空氣預熱管 的英文怎麼說

中文拼音 [kōngqìyùrèguǎn]
空氣預熱管 英文
economizer bank
  • 空 : 空Ⅰ形容詞（不包含什麼; 裏面沒有東西或沒有內容; 不切實際的） empty; hollow; void Ⅱ名詞1 （天空） s...
  • 氣 : Ⅰ名詞1 （氣體） gas 2 （空氣） air 3 （氣息） breath 4 （自然界冷熱陰晴等現象） weather 5 （氣味...
  • 預 : Ⅰ副詞（預先; 事先） in advance; beforehand Ⅱ動詞（參與） take part in
  • 管 : Ⅰ名詞1 （管子） pipe; tube 2 （吹奏的樂器） wind musical instrument 3 （形狀似管的電器件） valve;...
  • 空氣 : 1 （大氣） air; atmosphere 2 （氣氛） atmosphere 3 （氣閘） air brake4 pneum ; pneumo ; pneumat ;...
  1. Firstly, simulate flow field of rear smoke channel, plot velocity magnitude and ash concentration distribution in section of entry of heat pipe air preheater, compare with data which were measured in guiyang power station, verify simulation to be reasonable and right. secondly, simulate all kinds of factors which affect flow field ' s uniformity such as length, thickness, location of diffluent board, ash concentration, ash diameter, and so on, find the chiefly factors. thirdly, install guide board in curve channel in rear smoke channel, then simulate its " flow field, plot velocity magnitude and ash concentration distribution

    在此基礎上模擬在冬夏兩季不同情況下，不同流速對熱管空氣預熱器壁面溫度的影響；然後對影響整個流場分佈的各種因素：包括分流板長度、厚度、偏離中心流道位置的偏離度、飛灰濃度、飛灰粒徑等因素進行數值模擬；最後提出在分流煙道轉彎處加裝導流板，並模擬加裝導流板后的流場分佈，得到下級空氣預熱器出口、熱管空氣預熱器進口處的斷面速度場分佈、濃度場分佈，以論證加裝導流板能達到流場均勻化的作用。
  2. Wearproof porcelain plate developed by this factory can be used as inside lining plate, coal delivery pipework, bin, bunker, separation port, wind pipe bend, exhauster, inner pipe of mill fan, air preheater, air fule and various dedust equipment for antifriction. besides, it can extend the service life of equipment

    耐磨瓷板系是我廠自行研製的適用於磨煤機內襯板，輸煤管道、料倉、料斗、粗、細粉分離口、一、二次風管彎頭、引風機、排粉機內殼、空氣預熱器、尾部煙道等以及各類除塵系統設備的防磨抗蝕、延長設備的使用壽命。
  3. We specialize in manufacturing & developing the high efficiency self recuperative gas burners, which are widely used in direct heating and the radiant tube in various industrial heat treatment furnaces

    本公司專業生產和開發高效率空氣自身預熱式燒嘴，廣泛應用於各種工業熱處理爐的明火或輻射管加熱
  4. Air cannon block clearer is a special device used to prevent and remove the material blast and block of all kinds of bunker, hopper, cement preheating furnace, pipeline y section and mine drawshaft and drawslope

    空氣炮清堵器是防止和消除各類型料倉，料斗、水泥預熱器窯和管道分叉處及礦山溜井、溜坡的物料起拱，粘倉閉塞等現象的專用裝置。
  5. The new developments of htm station technique were introduced from the aspects such as changing the htm pipeline type in pet htm station, increasing the switch forms of steam atomization and compressed air atomization, increasing the steam generator, sending stripping tower off - gas to combination and using new material nd steel in air preheater

