emcn model is set up by use of flux - tube method. in this method, the segment in which the flux density is relatively even is considered to be an element, the permeance of each element can be calculated by use of conventional method. finally the permeance network can be set up by connecting each node with permeances, then the parameters and performance can be obtained

    其基本思想是通過磁通管原理，把電機內部磁通密度相對均勻的部分看作一個單元，計算出單元的磁導，最後再把各個節點用等效磁導連接起來構成一個磁導的網路圖，再根據電路的基本解法求得各個節點的磁位，從而求得電機的參數和性能。
  16. Firstly, the dissertation has analyzed the relationship between electromagnetic force and air gap, and obtained fitting formula of force and flux density using computed results

    本文首先分析了電磁力與懸浮氣隙磁場之間的關系，並利用計算結果得出了懸浮力與氣隙磁通密度的擬合公式。
  17. Our factory ' s soft ferrite made from good - quality iron oxide has merits of high permeability, high saturation magnetic flux density and low loss, and id widely used in electric and electronic sets of various kinds

    利用本公司優質氧化鐵生產的軟磁鐵氧體，具有高磁導率，高飽和磁通密度和低損耗的優點，它廣泛的用於各類電子電器整機中。
  18. In order to realize flux feedback control, the request of air gap flux density measurement is studied. using the 3d magnetic field analysis software, how and where to install the magnetic field sensors have been discussed. then two magnetic fields measuring methods have been chosen : the hall effects measurement and the electromagnetic induction method

    為實現磁通反饋控制，分析了懸浮磁場對磁通密度測量的要求，利用三維磁場分析軟體對磁場測量元件的安裝方式與安裝位置進行了分析，選擇了兩種磁場測量方法:霍爾效應法與電磁感應法，並分別設計了測量及信號放大、濾波電路，實現了懸浮磁場的測量。
  19. In single magnet modeling, from the air gap magnetic - flux density, single magnet linear model which take the flux density as the state variable is obtained, and used the fitting formula which the magnetic field analysis had obtained to revise the model parameters

    在對單鐵的建模中，從氣隙磁通密度的角度出發，得到了以磁通密度為狀態變量的單鐵線性模型，並採用磁場分析得出的擬合公式修正了模型參數。
  20. It mainly calculates intensity of magnetic flux in every part of motor magnetic circuit in order to prevent the fact the intensity is so high that the magnet core saturates

    改繞計算主要是計算電動機磁路各部分磁通密度數值，不使其過大而致鐵心嚴重飽和。
分享友人
分享到 Line

分享到臉書