稜角顆粒 的英文怎麼說
中文拼音 [léngjiǎokēlì]
稜角顆粒
英文
angular grain-
Fill the new shipping container with at least three - inches ( 7. 62 cm ) of foam - in - place, foam corner or edge pads, inflatable packaging, loosefill peanuts or other suitable dunnage materials
在新運輸包裝箱中填充至少三英寸( 7 . 62厘米)厚的現場發泡、泡沫稜角或邊緣襯墊材料、充氣式包裝、疏鬆填充顆粒或其它適用的襯墊材料。The tem micrographs of composite powders indicated that the size of particles after electroless plating increased from 10 ~ 20nm to 50 ~ 60nm and the originally granular form changed into spheral - like shape
透射電鏡觀察表明,粉體顆粒鍍覆后粒徑由10 20nm增加到50 60nm ,顆粒外觀由稜角狀變成近似球形,鍍覆均勻性較好。Fill the bottom of the new shipping container with at least three - inches ( 7. 62 cm ) of foam - in - place, polyethylene corner or edge pads, inflatable packaging, loosefill peanuts or other suitable dunnage material
在新運輸容器的底部填充至少三英寸( 7 . 62厘米)厚的現場發泡、聚乙烯稜角或邊沿襯墊材料、充氣式包裝、疏鬆填充顆粒或其它適用的襯墊材料。This article mainly emphasize on the classification of coarse grained soil from the viewpoint of engineering application ( content of coarse grains ), vibrating method is introduced in the shaping. meanwhile, research is made to the water stability and shear strength. through research, following conclusions are obtained : coarse grained gradation is the main factors to determine its shear strength, when the coarse grains content is over 70 % or around, the maximum shear strength appears : the grains itself have a bigger effect on the shear strength
以往對粗粒土的研究方法多採用擊實法,很少有人研究其抗剪強度特性,本文主要從工程應用的角度(粗粒含量)對粗粒土進行工程分類,成型方法採用振動法,同時對水穩定性、抗剪強度特性進行研究,通過研究得出以下結論:顆粒組成級配特性是決定其抗剪強度的主要因素,當粗粒含量在70左右時,抗剪強度最大;顆粒本身的特性對抗剪強度影響較大,顆粒越堅硬、大小顆粒相差越大、越不均勻、顆粒形狀越呈稜角狀、填築密度越大,抗剪強度就越高;含水量對抗剪強度的影響很小,可以忽略不計。分享友人