空氣進口 的英文怎麼說

中文拼音 [kōngjìnkǒu]
空氣進口 英文
air entry
  • : 空Ⅰ形容詞(不包含什麼; 裏面沒有東西或沒有內容; 不切實際的) empty; hollow; void Ⅱ名詞1 (天空) s...
  • : Ⅰ名詞1 (氣體) gas 2 (空氣) air 3 (氣息) breath 4 (自然界冷熱陰晴等現象) weather 5 (氣味...
  • : 進構詞成分。
  • : Ⅰ名詞1 (人或動物進飲食的器官; 嘴) mouth 2 (容器通外面的地方) mouth; rim 3 (出入通過的地方) ...
  • 空氣 : 1 (大氣) air; atmosphere 2 (氣氛) atmosphere 3 (氣閘) air brake4 pneum ; pneumo ; pneumat ;...
  • 進口 : 1 (船隻進港) enter port; sail into a port2 (外貿進口) import3 (入口) entrance; [機械工程] i...
  1. While working, the air with dust enters into the sedimentation chamber via wind entrance, dust with large size granule will fall because of sudden expand of the aeriform cubage, then the air will pass the water area of arc boards of the two sides to stir the water. then air with dust will be mixed with water forming water curtain at the exit, fine powder will be collected, purified air will be discharged by blower fans via breakwater and wind exit

    工作時含塵入沉降室由於體的體積驟然膨脹,大顆粒粉塵沉集下來,然後經過兩側弧形板間的水域並將水攪動含塵與水充分混合在出處形成水幕,較細的粉塵捕集下來,凈化后的經擋水板和出風由風機排走。
  2. The anchor flange for west - fast gas pipeline project is a kind of important device to avoid axile thrust damages all valve of electric field and the anchor flange of the project are only supplied by my company. the anchor flange has replaced import product, filling up domestic blank and achieving nationalization.

    錨固法蘭是西東輸管道工程為防止軸向推力對各種站場閥室造成破壞而設置的一種重要裝置。全線所用的錨固法蘭均由我公司獨家供應。該產品代替了,填補了國內白,實現了國產化。
  3. The fresh-air inlet was usually the crankcase breather cap.

    新鮮空氣進口一般是曲軸箱通蓋。
  4. Second, the starting and stopping behaviors under disturbed condition are analyzed and calculated by using the dynamic concentrative parameter model, which gives some advice to better prescribe refrigeration system and set theoretic foundation for carrying out automatic control of refrigeration system. third, the normal running process is analyzed and calculated by means of rational matching theory, which gives some advice on how to better understand the parameter change under steady state and the affection of inlet - parameter on evaporator. fourth, the simulation software with dynamic characteristic is designed, which can be applied to calculate thernio - parameter of cryogen, air humidity and frost thickness under different initial and boundary conditions, and to carry out dynamic simulation under conditions of dryness, wetness and frostiness, at the same time, to achieve detection and simulation at any stage from starting to stopping

    本文的主要內容如下: 1 )對翅片管蒸發器結構特點行分析,選取適當的微元控制體,就干、濕和霜工況下對每個微元分別行傳熱傳質分析,基於經驗關系式確定霜的有關參數,對于霜工況下的霜生長建立模型,經適當假設,運用質量守恆、能量守恆和動量守恆方程建立適合動態模擬的蒸發器數學模型,為系統模擬奠定基礎; 2 )對蒸發在大擾動下的開、停機過程,運用動態集中參數模型行分析和計算,為更好地描述製冷系統運行的全過程奠定基礎,同時也為製冷系統實現自動控制提供一定的理論基礎; 3 )對蒸發器正常運行過程,運用動態分佈參數和參數間定量耦合的觀點來分析和計算,為更好地了解穩態工況下各點參數的變化情況及各入參數對蒸發器動態特性的影響即蒸發器性能對各參數變化的敏感性; 4 )編寫翅片管蒸發器動態特性模擬計算程序,可以計算不同邊界條件和初始條件下的製冷劑熱力參數、溫濕度和霜厚度分佈場,實現對翅片管蒸發器在干、濕和霜工況下的動態模擬。
  5. The thesis focuses on the development of the dynamic simulation model of evaporators, the accomplishment of the stable and dynamic simulation of the parameters of cryogen - side, air - side and how to carry out dynamic simulation on the refrigerating effect of evaporators under different evaporating temperature and the realization of the analyses and calculations of the main parameters, such as, the wind speed of air - side and specific humidity etc, which affect the function of evaporators

    本文重點是對蒸發器建立動態模擬模型,並對製冷劑側和側參數行穩態和動態模擬,同時對蒸發器在不同蒸發溫度下的製冷量行了動態模擬,而且對影響蒸發器性能的主要參數(側入風速、入含濕量等)行了分析和計算。
  6. Firstly, simulate flow field of rear smoke channel, plot velocity magnitude and ash concentration distribution in section of entry of heat pipe air preheater, compare with data which were measured in guiyang power station, verify simulation to be reasonable and right. secondly, simulate all kinds of factors which affect flow field ' s uniformity such as length, thickness, location of diffluent board, ash concentration, ash diameter, and so on, find the chiefly factors. thirdly, install guide board in curve channel in rear smoke channel, then simulate its " flow field, plot velocity magnitude and ash concentration distribution

