穩態精度 的英文怎麼說

中文拼音 [wěntàijīngdù]
穩態精度 英文
steady-state accuracy
  • 穩 : 形容詞1 （穩定; 穩當） steady; stable; firm 2 （穩重） steady; staid; sedate 3 （穩妥） sure; rel...
  • 態 : 名詞1. （形狀; 狀態） form; condition; appearance 2. [物理學] （物質結構的狀態或階段） state 3. [語言學] （一種語法范疇） voice
  • 精 : Ⅰ形容詞1 （經過提煉或挑選的） refined; picked; choice 2 （完美;最好） perfect; excellent 3 （細）...
  • 度 : 度動詞[書面語] （推測; 估計） surmise; estimate
  • 精度 : precision; accuracy; degree of accuracy; precision accuracy; trueness
  1. For a class of series - wound active power line conditioner the design approach law of a new fuzzy integral sliding mode variable structure control is presented. this method adjusts power electronic switch in order to achieve anticipated balance volt, finally makes active power line conditioner not only possess good robustness of variable - structure control and decrease vibration to the most but also increase the steady state precision. series - wound aplc adopted this control method possesses good dynamic and steady state performance

    針對串聯型有源電網調節器運用變結構控制策略，調節電力電子開關模式，以獲得預期的平衡電壓，對串聯型有源電網調節器提出了模糊積分變結構控制方法，使串聯型有源電網調節器既保持了常規滑模控制強魯棒性的優點，又減弱了滑模控制的抖振，提高了系統的穩態精度，使系統具有良好的動態和靜態性能，模擬試驗表明該控制策略是一種十分有效的控制方法。
  2. And it is difficult to apply general pid control or fuzzy control to the equipment of crystal growth with nonlinear and great pure hysteresis characteristics

    晶體生長爐具有參數時變、大慣性和大純滯后的特點，應用常規pid控制演算法，動態性能不理想；應用模糊控制演算法，穩態精度不能令人滿意，都難以實現有效的控制。
  3. Fuzzy control is a simple and practical control method that had been developed in recent years. it has some adaptive ability for process parameter changes, but its steady - state accuracy is unsatisfactory

    模糊控制是近年來發展起來的一種簡單實用的控制方法，對被控過程參數變化有一定的適應能力，但它的穩態精度較差。
  4. The stability, response time, overshoots and steady - state errors of the systems are analyzed ; and the result indicates the feasibility of the model

    對系統的穩定性、過渡時間、超調量和穩態精度進行了分析，說明了該模型的可行性。
  5. Abstract : according to the characterestic of resistance furnace temperature control, temperature rising one - way control, large time delay and time - variation of parameter, using method of fuzzy compositional rule of inference establish fuzzy model and design fuzzy cntroler. in order to increase control system precision, it gives a fuzzy variable k, and sets parameter self - adjusting fuzzy control system. this system can on line self - adjusting controller parameters according to the error and variations of the error. it makes the system steady precision improved

    文摘:根據電阻爐溫控制的特點，即只有升溫單向控制、滯后較大且具有參數時變性，利用模糊推理合成法建立模糊模型並進行模糊控制器設計，為提高模糊控制的精度，引入模糊變量k ，構成參數自調整模糊控制系統.該系統可根據誤差和誤差變化在線自動調整控制器參數，使系統的穩態精度得到改善
  6. According to the characterestic of resistance furnace temperature control, temperature rising one - way control, large time delay and time - variation of parameter, using method of fuzzy compositional rule of inference establish fuzzy model and design fuzzy cntroler. in order to increase control system precision, it gives a fuzzy variable k, and sets parameter self - adjusting fuzzy control system. this system can on line self - adjusting controller parameters according to the error and variations of the error. it makes the system steady precision improved

    根據電阻爐溫控制的特點，即只有升溫單向控制、滯后較大且具有參數時變性，利用模糊推理合成法建立模糊模型並進行模糊控制器設計，為提高模糊控制的精度，引入模糊變量k ，構成參數自調整模糊控制系統.該系統可根據誤差和誤差變化在線自動調整控制器參數，使系統的穩態精度得到改善
  7. The concept of acceleration delay compensation is put forward in this dissertation. by using acceleration delay compensation and tv tracker compensation technology the tracking capability of o - e theodolite tv tracking system is promoted to track fast moving targets at maximal 50 / s angular velocity and maximal 30 / s2 angular acceleration other than maximal 30 / s angular velocity and maximal 12 / s2 angular acceleration before while the maximal tracking error is still less than 3