    摘要從改變聚酯熱媒站的熱媒爐熱媒管線形式、增加蒸汽霧化與壓縮空氣霧化的切換形式、增加蒸汽發生器、汽提塔尾氣送燒、空氣預熱器採用新型材質nd鋼等方面介紹熱媒站技術的新發展。
  6. New five - stage cyclone pre - heater system, high efficiency air girder grate cooler, multi - passage pulverized coal burner, davison heat temperature fan, luqi bs930 electrical dust collector, as well as chain - board elevator, chain conveyor adopted in this production line can ensure that the technology is advanced compared to other production lines with the same scale

    如新型五級旋風預熱預分解系統、高效空氣梁篦冷機，節能型多通道噴煤管，戴維森高溫風機，魯奇最新技術生產的電收塵（ bs930 ）等，輸送設備採用了耐用、節電的板鏈提升機、鏈式輸送機，將使本工程的裝備在同規模生產線中處于領先水平。
  7. 2. design scheme of gravity heat pipe air pre - heater is proposed which fits the actual situation of injecting steam boilers. detailed heat calculation and design on heat recovery of flue gas is carrying out

    提出了採用適合於注汽爐實際工況的重力熱管式空氣預熱器的設計方案，對煙氣的余熱回收進行了詳細的熱力計算和設計。
  8. Application of heat pipe type air pre - heaters

    熱管空氣預熱器的應用
  9. Heat pipe air pre - heater is adopted to recover gas heat to heat up cold air for burning, reducing flue gas temperature and increasing heat efficiency of injecting steam boiler

    採用熱管式空氣預熱器，利用排煙熱量加熱冷空氣，降低了煙氣溫度，減少排煙熱損失，提高注汽爐熱效率。
  10. Abstract : the in servie tubular heaters built early in refineries and chemical plans have low thermal load and low heat efficiency, therefore measures for technical reform are offered, including ( 1 ) enlarging the surface area of convection tubes to increase the thermal load of rhe convection section ; ( 2 ) increasign the heat interchanging area of radiant tubes ; ( 3 ) changing the height of the chimney ; ( 4 ) using new burner with forced air supply to increase calorific capacityu ; ( 5 ) adding air preheater between the convection section and chimney to enhence the temperature of the air entering the furnace ; ( 6 ) adopting high temperature radiant coating to improve the effect of radiant heat interchanging

    文摘:針對早期建造的煉油廠和化工廠在役管式加熱爐熱負荷和熱效率低的狀況，提出了若干技術改造措施包括，增大對流管表面積以增大對流段的熱負荷；增加輻射管的換熱面積；修正煙囪高度；換用新型燃燒器，變自然通風為強制供風，以增大燃燒器的發熱量，減小過剩空氣系數，節省燃料2 % 3 % ；在對流段和煙囪之間增設空氣預熱器以提高空氣入爐溫度；採用高溫輻射塗料增強輻射換熱效果，從而增加熱源對爐壁的輻射傳熱量和爐管的傳熱量等。
  11. The in servie tubular heaters built early in refineries and chemical plans have low thermal load and low heat efficiency, therefore measures for technical reform are offered, including ( 1 ) enlarging the surface area of convection tubes to increase the thermal load of rhe convection section ; ( 2 ) increasign the heat interchanging area of radiant tubes ; ( 3 ) changing the height of the chimney ; ( 4 ) using new burner with forced air supply to increase calorific capacityu ; ( 5 ) adding air preheater between the convection section and chimney to enhence the temperature of the air entering the furnace ; ( 6 ) adopting high temperature radiant coating to improve the effect of radiant heat interchanging

    針對早期建造的煉油廠和化工廠在役管式加熱爐熱負荷和熱效率低的狀況，提出了若干技術改造措施包括，增大對流管表面積以增大對流段的熱負荷；增加輻射管的換熱面積；修正煙囪高度；換用新型燃燒器，變自然通風為強制供風，以增大燃燒器的發熱量，減小過剩空氣系數，節省燃料2 % 3 % ；在對流段和煙囪之間增設空氣預熱器以提高空氣入爐溫度；採用高溫輻射塗料增強輻射換熱效果，從而增加熱源對爐壁的輻射傳熱量和爐管的傳熱量等。
  12. It works in the field where the temperature of gas is lowest of all components that be heated in the boiler. in general, air pre - heater is made of smooth pipes