    在此基礎上模擬在冬夏兩季不同情況下,不同流速對熱管預熱器壁面溫度的影響;然後對影響整個流場分佈的各種因素:包括分流板長度、厚度、偏離中心流道位置的偏離度、飛灰濃度、飛灰粒徑等因素行數值模擬;最後提出在分流煙道轉彎處加裝導流板,並模擬加裝導流板后的流場分佈,得到下級預熱器出、熱管預熱器處的斷面速度場分佈、濃度場分佈,以論證加裝導流板能達到流場均勻化的作用。
  7. To research the energy transformation and utilization orderliness of the new proposed system is the main objective and content of this dissertation, as follows : about two thirds of the work output of the turbine is consumed by the compressor. traditionally, every way of inter - cooling adopted in gas turbine decreases the work consumption of compressor in some degree. through the spraying of water at the entrace of compressor, the air can be continuously cooled in compression so that the work consumption can be reduced greatly

    本論文從以下幾個方面行了研究:由於燃輪機循環中壓機消耗近2 3的透平出功,傳統上採用的各種間冷方式都一定程度地降低了壓機耗功;而壓機入採用注水方式,可以對壓縮行連續冷卻,以達到大幅度降低壓機耗功的目的。
  8. Devices to prevent pollution by backflow of potable water - air gap with submerged feed incorporating air inlet plus overflow - family a, type c

    防飲用水迴流污染裝置.帶浸入式給水裝有空氣進口和溢流隙. a類c型
  9. Devices to prevent pollution by backflow of potable water - air gap with submerged feed incorporating air inlet plus overflow - family a, type c ; german version en 13078 : 2003

    防飲用水迴流污染裝置.帶浸沒式給水裝有空氣進口和溢
  10. The influence of the temperature of durene solution, the height from airway nozzle to liquid level, the temperature and feed rate of air on the vapor phase concentration of durene were studied with the self - made adjustor

    摘要利用自製的高熔點物料相濃度調控儀,研究了均四甲苯溶液的溫度、導管管距離均四甲苯液面的高度、溫度和料量等對均四甲苯相濃度的影響。
  11. Some liquid will vaporize and some of the vapor will be carried into the flame through the air inlets

    有一些液體會蒸發,而有一些則會通過入火焰。
  12. Air inlet strainer

    空氣進口
  13. Air inlet guide vane assembly

    空氣進口導流葉片裝置
  14. In the text, there analyzes the process of the mixture air and fuel in the two stroke gasoline engine and bring forward the specific solution to the improvementsing gasoline engine the high - press direct in - cylinder injection. this technology sprays the feul into the cylinder after the outlet vavle closed and scavengs the engine cylinder with pure and fresh air, which avoid the fuel escapes unburned

    本文分析了二沖程汽油機混合形成過程,並提出了具體的改方案,用缸內高壓直接噴射技術行改造。缸內高壓直接噴射是在發動機排關閉後向缸內噴射燃油,使用純新鮮行掃,避免了燃油短路損失。
  15. Separation of the water supply from the air inlet is accomplished by means of a diaphragm seal

    水供應與空氣進口的分離通過隔膜密封的方法實現。
  16. Requirement : air inlet must start to open when down stream pressure is 1. 0 psi or above

    要求:當下游流體壓力在1 . 0psi及以上時,空氣進口必須開始打開。
  17. The valve shall be constructed with a molded diaphragm separating the air inlet from the potable water supply to prevent spillage

    這種閥門結構應該是採用隔膜將空氣進口與飲用水供應分離開來以防止泄漏或溢出。
  18. Qualified heat recovery rate acquired from the merge equation ' s resolve in terms of the fortran program and the hvac - id graph in the course of the theory calculation. determining the experimental equations applying the ortho imitated experimental design on the basis of the simple spray chamber. the experimental date originated running double - spray chamber ' s entrance and exit air

    理論計算中通過編制的fortran程序求解組合方程組,並結合hvac - id圖求得符合要求的熱回收率,其間試驗公式是在單噴水室的基礎上採用一次正交回歸試驗設計得到,試驗結果是通過對運行的雙噴系統中的室內外狀態參數行測定而得到。
  19. The raw material to be dried can not be polluted and the quality of raw materials to be dried can not be damaged

    都有過濾器,不會污染被乾燥的物料,影響其品質。
  20. He took a deep breath. i could hear the air rip at his throat. he coughed and breathed again. but he sat still and did not try to escape

    他深深吸了一。我可以聽到入他喉嚨的聲音。他咳嗽了一又開始呼吸起來。但是卻始終直直坐著,沒有逃跑的打算。
分享友人