磨擦層 的英文怎麼說

中文拼音 [mócācéng]
磨擦層 英文
friction layer
  • 磨 : 磨動詞1 （摩擦） rub; wear 2 （研磨） grind; mull; polish 3 （折磨） grind down; wear down [out]:...
  • 擦 : 動詞1 （摩擦） rub 2 （用布、 手巾等摩擦使干凈; 揩拭; 抹） wipe; scrub; clean 3 （塗抹; 搽） spre...
  • 層 : i 量詞1 （用於重疊、積累的東西 如樓層、階層、地層） storey; tier; stratum 2 （用於可以分項分步的...
  • 磨擦 : rub; abrade; abrase磨擦電 triboelectricity; 磨擦工 rubber; 磨擦劑 abrasive; 磨擦器 grater; rubber...
  1. The result of those studies as follow : ( 1 ) an composite layer of definite thickness on the casting was gained by cast - sintering technique, and it has well wear - resistance. ( 2 ) the reinforcement of the composite layer is tic or vc, which was exiguous and is well distributed

    同時利用干滑動摩擦磨損實驗，對表面復合層的耐干滑動摩擦磨損的性能進行了研究。研究表明： （ 1 ）利用鑄造燒結技術可以在鑄件表面獲得一定厚度耐磨性能良好的表面復合層。
  2. Wear resistance of q235 steel surface mo - cr alloy layer by double glow discharge technology

    235鋼表面雙層輝光離子強化層摩擦磨損性能
  3. Test method for coefficient of static friction of uncoated writing and printing paper by use of the inclined plane method

    用傾斜面法測試無塗層書寫紙和印刷紙靜磨擦系數的試驗方法
  4. Standard test method for coefficient of static and kinetic friction of uncoated writing and printing paper by use of the horizontal plane method

    用水平面法測試無塗層書寫紙和印刷紙的靜磨擦和動磨擦系數的標準試驗方法
  5. Moving swiftly through the atmosphere, meteoroids are heated rapidly by friction.

    流星體在快速穿過大氣層時，因磨擦而迅速加熱。
  6. Gas permeability tester and mechanical folding device were developed to study the barrier property and deformation failure behaviors. the surface characterization, chemical structure, optical, mechanical properties of pet coated with dlc have been investigated by x - ray photoelectron spectroscopy ( xps ), contact angle measurement, light transmission analysis, nanoindentation and friction wear tests

    通過x射線光電子譜分析、接觸角測定、光學透過率分析、納米壓痕、摩擦磨損試驗、機械彎折試驗、氣體透過率試驗，對膜層的表面特徵，光學、力學及氣體阻隔性能進行了系統的研究。
  7. The results indicated that the dimension, shape and purity of base material could meet the functional demand of solid lubricant ; the thermal decomposition temperature of ptfe resin exceeds 400 c, but organic and inorganic packing filler added in ptfe made the water absorption rate of composite material increased, melting temperature and decomposition temperature decreased, in the meanwhile oxidative decomposition reaction was accompanied ; polar groups such as c = o, c - o - c and so on in the carbon fiber surface is advantageous to increase compatibility with other components and interlayer shearing strength ; uniform design experimental method could help to find the relationship between formula and frictional property by relatively small tests. the developing trend of each formula ' s friction coefficient could be showed by fitting curve ; the friction coefficient with no copper powder or graphite in formula was relatively big. this fact showed that copper powder and graphite should be used cooperatively ; it was found that when the ratio of copper powder to graphite by weight is 15 : 60, 30 : 30 - 40 and 60 : 15 - 30 respectively, the friction coefficient was relatively small. the degree of crystallinity of pure ptfe reached maximum by air cooling and the abrasion loss also reached maximum among three ones ; at the same time, the abrasion loss of solid lubricant sample was also the biggest among three ones ; when solid lubricant matched with 45 # steel axle or gcrl5 steel axle, lubricant transfer film could be formed on metal surface, thus direct contact between the surface of metal friction pair rings was reduced. their working life was elongated extremely ; there was mainly much graphite, a little ptff, moo3, feso4, cus and so on in lubricant transfer film

    試驗結果表明：所選原料的尺寸、形狀及純度可滿足固體潤滑劑的性能要求；聚四氟乙烯樹脂熱分解溫度超過400 ，但在ptfe中加入無機填料會使復合材料吸水率提高，熔融溫度及分解溫度降低，且伴有氧化分解反應；碳纖維表面含有c = o及c - o - c等極性基團，有利於提高其與其它組分的相容性，提高層間剪切強度；均勻設計試驗方法能夠用較少的試驗次數找出配方與摩擦性能間的關系，擬合曲線基本能表示各配方的摩擦系數發展趨勢；配方中不加銅粉或不加石墨，其摩擦系數均較高，說明銅粉和石墨應該配合使用；當銅粉15份、石墨60份時，銅粉30份、石墨30 - 40份時，銅粉60 、石墨15 - 30份時，摩擦系數均具有較低值；純聚四氟乙烯樹脂在空氣冷卻時結晶度最大，磨損量也是三者中最大的；同時，固體潤滑劑試樣在空氣冷卻時的磨損量也是三者中最大的：不論是固體潤滑劑與45 #鋼軸配副或是固體潤滑劑鑲嵌入銅套后與gcr15鋼軸配副，在金屬表面均可形成潤滑轉移膜，從而減少金屬摩擦副表面間的直接接觸，大大延長其使用壽命;轉移膜中主要含有較多的石墨、少量聚四氟乙烯、 moo 。
  8. It has been discovered that ( 1 ) in the region between 100 - 350 the friction coefficient is lowering along with the swing of temperature ; ( 2 ) the friction coefficient is the highest at the temperature of 500, and adhesive wear occurred ; ( 3 ) the global graphite grain layer appeared at the surface of wear scar at 450n and 300, and played an extremely good effect of lubrication, thus makes a fairly lower wear at the temperature of 300

