穩定試驗 的英文怎麼說

中文拼音 [wěndìngshìyàn]
穩定試驗 英文
stability test
  • 穩 : 形容詞1 （穩定; 穩當） steady; stable; firm 2 （穩重） steady; staid; sedate 3 （穩妥） sure; rel...
  • 定 : Ⅰ形容詞1 （平靜; 穩定） calm; stable 2 （已經確定的; 不改變的） fixed; settled; established Ⅱ動詞...
  • 試 : 名詞（古代占卜用的器具） astrolabe
  • 驗 : 動詞1. （察看; 查考） examine; check; test 2. （產生預期的效果） prove effective; produce the expected result
  • 穩定 : 1 （使穩定） stabilize; steady 2 （穩固安定） stable; steady 3 （物質的性能不易改變的作用） stabi...
  • 試驗 : trial; experiment; test
  1. Docking mechanism test - bed is mainly used to simulate dynamics process of two aerocraft ’ s docking on the ground, validate rationality of the mechanism ’ s design and estimate stability of the docking process

    對接機構綜合試驗臺主要用於地面模擬空間兩飛行器對接的動力學過程，對機構設計的合理性、對接過程中的穩定性進行驗證和評估。
  2. Long term immersing marshall test and frozen - thaw cycle test were used to investigate the anti - stripping performance of andesite asphalt mixture using cement and anti - stripping agent

    摘要採取長時間浸水馬歇爾試驗和多循環凍融劈裂試驗方法，對摻加了水泥、抗剝落劑的安山巖集料瀝青混凝土水穩定性能進行研究。
  3. Test method for thermal stability testing of gallium arsenide wafers

    砷化鎵晶片熱穩定性的試驗方法
  4. In view of bearing capacity of the elastoplastic theory analysis, the author made a comparison between the achieved bearing capacity limit load pi / 4 of round base ( space problem ) and the limit load pi / 4 of bar groundwork foundation design ( plane problem ) from soil mechanics at home and abroad as well as foundation criterion, and explained why the value of formula in present design criterion from soil mechanics is inclined to be conservative. in the light of the author ' s many years experience of vibration test on the spot and the research work of relevant projects, the author worked over the dynamic pile testing of the bearing capacity of foundation and batholith, and gathered the parameter of dynamic analysis and testing. the author also talked over the difficult point of pile foundation design criteria in present batholith engineering world, i. e. the confirmation of batholith bearing capacity of pile end, from the following aspects : a ) confirmation of single axis counter - pressure strength of rock in house ; b ) f. e. m calculation of elastoplastic model ; c ) calculation of soil mechanics ; d ) deep well load test

    然後，對巖土工程領域至今尚未解決，甚至不為人注意的考慮地基變形的地基承載力問題進行了實用化的探討，提出了考慮地基變形的地基承載力上程計算方法；對基於彈塑性理論分析的地基承載力國內尚未見報道的空間問題得到了圓形基礎（空間問題）的承載力界限荷載p _ （ 1 / 4 ） ，並與國內外土力學專著及地基基礎設計規范中的條形基礎（平面問題）的界限荷載p _ （ 1 / 4 ） ，進行了對比，從而定量上解釋了目前設計規范引用土力學承載力公式值偏於保守的這一情況；根據本文作者多年從事現場地基工程振動試驗及相關課題的研究工作，本文以截頭錐模型模擬地基，對地基（巖基）承載力的動測法進行了研究，為各類地基（包括巖基） ，匯總了動力分析和檢測川的參數：針對日前巖土工程界應用樁基設計規范中的難點? ?樁端巖基承載力的確定問題，從巖石室內單軸抗壓強度確定、基於彈塑性模型的有限單元法計算、土力學計算及深斤載荷試驗四方面進行了深入討論；本文作者根據多年現場載荷試驗的工程實踐，對深井荷試驗裝置的核心部分? ?反力裝置，設計了側壁支撐反力加載系統，該加載系統具有實用、簡便、穩定及安個等優點。
  5. Inspection methods for basic parameters of environmental testing equipments for electric and electronic products centrifugal machines for constant acceleration test

    電工電子產品環境試驗設備基本參數檢定方法穩態加速度試驗用離心機
  6. The results of the experiment show that the synthesized index, unsteady index and steady index inflect the stability margin of the compressor well. and show that the insert - board experiment can get the enough weight in the synthesized index. and also show that the low - press - area of the steady total - press moves along the rotor circumvolving direction

    試驗結果表明，綜合畸變指數，動態畸變指數，穩態畸變指數對壓氣機穩定性有很大作用;同時試驗還表明，插板能夠產生較大的動態畸變指數分量;穩態壓力圖譜低壓區隨著轉子轉動方向轉動;以及其他一些有益的結果。
  7. Photography - processed photographic colour films and paper prints - methods for measuring image stability

    照相已加工照相彩色膠片和相紙照片影像穩定性試驗方法
  8. Methods of testing plastics - thermal properties - determination of the thermal stability of polyvinyl chloride by the congo red method