    鍋爐設備中的低溫段管式空氣預熱器位於鍋爐煙氣溫度比較低的區域，它的管子通常採用光管構成。
  13. Application of new steam soot - blower on heat pipe preheater

    用於熱管式空氣預熱器的新型蒸汽巡掃吹灰器
  14. The type of heat transfer inside the pipes belongs to single - phase compulsive turbulent flow of inner pipe. inner trachea is a kind of special pipe compared by smooth pipe, which can strengthen heat transfer inside pipe

    空預器煙氣側的換熱類型是管內單相強迫紊流換熱，論文在查閱了相關文獻的基礎上，比較了幾種不同的管內強化換熱措施，在其中選擇內螺紋管代替光管，來改造管式空氣預熱器。
  15. There are a lot of advantages when inner trachea applied in air pre - heater, such as the improvement of the temperature of pipe, the low consumption of metal, except for the increment of flow resistance. according to many related papers, it is more proper inner trachea with the structure of short distant between two whorls and shallow depth of whorl. it can enhance heat transfer with smaller flow loss

    內螺紋管是一種異形管，和光管相比，管內側的換熱系數大大增強了，應用於空氣預熱器可以起到提高總傳熱系數、節約受熱面金屬消耗量的目的；同時提高了管壁溫度，能夠減輕低溫腐蝕的程度和速度；不足之處是帶來了更大的阻力損失。
  16. Taking some tubular air pre - heater used in one boiler whose capacity is 130 t / h as an example, new blue print with inner trachea is completed by means of computer program. several key design variables may be changed, such as diameter of pipe and velocity of flow of gas. these cases have been considered, and their results have also been compared with each other

    比較了幾個重要的設計變量，如外管徑、煙氣流速等參數變化時，總傳熱系數和空預器本體管子總重量，阻力損失以及最低管壁溫度等幾個重要設計結果的變化趨勢，對內螺紋管空氣預熱器的設計具有借鑒意義；其間還分析了內螺紋管與光管在設計時的不同之處；最後，初步分析了內螺紋管的優化設計問題，提出了一些建議。
  17. There will appear a very uneven flow field, and appear a very big velocity magnitude distribution and ash concentration distribution near back wall. thus, the velocity magnitude is far bigger than that of optimal design velocity magnitude, which will lead to serious wear and tear in metal face of heater. especially, because of curve structure in front of heat pipe air preheater, there is more serious wear and tear

    由於靠近豎井后墻面的煙氣流速很大，飛灰濃度也較大，斷面速度分佈的最大速度大於最佳設計速度的2 - 3倍，這樣將造成受熱面的嚴重磨損，特別是熱管空氣預熱器前端煙道的幾何結構有一定的轉角，更增加了磨損的程度。
  18. In the end, the paper makes an thermodynamic analysis, evaluation of investment and techno - economic analysis on the retrofit plans of heat recovery steam generator and air pre - heater, which helps to make the evaluation of the plans from the view of energy conservation and economy benefit

    完成熱管布置設計和設備細部結構設計，繪制余熱回收設計圖紙。最後對所設計的余熱鍋爐和空氣預熱器方案進行熱力學分析、投資概算和技術經濟分析，從節能和經濟性角度評價了設計方案的效益。
  19. This thesis focuses on the overall optimal design of pipe parts and head pipe exchanger. an example is also presented to stand for the typical heat pipe heat exchanger ( that is, head - pipe air pre - heater ). the specific details and methods are introduced in the integrated optimal design and the optimal selection for head pipe heat exchangers

    本課題就是要針對這一問題，對熱管元件及熱管換熱器整體優化設計進行研究，以氣- - -氣熱管換熱器中典型代表- - -熱管空氣預熱器為例，利用最優化理論，提出了對其進行整體優化設計的方法。
分享友人
分享到 Line

分享到臉書