空間測標 的英文怎麼說

中文拼音 [kōngjiāncèbiāo]
空間測標 英文
space mark
  • 空 : 空Ⅰ形容詞（不包含什麼; 裏面沒有東西或沒有內容; 不切實際的） empty; hollow; void Ⅱ名詞1 （天空） s...
  • 間 : 間Ⅰ名詞1 （中間） between; among 2 （一定的空間或時間里） with a definite time or space 3 （一間...
  • 測 : 動詞1. （測量） survey; fathom; measure 2. （測度; 推測） conjecture; infer
  • 標 : Ⅰ名詞1 [書面語] （樹梢） treetop; the tip of a tree2 （枝節或表面） symptom; outside appearance; ...
  • 空間 : space; enclosure; room; blank; interspace
  1. The intelligent mine will be the most important weapon system to defend arming helicopter hedgehopping in future war. passive acoustic detection technology is the key technology. with the researching of the national defence pre - researching project which is the research of acoustics compound fuse of anti - helicopter intelligent mine, this paper presents acoustic localization algorithm and discusses the affect of wind to the localization, then a method of how to correct the affect of wind has been studied, upon this a dsp software system has been designed

    智能雷彈是防禦超低空飛行的武裝直升機的重要武器系統，而被動聲探測技術是其關鍵技術，本文結合「九?五」國防預研項目「反直升機智能雷彈聲復合引信技術」的研究，對空間目標聲定位演算法和風對被動聲定位的影響及如何對這種影響進行修正進行了深入分析，並在此基礎上設計了dsp軟體系統。
  2. The intelligent mine will be the most important weapon system to defend arming helicopter hedgehopping in future war. passive acoustic detection technology is the key technology. with the researching of the national defence pre - researching project which is the research of acoustics compound fuse of anti - helicopter intelligent mine, this paper presents two type of acoustic localization algorithm, emphasizes the discussion of algorithm and presicion of space acoustic localization with sensors at different height in detail and compares them

    智能雷彈是防禦超低空飛行的武裝直升機的重要武器系統，而被動聲探測技術是其關鍵技術，本文結合「十?五」國防預研項目「反直升機智能雷彈聲復合引信技術」的研究，對兩種空間目標聲定位演算法進行了深入分析，重點討論了空間高低陣定位演算法，分析了定位精度。
  3. In the research realm of the target identify, an important topic is to minish the laser radar cross section of the space target for target stealth. the laser radar probes a target is based on the target under the laser, the space and time distribute characteristic of the strength ? polarization and phasic of the laser scattering etc. to identify a target

    在目標識別研究領域有一個重要的課題是減小空間目標的激光雷達散射截面便於目標隱身。激光雷達探測目標是根據目標在激光照射下，激光散射的強度、偏振和相位等的空間和時間分佈特徵來識別目標，目標表面粗糙度是影響目標激光散射特性的重要影響因素。
  4. The measure system of tangent for space coordinates

    接觸式空間坐標測量系統
  5. The signal processing techniques of infrared spectrum radiometer for detecting spatial objects was investigated

    摘要研究用於空間目標探測的紅外光譜儀信號處理技術。
  6. Compared with currently fire control system, apsse has such characteristic as : highly precision, complex construction, high technique, etc. so this thesis expatiated in detail on the measuring theory of apsse, emphases on the discussion of system error and random error of apsse, deduced the three axis error of apsse usign the coordination transformation methods, provided the applying base for the measuring error equation of apsse. in this paper, we emphases on expatiating the basic theory of usign space coordination transformation in the measuring error equation of apsse

    因此，論文採用了空間坐標變換方法分析機載光電跟蹤測量設備在對目標進行測量、定位時空間坐標轉換關系，推導出從中心地平坐標繫到目標坐標系的變換矩陣，在此基礎上首先建立機載光電跟蹤測量設備的無測量誤差的位置傳遞方程和機載光電跟蹤測量設備的含有測量誤差的位置傳遞方程，為利用蒙特卡洛法分析機載光電跟蹤測量設備的測量誤差奠定了理論基礎。
  7. Including usign coordinate transformation method to deduce the uniform coordinate from the object coordinate to the photo coordinate, then setup the measuring error equation of apsse, this established the theory ground of usign the mont carlo method to analysis the error of apsse. there are errors from every tache of coordinate transform

    由於建立機載光電跟蹤測量設備的測量誤差的位置傳遞方程是基於空間坐標變換的基礎上，從中心地平坐標繫到目標坐標系的變換涉及到幾十個環節，而每個環節都有誤差，其誤差的性質和大小直接影響對目標的定位測量。
  8. The main task of this paper concentrates on such parts as calibration of measurement sensor, high speed and accuracy image collection and processing, data fusion of different angle of view, visualization of measuring results. to accomplish sensor calibration, a pinhole model of the camera is employed and an equation of a light plane is setup. parameters such as the m array of the pinhole model and the normal vector of the light plane arc acquired through experiment. in image processing, we adopt the template - changing parallel thinning method to improve processing speed and accuracy