    塑料試驗方法.第1部分:熱性能.試驗方法130a :剛果紅法測定聚氯乙烯熱穩定性
  9. Test should be proceed under good meteorologic conditions and sea condition, keep the cruise 、 ship speed and main engine revolution of the vessel stable before trial, rudder angle should keep at center position

    試驗應在良好的氣象條件和海況下進行，試驗前，應保持航行、航速以及主機轉速的穩定，試驗期間，舵角應保持在正中位置。
  10. Methods of test for verification of stability of pallet stackers and high lift platform trucks

    托盤碼垛機和高陞程平臺貨車穩定性驗證試驗方法
  11. Pss parameters setting and field test on tubular turbine unit

    發電機組的電力系統穩定器參數整定試驗
  12. The best percentages of the component parts of the new material was found in the experiments. we measured its mechanical properties and did the test on its stableness. the results of the experiments and analysis show that the semi - rigid bituminous emulsion has advantage to the bitulith

    本文對乳化渣油半剛性路面材料進行了系統的實驗研究和理論分析，簡述了該材料的製作和成型機理，探討了其最佳配比，進行了穩定試驗，測試了力學性能，並對其進行了微觀分析。
  13. Cosmic ray test was carried out to choose and optimize working parameters of full - length prototype and its data acquisition system, verify the electronics system about dynamic range, drift time measurement search window, charge measurement integral width, work stability and electronics grounding and noise. in experiment, acquired abundant experience with the solution of actual problem and verified their reliability of physical design. this lays the foundations for the successful construction of the besiii drift chamber and electrical system

    測試過程中我們調整了電子學的動態范圍、漂移時間和電荷測量參數驗證了電子學系統工作的穩定性、抗干擾能力及噪聲水平等並成功解決了實驗過程中遇到了問題。通過長時間的取數進一步檢驗了全長模型和電子學系統工作穩定性，驗證了全長模型及其數據獲取系統物理設計的可靠性，為漂移室和電子學系統的成功研製奠定了基礎。
  14. At present plenty of experimental study has been made on the materials and structural performance of asphalt concrete cores in the world, and the design methods and construction technique as well as equipments have been more mature. however, there is still lack of the research of its basic performance. in this thesis, in combination with the actual project, the experimental study has been employed with the field core specimen and the specimen made in laboratory, mainly include the static triaxial test, confinement pressure stabilization test and stress relaxation test

    目前，國內外對瀝青混凝土心墻的材料和結構性能已進行了一些試驗研究，其設計方法、施工工藝和設備較為成熟，但其基本性能研究方面顯得較為薄弱，本文結合實際工程對瀝青混凝土心墻的芯樣和試驗室成型的試件進行了試驗研究，主要包括靜三軸試驗、圍壓穩定試驗以及應力鬆弛試驗研究，得到以下基本結論： 1
  15. Methods of test for verification of stability of industrial trucks operating in special condition of stacking with mast tilted forward

    工業用帶前傾起重桿的碼垛貨車特殊條件下工作穩定性驗證試驗方法
  16. With the application of the statistic and decision theory, such as robust design of experiments, calculation of parameter, simulating comparison, optimizing plan and evaluating reliability etc, this plan solves the problem of optimizing the universal examination of the same fuse with several shells in the approval test

    該方案通過對穩健試驗設計、參數計算、模擬比較、方案優化、可靠性評估等一系列決策理論和統計理論的運用，解決了多彈種通用引信在設計定型試驗時通用性考核的優化問題。
  17. Other content in this paper is the design and investigation of spiral inlet port. the geometries that compose intake port have been repeatedly when intake port scheme was designed. the intake port scheme has been carried out steady - flow test. the experiment data has been analyzed and investigated, then the performance of inlet port has been estimated by the fluid coefficient and the whirl ratio. at last, the spiral inlet port scheme has been selected based on matching relation of the factors of combustion system. in addition, how to " intake port synthesis performance coefficienf ' evaluate engine intake port has been discussed

    本文的另一項內容是螺旋進氣道的設計和研究。通過對進氣道的幾個主要結構參數進行反復修改擬定進氣道方案，並對其進行穩流試驗，分析和研究試驗數據，利用流通系數、渦流比進行進氣道性能評估，根據燃燒系統要素的匹配關系，確定了兩種螺旋進氣道方案。另外，本文探討了「進氣道綜合性能系數」對發動機渦流進氣道性能的評估能力。
  18. Road vehicles - passenger car trailer combinations - lateral stability test iso 9815 : 1992

    道路車輛.客車拖車組合.橫向穩定試驗
  19. Thermal stability test

    熱穩定試驗
  20. Aiming at the problems that there are in the fuse universal test of the conventional weapons test, this paper puts forward using quality control method and statistical analysis method to get the optimum plan for fuse universal test, meanwhile evaluates the reliability

    本論文針對常規兵器試驗中引信通用性試驗存在的一些問題，提出用線外質量管理方法?穩健試驗法、極差分析和方差分析等統計分析方法，對引信通用性試驗方案進行優化設計，同時對引信的通用性進行了可靠性評定。
分享友人
分享到 Line

分享到臉書