穿進速率 的英文怎麼說
中文拼音 [chuānjìnsùlǜ]
穿進速率
英文
penetration rate-
Sicp / al matrix composites, with 5, 15 and 25 % volume fraction of sic particles, were prepared by vacuum hot - pressing sintering processing in this paper. based on mechanics properties, sem observation and energy dispersive x - ray analysis, the interface reaction phenomenon of sicp / al composites made by vacuum hot - pressing sintering, as well as the reinforcement and fracture mechanisms of this composite were analyzed. the dynamic responses of sipc / al composites were studied by a split hopkinson high - speed pressure bar impact system which strain rate was from quasistatic state strain rate ( 3. 3 10 - 3s - 1 ) to dynamic state strain rate ( 5. 2 103 s - 1 )
本研究以武裝直升飛機防護裝甲材料為研究對象，採用真空熱壓粉末冶金燒結工藝制備了含sic顆粒體積分數分別為5 、 15和25的sic顆粒增強鋁基復合材料，結合其力學性能、掃描電鏡和界面微區能譜分析結果，分析了sic _ p al復合材料的真空燒結過程中的界面現象，以及材料增強和斷裂機理，並利用hopkinson高速壓桿沖擊實驗系統對其從靜態到動態（應變率為3 . 3 10 ~ （ - 3 ） s ~ （ - 1 ） 5 . 2 10 ~ 3s ~ （ - 1 ） ）的壓縮破壞響應進行了研究，分析了不同體積分數sic _ p al復合材料高應變率壓縮載荷下，材料的變形和微觀損傷機理，以及利用高速沖擊空氣炮測定了改復合材料制備剃度復合板的穿透性能。In this paper, firstly the macro parameter of the series connection app was comprehensively analyzed, among which the trajectory location of the bullet emission and the terminal velocity of the bullet were mainly analyzed, and the feasibility of the series connection app to cope with explosive reactive armor was demonstrated. and then the macro design about the head of the series connection app was made, among which a particular analyse about the bullet " s launching process was made, from which we concluded the relation between the thickness of the airproof loop and the velocity of the bullet detached from the carrier and the relation between the length of the bullet and the velocity of the bullet detached from the carrier and the relation between the length of the bullet and the burning rate of the powder and the relation between the length of the bullet and the maximum pressure of the emission hole and the relation between the length of the bullet and the emitting time of the bullet, and the reasonable str ucture of the head of the carrier and bullet were designed, then the intensity of the head of the carrier was checked out using of the software of ansys
本文首先對子母式穿甲彈總體參量作了全面的計算分析，其中主要分析了子彈射出的彈道位置和必要的子彈著靶速度，論證了子母式穿甲彈對付爆炸式反應裝甲的可行性，然後對子母式穿甲彈彈頭部進行了總體設計，其中主要對子彈的發射過程進行了詳細的分析，得出了母彈彈頭部發射孔內閉鎖環厚度與子彈飛離母彈速度的關系、子彈長度與子彈飛離母彈速度的關系、子彈長度與火藥燃燒率的關系、子彈長度與母彈彈頭部發射孔內最大壓力的關系以及子彈的長度與子彈發射所需時間的關系，設計出了合理的母彈彈頭部結構和子彈的結構，並利用ansys有限元分析軟體對母彈彈頭部的強度進行了校核。Test results indicated : with the hoist of altitude, the increase of ice amount and the rise of pollutant, the average flashover voltage reduced. the character exponent generally depends on the insulator profile, ice amount, ice state and pollution severity etc. by means of a high - speed camera, a data acquisition system and high voltage test facilities, a series of the flashover processes on ice surfaces were record. the experimental results form this study and the subsequent theoretical analyses suggested : the thermal ionization of the air in front of an arc root resulted in arc movement ; the electrostatic force had an auxiliary effect of impelling arc propagation ; the electrical