    主要研究了攝像機針孔模型的建立及測量傳感器的標定；圖像的快速高精度的採集和處理，在圖像處理中採用多幀平均演算法，很好地解決了速度和精度之間的矛盾制約；根據旋動理論建立空間坐標變換數學模型，進而建立其不同視角下的測量數據融合演算法，生成完整的物體三維數據集合；在vc平臺下編寫三維顯示軟體模塊，完成三維測量結果的可視化，實現了三維物體的任意角度的觀察、任意倍數的放大和縮小、任意方向平移及動畫效果。
  9. Aiming at the nonlincar optical mapping between spatial coordinates and image plane coordinates, a measuring method for 3 - d spatial coordinates calculation carricd out with progressive approach is put forward in the paper

    針對空間坐標對圖象平面坐標的非線性光學映射關系，本文提出了逐步逼近實現3 - d空間坐標計算的測量方法。
  10. The inner and outer orientation elements of non - mearsured camera are figured out in the method of direct linear transformation ( dlt ) on the basis of the known coordination of key points in the image. the tolerance analysis of inner and outer orientation elements is accomplished with the coordination of redundant key points. finally, the physical spacial coordination of the image points is calculated in the way of dlt

    運用直接線性變換法（ dlt ） ，根據測量圖像中控制點的已知坐標，計算出非量測相機的內、外方位元素，使用多餘的控制點坐標，完成內、外方位元素的誤差分析，最後運用直接線性變換法根據測量點的像點坐標計算出相應的物方空間坐標。
  11. Tracking of the target satellite was managed from a large team at the xian chinese space tracking control center

    對目標衛星的測控是由中國西安空間測控中心的龐大隊伍來運作的。
  12. To this problem a series of image rectification procedure which utilize geometric rectification theory in vehicle license recognition system are pointed out : we first locate vehicle license and execute the edge detection and binary conversion, then proceed calibration in which we use two calibration scheme looking for control point coordinate, one based on the hough transformation, the other based on image analysis method, and finally realize image correction in geometrical transform and bilinear gray interpolation method

    針對此問題本文給出了一套將幾何畸變校正技術應用到汽車牌照自動識別系統中的車牌圖像校正方法：首先提取牌照信息，並對圖像進行邊緣檢測和二值化的預處理；然後提出了基於hough變換控制點提取和基於圖像分析法的控制點提取的兩種實時標定方法；最後通過空間坐標變換和灰度插值完成圖像的校正。
  13. Then the optical path difference can be obtained with psi algorithm and to use the phase value for each pixel to determine a height value for each pixel. a primary advantage of psi is its high precision. with careful control of environmental conditions, measurement precision to the nanometer scale or below is possible with psi

    它的基本測量原理是，通過攝像系統（ ccd ）接受到的干涉圖中空間坐標已知的各個像素點的光強信號，在壓電晶體驅動參考光程有序變化時，採集到多幅干涉圖的光強信號，由移相干涉法，由光強值得到被測光程差值（位相值） 。
  14. The purposes of this technical reform are to raise the measurement accuracy of the miss - targets and to improve the system error of the axis, hence increase the space pointing accuracy of satellites. it can offer a measurement means for high accuracy measurement orbit, forecast and method research on the space targets

    本項改造提高了脫靶量的測量精度和減小了軸系的系統偏差，從而提高衛星的空間定位精度，為空間目標高精度測軌預報和方法研究提供了測量手段。
  15. Single axis physical simulation for wheel control system of the earth observation satellite

    基於雷達觀測的空間目標識別模擬軟體的設計與實現
  16. Also, you can target specific areas of the kernel for execution, which eliminates the typical userspace test case hit - or - miss approach to executing kernel code

    而且，您還可以執行內核的特定目標區域，這樣典型的用戶空間測試用例執行內核代碼時就不會再漫無目的。
  17. Along with the electronic warfare demand and the requirement of probing and tracking outer - space objects, phased array antennas have become developmental mainstream of the applied radar antennas

    隨著電子對抗技術的發展和外空間目標探測、控制的需要，相控陣天線已經成為當今實用雷達天線發展的主流。
  18. In this paper, a 3d finite element analysis software ( fzfx3d ) was compiled to simulate the construction process of mass concrete structures constructed with sequence method. based on the practical project xiluodu arch dam, the dam ' s construction process was simulated by a small time step size, 0. 5 or 1 days. the environmental temperature change, hydration heat rise, artificial cooling, creep, volume deformatio

    運用laplace變換方法將溫度的求解表示為只與空間坐標及澆築時間有關的函數，從而避免了用隱式差分法、有限元法求解時需求解聯立方程的因而對測點選擇的依賴，也避免了顯式差分法求解穩定性受時間步長，測點間距大小限制的缺點，因而具有測點布置靈活的特點。
  19. A patent has been applied for based on these widely used innovations. a 3d particle velocity measurement system was built upon calibration method of multi - layer regular grid and particle space coordinates determination method of iterative approaching developed in this paper

    建立了顆粒三維運動測量系統，提出了「空間多層正交網格」的標定方法，用「多次迭代逼近法」進行顆粒空間坐標的計算。
  20. Advanced orbiting system ( aos ) is the product of the standardization of space data system and the combination of tt & c and communication. aos protocol brings the field of the space c & t tremendous changes. our aerospace projects should implement the aos protocol to join the world aerospace club

    高級在軌系統（ aos ）協議是空間數據系統標準化和測控與通信相結合的產物，該協議的出現給空間測控通信領域帶來極大變革，我國航天事業要與世界接軌必須逐步實施aos協議。
分享友人
分享到 Line

分享到臉書