    提出了加速度滯后補償的概念，並將其應用到提高電視跟蹤穩態精度中；結合電視跟蹤器補償技術，在保證最大跟蹤誤差不大於3的條件下，將目前的光電經緯儀電視跟蹤系統跟蹤最大角速度30 / s 、和最大角加速度12 / s2能力，提高到跟蹤最大角速度50 / s 、最大角加速度30 / s2 。
  8. In conformity with this means, we study that the changing of radar and platform coefficients influences the target location, and present the way to analyze the location accuracy through the platform position accuracy, platform attitude stability and radar timing accuracy

    在此基礎上，論文剖析了雷達及平臺參數變化對目標定位的影響，提出了通過平臺位置精度、平臺姿態穩定精度和雷達定時精度來分析目標定位精度的方法。
  9. The experiment result shows that conversion efficiency in ccm is improved by 2 percent compared with that in dcm, although the on - resistance of winding in ccm is more than that in dcm. the analysis of open - loop transfer function in both dcm and ccm shows that pull - push hfl inverter at ccm

    微分補償網路的推挽高頻鏈逆變電路在輸出從空載變化到額定阻性負載變化的過程中，逆變電路工作模式從dcm變化到ccm模式，實驗結果表明電路在這兩種模式下都能輸出穩定的正弦電壓，且具有較高的穩態精度。
  10. The simulation results indicate that the algorithm is suitable for the speed regulation of srm. within a wide speed range the system has a good regulation character and a high precision of steady state, also the system can well constrain the disturbance of the load torque varying

    模擬結果表明，採用本演算法構成的sr電機凋速系統在整個調速范圍內具有良好的調節性能及穩態精度，對負載轉矩的變化造成的擾動輸入能夠很好的加以抑制。
  11. Control simulations prove that the designed control system has quick response and high steady - state accuracy

    模擬結果表明，本文所設計的模糊控制系統具有較高的響應速度和穩態精度。
  12. For the position loop designs, considers the exact orientation for overall system and insure the steady - state accuracy of complete system, we also use the pid control for the position loop

    為了確保整個系統的穩態精度和精確定位，位置環的設計也採用了傳統的pid控制。
  13. The imperfect static precision is a weakness of classical fuzzy control

    穩態精度欠佳是經典模糊控制的一個弱點。
  14. Simulation results shows that this method is better static precision and dynamic characteristic than the pid controlling

    模擬結果表明，與傳統的pid控制相比，該方法有著較高的穩態精度和動態特性。
  15. Then the author analyzed the three - axis position servo system, deduced the transfer function. in order to know what affect the steady precision and static precision the author made a detailed analysis about them. then the author put forward the measure which can improve the steady precision and static precision

    以位置控制的電機帶載伺服系統為研究對象，建立三軸電動測試轉臺的數學模型並進行理論分析，求出開環傳遞函數，對系統的穩態精度和靜態誤差進行分析，找出影響因素及提高措施。
  16. In the control strategy, the basic value of rotation rate is calculated by corrected similar formulation and the adjustment value is ascertained by output of fuzzy controllers, the strategy can assure steady precision and to eliminate vibration

    在這種控制策略中轉速控制量的基值根據修正後的相似公式進行計算，而轉速控制量的調節值為模糊控制器的輸出，這樣做既保證了系統的穩態精度；也避免了系統振蕩。
  17. The reference signal and the disturbance signal are controlled, which can achieve optimal effect in the meantime, applying adaptive lms algorithm based on variable step and variable region to variable frequency speed regulation system, the initial convergence rate, tricking ability of time - varying system and stable precision are best in the meantime

    利用變論域變步長的lms自適應濾波演算法，使自適應逆控制的異步電機變頻調速系統及其逆系統辨識的初始收斂速度、時變系統跟蹤能力及穩態精度3個指標同時達到最優。
  18. The dynamic performance and steady accuracy of the servo systems are crucial factors for precision measuring and grinding

    要實現精密的測量和修磨，伺服系統的動態性能和穩態精度等指標是決定性因素。
  19. The simulation results prove that this system has rapid dynamic response speed and high steady - state, as well as good following capability and strong robustness

    模擬結果表明，該系統具有不僅上升速度快、穩態精度高，而且跟隨性好、魯棒性強。
  20. On the basis, fuzzy self - adaptive pid control methods are applied, the fuzzy rules for dynamic modification of pid parameters are established to adjust pid parameters online. those enable the system with better robustness and preciseness of stable status

    在此基礎上，運用模糊自適應pid控制方法，制定pid參數動態修改的模糊規則，對pid參數進行在線自適應調整，使整個系統達到較好的魯棒性和穩態精度。
分享友人
分享到 Line

分享到臉書