通過對攝像機、數據採集系統及高壓試驗裝置記錄覆冰絕緣子表面閃絡電弧的發展過程的試驗結果進行理論分析得出：弧根周圍空氣的熱電離導致了電弧的發展，靜電場力對電弧的發展起到了加速作用，電擊穿僅發生在閃絡最終的跳躍階段；通過測量閃絡過程中的放電電壓、泄漏電流、閃絡時間、覆冰水電導率、電弧長度及電弧半徑等參數，得到了不同階段電弧（電弧起弧階段、電弧發展階段及完全閃絡）的發展速度、臨界電弧長度均隨覆冰水電導率的增加而減小。Then analytical measurements of the noise were carried out on both of the turbines by means of modern acoustic apparatus and a conclusion has been found that the noise of the concentrated wind energy turbine is lower than the one of the ordinary wind energy turbine and the root of the trouble to cause noise chiefly originates from the turbine blade. besides, the result of analytical measurement also reveals that the power output both of the wind energy turbines will increase with the increase of the wind speed and unfortunately does the noise too. in order to lower the noise, a measures of noise reduction have been advanced that an active method is to develop a wind energy turbine run at a lower rating of wind speed while the passive method is to adopt a board drilled tiny holes, having established a sound technological basis for the development of a kind of wind energy turbine of low noise and high level in the world
主要對濃縮風能型風力發電機在正常運轉時，噪聲產生的機理進行了理論分析研究，並與普通型風力發電機的噪聲進行了對比實驗分析；利用現代聲學測試手段對兩類機型進行測試與分析，得出濃縮風能型風力發電機產生噪聲低於普通型風力發電機和葉輪是風力發電機產生噪聲的主要部件的結論；通過對兩類機型的噪聲、輸出功率的測試，得出隨著風速的增加，兩類風力發電機的輸出功率在增加，產生的噪聲也在增加的結論；提出了進一步降低濃縮風能型風力發電機噪聲的措施，從主動降噪方面，研製低額定轉速的發電機；從被動降噪方面，採用微孔穿板的降噪結構；為研究開發一種國際上低噪聲、高水平的風力發電機打下了良好的技術基礎。The opening stress and the life of crack growth is calculated and compared with the test results and the experience formula. the feasibility of the newman theory of opening stress used in the high strength steel is validated. then through the slice synthesis method, the three dimension surface crack of the weld joint of cone - cylinder is decomposed into many plane through cracks
本文將基於裂紋閉合現象建立的帶狀屈服模型，用在平面貫穿裂紋中，計算此時的裂紋張開應力和疲勞裂紋擴展壽命，與試驗結果和經驗公式比較，驗證newman裂紋張開應力理論在高強鋼中的可行性；然後，用切片合成法，把潛艇結構凸錐柱結合殼焊縫處的三維表面裂紋分解成平面貫穿裂紋，用帶狀屈服模型的理論來分析平面貫穿裂紋，得到裂紋沿深度方向的擴展速率，進而得到潛艇結構的疲勞壽命。Abstract : the saturation behavior of stress current is studied. the three types of precursor sites for trap generation are also introduced by fitting method based on first order rate equation. a further investigation by statistics experiments shows that there are definite relationships among time constant of trap generation, the time - to - breakdown, and stress voltage. it also means that the time constant of trap generation can be used to predict oxide lifetime. this method is faster for tddb study compared with usual breakdown experiments
文摘:基於一階速率方程，討論了恆定電壓應力下應力電流的飽和行為.通過對應力電流的擬合，發現存在三類缺陷產生的前身.更進一步的統計實驗顯示，在缺陷產生時間常數、擊穿時間以及應力電壓之間存在著明確的關系.這意味著缺陷產生時間常數能夠被用於有效預測氧化層的壽命.與常規的氧化層擊穿實驗相比，基於缺陷產生時間常數的預測更快、更有效Packaging pills with their own bodyguards ( in this case, molecules called protease inhibitors ) could enable protein - based drugs to survive, but it would not aid them in crossing the gut lining ; they are too big to slip into the blood as easily as more typical drugs, which generally consist of small molecules
為藥物配備保鏢（上述例子的保鏢分子稱為蛋白酶抑制劑） ，雖然可以讓蛋白質藥物保存下來，但卻無法幫助藥物穿過腸壁，因為這些分子太大，無法像一般小分子藥物那般輕易進入血液，而且包覆層對藥物動力學（藥物進入血液的速率以及停留在身體組織與器官的時間）的控制能力也相當有限。分享友人