    發現： （ 1 ）在100 ~ 350區間，隨溫度的升高，摩擦因數在降低； （ 2 ）在500時，摩擦因數最高，且發生了粘著磨損； （ 3 ）在450n ， 300時，磨痕表面出現了球狀的石墨顆拉層，這起到了極好的潤滑作用，使得300時，磨損較低。
  9. Standard test method for coefficient of static friction of uncoated writing and printing paper by use of the inclined plane method

    用傾斜面法測試無塗層書寫紙和印刷紙靜磨擦系數的標準試驗方法
  10. Standard test method for determining the abrasion resistance of inks and coatings on membrane switches using the norman tool " rca " abrader

    使用norman工具" rca "磨擦器測定薄膜開關上墨水和塗層抗磨性的標準試驗方法
  11. ( 2 ) it is found that distilled water as lubricant can markedly reduce the accumulation of friction heat and temperature rise on the frictional surfaces of polymer. so the heat fatigue and adhesive wear decrease. moreover, a lubricating film forms on the interface between the counterpart and polymer when distilled water acts as polar lubricant

    （ 2 ）潤滑劑水的存在，可大幅度降低聚合物磨損表面的摩擦熱積累及溫升，從而減少了基體的熱疲勞磨損和粘著磨損，同時，水作為一種極性潤滑劑，在摩擦界面上能形成一層潤滑膜，對摩擦表面起了一定的隔離作用。
  12. The wear - resistance of the rps tin coating is significantly higher than that of the quenched m2 high - speed steel. the wear resistance of the quenched m2 high - speed steel was improved about 2. 5 times by the rps tin coating under high load. the antifriction performance of the tin coating is also very excellent due to the self - lubricating effect of tin, the friction efficient of which is about 5. 3 % that of the quenched m2 steel

    在無潤滑條件下，反應等離子噴塗tin塗層的耐磨性明顯高於淬火m2鋼，在高載荷下，其耐磨性是m2鋼的2 . 5倍；同時，由於tin的自潤滑效應，塗層的減摩性遠遠優于m2鋼，高載荷下摩擦系數僅是m2鋼的5 . 3 。
  13. Standard test method for granule adhesion to mineral surfaced roofing by abrasion

    用磨擦法測試礦物塗覆屋頂層顆粒粘結性的標準試驗方法
  14. Turning the grinding machine round, driven the barrel body to rotate by the transmission, the work piece that makes in the barrel, grinding stones and adding and grinding pharmaceutical and water in right amount, mix in barrel, is it is it flow layer to produce through action of gravity to make use of, flow friction on layer grind cutting, reach the work piece and process the surface quality taken

    ?轉研磨機，是由傳動帶動桶身旋轉，使桶內的工件、研磨石與添加適量研磨劑和水，在桶內混合，藉由重力作用而產生流動層，進而流動層的磨擦進行研磨切削，達到工件加工所要的表面品質。
  15. The papers also brings forward the design parameters of the material critical suspending speed and the wind capacity according the theory of the air transportation, analyses and build up the condition of material diameter and airflow speed of the gas - solid current locating the separating interface

    論文根據氣力輸送理論求出螺旋氣力吸取料裝置物料的懸浮速度及風機風量的設計參數，分析確定位於分離界面處的氣固二相流處于層流狀態即處于粘性磨擦阻力區的粒徑條件與氣流速度條件。
  16. Extremultus high - efficiency flat belts of the p line are available with friction coatings coverings of highly wear - resistant elastomer g or chrome - tanned leather on one or both sides

    P系列的易傳動高效能平皮帶的磨擦塗層單面或雙面由高耐磨彈性橡膠或由鉻鞣製的皮革構成。
  17. Tribological properties and mechanism of fe - cr - ni coating

    耐磨塗層的摩擦性能及作用機理
  18. In diplomatic friction, a national leader to another national some negative appraisals so long as does not enter the policy - making stratification plane, the practice stratification plane, becomes the national policy, carries out, cannot vacillate two national the normal relations

    外交上的磨擦，一個國家領導人對另一個國家的一些消極評價只要不進入決策層面、實踐層面，成為國策，推行開來，就不會動搖兩個國家的正常關系。
  19. Use of the protective layer of water, the dolphins swimming almost no friction or create a vortex

    藉助這個水的保護層，海豚游動時幾乎沒有磨擦力，也不造成漩渦。
  20. Smtc versatile friction testing machine is designed and developed by this company, which is mainly used for the surface abrasice - resisting and solvent resisting testing of the paint membrane, printing ink, dying printing and plating coationg of the product made of rubber, plastics and metal, bear the melting agent test. etxc

    Smtc多用磨擦測試機是本公司研發的產品表面耐磨檢測儀器，主用於矽膠、橡膠、塑膠、金屬等產品的表面漆膜、油墨、染色印刷、電鍍塗層等表面耐磨，耐溶劑測試。
分享友人
分享到 Line

分享到臉書